Construction Of Road From Radhashree Bastralaya To Dilip Shop At Dakshin Barasat Under Jaynagar-I Ps
Tender Value
19.80 Lakhs
Estimated cost
Bid Submission
23 Feb 2024
0 days left
EMD
39608
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
jaynagar → West Bengal
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Construction Of Road From Radhashree Bastralaya To Dilip Shop At Dakshin Barasat Under Jaynagar-I Ps
BOQ
| Sl. No. | Item Description |
| 1 | Construction of Road |
| 2 | Close Bamboo Walling made of 65mm to 75mm dia. bamboos (in single line) driven about half-length into the ground side by side, with stout stays at an interval of 1m, 3nos. of half split bamboo runner of same dia fitted and fixed with nails etc. complete as per direction. (Measurement to be taken along the length of piling after finishing the works).(iii) With bamboos of length above 2.50m and upto 3.00m |
| 3 | Eucalyptus bullah Walling made of 100 mm dia.eucalyptus bullah (in single line) 5m lenth driven about 3.33 m intothe ground side by side @ 350 c.c, with 100mm eucalyptus bullah ties 2.50m length at an intervalof 2.25m c.c and 100mm eucalyptus tie post 2.50m length driven 2.35m into the ground, 3nos. ofeucalyptus bullah runner of 100mm diafitted and fixed with nails etc. complete as perdirection. (Measurement to be taken along thelength of piling after finishing the works). |
| 4 | Construction of Embankment with Material Obtained from Borrow Pits Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Technical Specification Clause 301.5 for Rural Roads of MORD. (Mode of measurement: pre works and post works)(a) Carriage up to total lead of 1.0 km. |
| 5 | Earth work in excavation of foundation of structures as per drawing and technical specification,including setting out, removing, spreading or stacking of spoils within a lead of 150 m. as directed and including trimming the sides of the trenches,leveling, dressing and ramming the bottom, and backfilling with approved material complete as per direction of the Engineer-in-Charge(iv) Without pumping out water and shoring |
| 6 | Box cutting or filling in Road embankment in all sorts ofsoil including spreading the spoils properly over the flank as necessary or on berm to approximate grade & camber and rolling the sub-grade with power roller to proper camber and grade as per direction and satisfaction of Engineer-in-charge including uprooting and removing plants and jungles when and where necessary.(a) Depth up to 150 mm. |
| 7 | Construction of Sub Base using Local Materials,spreading in uniform layers with Motor grader onprepared surface, including screening the metal asnecessary, mixing by mix in place method withRotavator at OMC, and compacting with vibratoryroller to achieve the desired density, lighting,guarding and barricading including cost andcarriage of all materials and making necessaryearthen bundh of one metre wide on each side toprotect the edges complete as per Clause 401 ofSpecifications for Road & Bridge Works of MoRT&H(5th Revision).(i) For Construction of Sub Base by compacting 1stclass brick aggregates (40 mm down) andsand (in proportion of 60:40). |
| 8 | (A) Filling in foundation or plinth by silver sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. |
| 9 | Single Brick Flat Soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints withlocal sand. |
| 10 | Hire and labour charges for Shuttering with or without staging upto 4.0 m height using approved stout props with wooden planks/ply wood/steel sheet plate with required bracing for any kind of plain or reinforced concrete works in all sorts of minor structure including culvert, box culvert, crossdrain etc. The rate is inclusive of fitting, fixing and striking out after completion of work as per specification and direction.(b) Where staging is not required. |
| 11 | Providing and laying Design Mix concrete for plain / reinforced concrete work in any part of bridge (excluding bottom plugging) with coarse aggregates of appropriate nominal size and grading, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, including labour, cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in-Charge and cost for quality control, sampling, testing etc. all complete but excluding cost of labour and materials for formwork & reinforcement works. (a) M-15 Grade,Using concrete mixer |
| 12 | First class Brick work in cement sand mortar in steining of well, pier, abutment, wing wall, parapets cross drain. H.P. culverts, guard wall etc. including curing, scaffolding, raking out joints etc. complete including cost and carriage of all materials. (b) In 1:6 proportion |
| 13 | Supplying, fitting and placing HYSD bar reinforcement in super-structure including initial straightening, straightening of coils bars, removal of loose rust (if any), cutting to requisite length bending, binding with annealed wire not less than 1 mm in size and conforming to IS 280 at every intersection hooked and bent to correct shape and placed on forms etc. including cost of black annealed wire and cost of loading, unloading, carriage of all steel materials complete as per drawing and technical specifications and direction of Engineer-in-chargeI. For SAIL/TATA/RINL |
| 14 | Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. i) Pakur Variety |
| 15 | Add 18% GST |
| 16 | Add 1% L&W cess |
AI Tender Summary
Tender Timeline
Feb 08, 2024
11:30 IST
Tender Published
Tender notice published.
CompletedFeb 23, 2024
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedFeb 28, 2024
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender