Vehicle Factory has published Tender For Construction Of Footpath Of Road Side With Fixing Of Paver Block In Estate Area At Vfj.. Submission Date for this Tender is 29-03-2024. Footpath Work Tenders in jabalpur Madhya Pradesh. Bidders can get complete Tender details and download the document.
| Sl. No. | Item Description |
| 1 | M & L for Excavating in trenches hard/dense soil, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out. |
| 2 | M & L for Cement concrete in foundations, filling and mass concreteType C1 M-10 1:3:6. (20 mm graded aggregate). |
| 3 | M & L for Cement concrete in surface channels and drainsType B1 M-15 1:2:4. (20 mm graded aggregate). |
| 4 | M & L for Rendering Cement Plaster 15mm thickin CM 1:6 on fair faces of brick work or concrete surfaces. |
| 5 | M & L for Neeru finish to plastering as specified. |
| 6 | M & L for Reinforced cement concrete (nominal mix) type A1 M20 1:1.5:3 (20 mm graded aggregate),Walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilaster and buttresses. |
| 7 | M & L for Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips. |
| 8 | M & L for Mild steel TMT bars 6mm to 8mm dia, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips. |
| 9 | M & L for Formwork to faces offlat rough finish surface of concrete walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter. |
| 10 | M & L for Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete. |
| 11 | M & L for Hardcore (Broken stone or boulders) of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface. |
| 12 | M & L for Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade withapproved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. |
| 13 | S & F PVC (SWR) pipes single socketed, in any length with rubber ring joints, laid in trenches or in floors (Bore in 110 mm). |
| 14 | M & L for Preparation of new or previously untreated plaster and concrete surfaces of any description over 10cm girth or width, not otherwise described and apply two coat of synthetic enamel paint, colour and quality as directed by EIC. (Make - Asian, Berger, Dulux, Nerolac, Shalimar, Indigo |
Copyright © 2024 · All Rights Reserved. Terms of Usage | Privacy Policy
For Tender Information Services Visit : TenderDetail
