Tender For Repair/ Replacement Of Angle Iron, Chain Link Fencing, Concentina Coil, Drain, Cover Slab And Hard Standing In Tech Area At Afs Yelahanka
Tender Value
32 Lakhs
Estimated cost
Bid Submission
13 Apr 2024
0 days left
EMD
64000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
yelahanka → Karnataka
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender For Repair/ Replacement Of Angle Iron, Chain Link Fencing, Concentina Coil, Drain, Cover Slab And Hard standing In Tech Area At Afs Yelahanka
BOQ
| Sl. No. | Item Description |
| 1 | Dismantling of galvanized mild steel two strand barbed wire from all existing mild steel, RCC fencingpost etc. complete all as directed. |
| 2 | Dismantling of fencing, wire mesh of any type and in any position by unscrewingnuts fillets, clamps complete all as directed. |
| 3 | Dismantling posts or strut(steel or RCC fencing posts) any sectionand taking out embedded portion (post embedded in natural ground) including making good to disturbed ground surfaces complete all as directed. |
| 4 | All as per serial item No 3here-in-before but post embedded in concrete all as specified and directed. |
| 5 | Demolition of cement concrete in ground floors and paving not exceeding 15 cm thickness (below or above ground level) and disposing the rubbish to a distance exceeding 50 Mtr but not exceeding 100 Mtr away to low lying areas complete all as specified and directed. |
| 6 | Demolition of brick work or stone/ boulder masonry built in cement mortar including all quins, arches, pillars etc. but excluding ashlar facings, dressed stone work and precast concrete articles complete all as directed. |
| 7 | Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as directed. |
| 8 | Taking down cement plaster of any description on brick walls, etc including raking out joints, hacking for key scrubbing down with water etc all as specified and directed. |
| 9 | Excavating in post holes (or similar holes) in soft/loose soileach n. exc 0.5 cum, getting out, returning, filling in and ramming earth orbroken rubble mixed with earth around, in layers n. exc 25cm, watering, and removing surplus soil to a distance n. exc 50m and making good surface all as specified and directed. |
| 10 | M & L for 25 mm thick sand filling in bedding layer for laying floor finished completeall as specified and directed. |
| 11 | Removing excavated materials not exc 50 mand depositing where directed at a level not exc. 1.50 m above the starting point complete all as specified and directed. |
| 12 | M&L for plain cement concrete (PCC) 1: 4 :8, type D-2 (using 40mm graded stone aggregate) as in foundation, filling and mass concrete complete all as specified and directed. |
| 13 | M&L for plain cement concrete (1:2:4) type B-1 (using 20 mm graded stone aggregate) forin walls or retaining walls, any thickness, size or shape including pilasters, buttresses columns, pillars, boundary pillars and posts (including caps and bases) complete all as specified and as directed. |
| 14 | M&L for plain cement concrete (PCC) 1:2:4, type B1(using 20 mm graded stone aggregates) as in coping/band and bed block etc incl necessary formwork, weathering, slightly rounded or chamfered angles and throating complete all as specified and directed. |
| 15 | M&Lfor pre-cast cement concrete block masonry 1:3:6, type C1(using 20 mm graded stone aggregate) with solid blocks, exceeding 10 cm in width and setting in mortar, 1:6complete all as specified. |
| 16 | M&L for pre cast cement concrete 1:2:4, type B1(using 20mm graded stone aggregate) in cover slabs for manhole,drain and Connected Works set in CM 1:4 including necessary form work and demolition of old slab complete all as specified and directed. |
| 17 | Extra for forming fair finished drain or channel 45cm inner girth in cement concrete using extra cement including forms, moulds, mitred/ stopped ends etc complete all as specified and directed |
| 18 | S&F mild steel posts and struts in fencing including cutting tops to shapes as directed, drilling holes notching for wire etc flat iron fillets (for securing wire mesh etc including all necessary drilling, bolting or rivetting etc and similar work confirming to Fe-290 Gde E-165) all as specified and directed. |
| 19 | S&F mild steel framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165 for portions framed and hung as gates, including pintle hinges, stops, hand-made sliding bolts, etc complete all as specified and as directed. |
