Supply Of Cane Unloader Bridge , Supply Of Cane Unloader Bridge , Design, Manufacturing And Supply Of Heavy Duty Out Door Bridge For Sugar Mill Plant Cane Unloading Conforming To Is:807-1976 & Is:3177-1977 Fabricated From M.S. Plate Section Conforming To Is:226/2062 Steel In Box Type Design With And Carriage Fitted With Wheel Of Fusion Welded Having L Type Bearing Housing For Long Travel (Lt) Wheel Assemblies Having Span-22.00 Mtrs Capacity -05Ton Swl Along With Dismantling Of Old Existing Bridge And Erection And Commissioning Of New Bridge Old Existing Cross Travel Trolley Will Be Used. Type Of Bridge-M.S. Plate Fabricated Box Type Span-22.00 Mtrs, Unloading Capacity -05 Ton Swl , Techincal Specification:-Type Of Bridge -Box Type (M.S. Plated Fabricated), Capacity-05 Ton Swl, Unloading Capacity -80 To 100 Ton Cane/Hr, Utility-Sugar Cane Handling, Height Of Top Of Top Rail From Ground-10.00 Mtrs, Height Of Lift-12.50 Mtrs, Wirerope-19Mm, 6/36 Construction Fiber Wire, Long Fral Speed -23-25 Meter/Minute, Box Side Plate Height-1250Mm, Box Side Plate Thickness-8Mm, Top & Bottom Plate Thickness-Top Plate-12Mm Thick, Bottom Plate-10Mm Thick, Top & Bottom Plate Width-500Mm, Baffle/Stiffener Plate Spacing -750Mm, Baffle/Stiffener Plate Thickness-8Mm , End Carriage:- Length-5000Mm, Height-450Mm, Centre Distance Fo End Carriage Wheel-4500Mm,Centre Distance Of Trolley Wheel -1965Mm , Long Travel Mechanism:- Size Of Rail Top At Long Travel- Width-60Mm, Height-25Mm, Size Of Rail Section At Cross Travel-Width-60Mm, Hight-25Mm , Electric Motors For Long Travel Drive 5.3Hpx960 Rpm Rating S4 Duty, Qty-02 Nos , Gear Box For Long Travel:- Type Helical ,Model-Hb-350, Ratio-40:1, Service Factor-Greater Than 2 On Installed Power, Qty-02 No , Coupling For Long Travel Drive:- Type Geared Type Half Gear Model-103 , Breaks:- Thruster-Electro Hydraulic Thruster 18 Kg/Cm² , Dia-6, Qty_ 02 No., Floating Shaft Dia/Length-70Mm/800Mm-1000Mm , Wheel:- Dia Meter-420Mm, Bearing-22218 Skf/Fag Make, Housing -L Type, Qty-04 Nos , Note:- (I)Fabrication Will Be Done Using Prime Plates And Sections And Using Mig, Welding Process. (Ii)Only Tack Welding Will Be Done By Electrode Using Arc Welding(Iii) Parallality Of The Cross Travel Rails/Square Bar, Diagonals, Deflection Of The Bridge & Trolley Will Be Accurate And Confirming To Standard And Best Engineering Practices. (Iv) Bridge Must Be Two Coated By Red Oxide Metal Primer And Two Coats Of Golden Yellow Colour.
