Tender For Procurement Of Equipments For Cord Blood Bank, Kolkata-West Bengal

Procurement Of Equipments For Cord Blood Bank Procurement Of Equipments For Cord Blood Bank Nitrogen Storage Tank Nitrogen Supply Tank Minus 80 Degree Deep Freezer , Specification Of Minus 80°C Deep Freezer, Vertical: 1. Temperature Range:Minus 80°C To Minus 85°C ± 1°C 2. Net Volume ( Usable Volume ) : 600-700 Litre 3. Inner Door Should Be 2-4 In Number. 4. No. Of Shelves: 3-4 5. Inner Chamber & Shelf Should Be Made Of Stainless Steel. 6. Fully Programmable Microprocessor Based Temperature Controller With Control Panel. 7. Touch Screen Display With Clearly Discernible Digits And Alphabets. 8. Audio Visual Alarm Should Be Available For-Power Failure, Sensor Failure, Low Battery, High / Low Temperature, Door Open, High Condenser Temperature. 9. Freezer Must Have Inbuilt Battery Backup For Display. 10. Provision For Local Distant Alarm And Remote Temperature Monitoring And Compatible With External Lab Monitoring And Reporting System Should Be Available. Provision Of Additional One Port For Independent Temperature Sensor Monitoring Should Be Provided. 11. Servo Controlled Voltage Stabiliser Should Be Provided So That The Compressor Should Be Capable To Run Any Voltage Between 190-270V And During Initial Startup. The Voltage Stabilizer Should Be Isi Marked. 12. Power Supply: 220-240 Volts, 50Hz, Single Phase. 13. Must Be Provided With Iq, Oq, Pq Documentation. 14. Efficient Cfc Free, Hcfc Free Refrigerant ( Green Gas Type ) , Environment Friendly. Cfc Free Certificate To Be Provided. 15. Weight Carrying Capacity Per Shelf: 30 Kg Or Above. 16. Vacuum Release Valve For Easy Door Opening. 17. Settable Points For High / Low Temperature And High / Low Temperature Alarm. 18. Temperature Display Resolution Of Minimum 0.5°C 19. Height Of 190-200 Cm And Width And Depth Of Appropriate Dimension. 20. Provision For Frost Free Door Handle. 21.Good Quality Rubber Gasket Preferably Double Seal Silicon Made For Better Insulation. 22. Puf Or Equivalent Insulation In The Door, Certification Required. 23. Temperature Log Which Should Be Transferrable In Pen Drive Or Equivalent Device And Printable. 24. Safety & Standard Certificate: Us Fda / European Ce ( 4 Digit Notified Body ) / Bis. 25. Electrical Safety Certificate As Per National Or International Norm. Iec 60601-1 Certification Required. 26. Minimum 2 Years Warranty Including All Spares Required And 5 Years Compressor Warranty. 27. Post Sale Service Support Should Be Available For A Minimum Of 8 Years. 28. Holdover Time: Full Load Of Plasma Bags At -76 Deg C Should Take At Least 1 Hrs To Rise Above -60 Deg C If Power Off And It Should Be Supported By Providing Performance Curves. 29. Temperature Attainment Time Should Be Within 6-8 Hours In Empty State. Cooling Down Time: A Full Load Of Plasma Bags At 25 Deg C Should Not Take More Than 5 Hrs For All The Bags To Reach Below - 70Deg C And It Should Be Supported By Providing Performance Curves.

Refer document

INR 150000.0 /-

Refer document