Tender For Providing Lighting Arrangement Sport Complex Of Village Yakubpur In Sector-86, Noida, 1 Supply & fixing of 6 mtr GI Octagonal Pole of approved make (top dia 70mm, Bottom dia 130mm and base plate 12mm thik) having 3mm thikness with Single arm bracket 1 Mtr length in 1:2:4 RCC foundation bolt including the cost of foundation, excavation & back filling and Required T&P completee in all respect. PS No, 647 2 Supply & fixing of LED Street light Fitting having die cast aluminium body and diffuser with driver set suitable for 75 to 90 Watt. Confirming to IP 66 and above Protection complete in all respect.CAT- AAA PS No 1423 3 Supply & fixing of 30 mtr High mast shaft of approvedmake with rising system hot dip glavanized inside & out side dip,heaving pole sheet thickness 4 mm. Top dia minium 150 mm, Bottom dia 500 mm base plate 32 mm thick suitable for wind velocity as per IS 875 part 3 & having no circumferential weld, with accessories for high mast such as head frame suitable for 8 to 12luminaries & its control gear boxes 1.5 HP power toolmoter, 3 point suspension system with steel wire rope 8mm dia, double drum winch, including making suitablefoundation as per manufature drawing/ site reuiment`long with foundation bolts nuts, washers, anchor plates etc completee in all respect.PS No. 655 4 Supply and fixing of LED Street light Fitting having die cast aluminium body and diffuser with driver set suitable for 175 to 200 Watt. Confirming to IP 66 Protection complete in all respects PS 1425 (A) CAT.AAA 5 Supply and laying of aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. PS No. 501 6 a) 16 sqmm x 4 core 7 b) 25 sqmm x 2 core (AOR) 8 c) 35 sqmm x 3.5 core 9 d) 50 sqmm x 3.5 core 10 Supply and fixing of plain or pin type copper tin plated cable socket ( lug ) to the cable leads, insulating with tape and makingonnection etc. complete in all respect as perdirection of the Engineer-Incharge. PS No. 504a) 16 sqmm 11 a) 16 sqmm 12 b) 25 sqmm 13 c) 35 sqmm 14 d) 50 sqmm 15 Supply and burring of Safe Earthing Electrode T-19, (Hot Dip Galvanized), Length up to 3000mm, outer Dia 50 mm inner Dia 25 mm, terminal Dia 12mm, outer GI pipe of 16 swg and inner GI pipe of 12 swg with Hot Dip Galvanization up to 100 micron filled with crystalline conductive mixture (CCM) having anti corrosive & conductive property with 50 kgs activated soil (BFC) capable of reducing the soil resistivity with good mixture of retaining capacity and one earthing lead of 25mm x 3mm G.I. strip, upto switch board (from apron to switch board, the cost of G.I. strip will be extra) along with 30 cm square C.I. frame with hinged cover & masonry housing. Make: As approved in U.P. P.W.D., & C.P.R.I. Certified. PS 725 (B) 16 Supplying and fixing of 32 mm dia X 2.00 metres long G.I. pipe (medium class) bracket for mounting of fluorescent / HPMV /HPSV street light fitting on pole including bending the pipe to therequired shape, 2 nos 40 mm X 3 mm flat iron clamps with nuts,bolts and washer, painting the flat iron with primer and finish paint etc. as required DSR-12.34 17 Supply & erection of D clamps of 50 mm x 6mm flatiron on steel tubular poles / steel rail poles with bolts, nuts etc. complete in all respects including painting with aluminium paint UPPWD-623 18 Cement Concrete with 2 cm gauge stone grit, coarse sand & cement in proportion of 4:2:1 including supply of all material, Labour , tools & plants etc. Required for proper completion of work. SOR No. 279(a) 19 Cutting road and making good the same including supply of extra quantities of materials i.e. aggregate, moorumm screening, red bajri and labour required (AOR) 20 Numbering of poles & post with combination of yellow and black colour paint etc. complete in all respects as per direction of E/I. (AOR) 21 Excavation of the cable trenches in hard rock not exceeding 1.5 metres in width, and lift upto 1.5 metres, including getting out the excavated soil and disposal of excavated soil as directed within a lead of 50 metres.DSR-2018 Item No.14.6 22 S/Laying of90 mm dia (OD 90 mm & ID 76 mm nominal) size of (DWC) HDPE Pipes ISI marked along wigh all accessories like socket, bend, couplers etc. conforming to IS 14930, Part-II complete with filling and cutting, jointing etc. direct in ground ( 75 cm below ground level) including excavation and refilling the trench pat excluding sand cushioning and protective covering etc. Complete in all respects. Rex/Duraline/Time/CPE make. as per DSR 2018 item no. 14.16.2 page no. 52 23 MS Strip (50x6mm) Fencing (6 Feet height including civil work) UPERC Page-53 24 Frp Fencing (6 feet height including civil work) UPERC Page-53 25 Demolishing R.C.C. Work mannually by mechnical means including stacking of steel bars and disposal of unservicable material within 50 mtr. Lead as per direction of E/I. (AOR) 26 Laying old cement concrete interlocking paver blocks of any design/shape laid in required line, level curvature, colour and pattern over and including 50.00mm thick compacted bed of coarse sand, filling the joints with fine sand etc. complete in all respect as per direction of E/I. (AOR) 27 Taking out existing CC Interlocking from footpath/central verge, including removal of rubbish etc. disposal of unservicable material to the dumping ground, for which payment shall be made separately and stacking of servicable material within 50 Mtr. Lead as per direction of E/I. (AOR) 28 Supply and fixing of 15 Amp TPNcapacity of automatic street light cubical control panel painted with anti corrosive alkali and acid proof paint crossing of time switch TSO 100 series with contractors, HRC fuse, isolating swtich metering instrument & instrument box with CTs etc. in case of TPN, Complete in all respects. as per PS No. 807D 29 Supply & erection of overhead line with G.I. wire no. 8 to 4 SWG on poles/serivce bracket including binding etc. complete in all respect... PS 628 30 Supply and laying of 25mm x 3mm G.I. strip from earth electrode directly in the ground as required complete in all respect... PS 716