| 20 | Supply and fix mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screw end to be fitted with washers and one hexagonal or square nut, diameter of bolts 12 mm, length of bolt exc. 5cm not exc. 7.50 cm long, complete all as specified and as directed. |
| 21 | Fixing only chain link fencing including line wires, any mesh , size and type to any type of standards , rails , straining bolts, etc. including provision of binding wire, all as specified and directed. |
| 22 | S&F galvanized 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossings with and provision of galvanized mild steel wire, staples or steel pin etc. as directed (each line wire to be measured) complete all as specified and as directed. |
| 23 | All as per Ser item no 22 but except barbed wire inclRestraininig & resecuring of existing barbed wire including making good staples etc all as specified and directed. |
| 24 | S&F in reapir for galvanised mild steel concertina coil fencing of 600mm dia, centre to centre barbs distance 48mm, Thickness of strip 0.50mm, length of barb 10.50mm, Dia of Spring wire 2.50mm, No of spiral (No of Turn ) 50/51 per coil Clips per spiral 5 Nos, Approximate weight 8.00 to 8.50 KG/ per coil ( Recommended coil stretch lenght 6 mtr ) and confirming to IS and asManufacturers instuction and laying and secured with barbad wire/ Iron angle by usingneccesary securing clipsall a specified and directed by Engr-in Charge. |
| 25 | Supply and fix mild steel TMT bars 10 mm dia and over cut to length, bent to shape reqd incl cranking , bending spherically for hooping for columns , hooking ends & binding steel wires not less than 0.9mm dia with clips complete all asspecified and directed. |
| 26 | Supply only mild steel round bars 10 mm dia, Fe 290, Grade E-165, cut to length, bend to shape required and hooking ends for fixing to chain link fencing complete all as specified. |
| 27 | M & L for rolled mild steel framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails anduides) and hanging; also fastening and fixing conforming to Fe 410 -W (Gde- E- 250) quality-A complete all as specified and directed. |
| 28 | Supply only Chain Link MS galvanised fencing , any size or type, all as specified and directed. |
| 29 | Material and labour for 100 mm thick,plain cement concrete1:2:4, type B-2 (using 40mm graded stone aggregate) as in footpath and finishing surfaces of concrete even and smooth without using extra cement complete all as specified and directed. |
| 30 | M&L for 75mm thick plain cement conctere (PCC) 1:3:6, type C-2 (using 40mm graded stone aggregate) as in sub base complete all as specified and directed. |
| 31 | M & L for Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 grade jointed with grey cement and pigments completeall as specified and directed. |
| 32 | M&L for rendering 15 mm thick on fair faces of brick work or concrete surfaces on walls in CM 1:4. finishing even and smooth without using extracement complete all as specified and directed |
| 33 | M&L for preparation of the old surfaces unplastered of wall and applying one coat of cement base paint ,complete all as specified and as directed. |
| 34 | M&L Preparing old painted steel surface and applying one coat of Synthetic enamel all as specified and directed. |
| 35 | M&L for preparation of new steel surfaces of any description, over 10 cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide, zinc chrome primer complete all as specified and as directed. |
| 36 | M&L for preparation of steel or iron surfaces not exceeding 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed. |
| 37 | M&L for50 mm thick plain cement concrete 1:3:6, type C2 (using 40 mm graded stone aggregate) as in plinth protection and paving finishing surface even and smooth without using extra cement including necessary formwork to divide area in panels complete all as specified and directed. |
| 38 | M&L for chequeredtiles of size 200x200x 25 mm thick, set and jointed in neat cement slurry in floors and pointed in white or coloured cement to match over and including 15 mm thick screed bed in CM 1:6all as specified and directed. |
| 39 | M & L for Preparation of newly plastered surfaces and applying two coats of cement base paint on walls incl priming surfaces with alkali resistant priming paintetc complete all as specified and directed. |
AI Tender Summary
Tender Timeline
Mar 23, 2024
11:30 IST
Tender Published
Tender notice published.
CompletedApr 13, 2024
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedApr 15, 2024
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender