Installation Of Solar Led Street Light With Pole (Pole- 6Mtr, 18Watt, Battery- 12.8V, 24-30Ah Lithium Ferro Battery, Module-75Wp Solar Panel) At Following Places:I) At Vill- Jhatiboni, Gp-Jagdalla-Ii Under Block Bankura-I (5 Pcs), (Ii) At Vill- Helnasusun
Tender Value
7.02 Lakhs
Estimated cost
Bid Submission
08 Jan 2024
0 days left
EMD
14050
Bank guarantee accepted
Document Fee
1180
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
bankura → West Bengal
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Installation Of Solar Led Street Light With Pole ( Pole- 6Mtr, 18Watt, Battery- 12.8V, 24-30Ah Lithium Ferro Battery, Module-75Wp Solar Panel ) At Following Places:I ) At Vill- Jhatiboni, Gp-Jagdalla-Ii Under Block Bankura-I ( 5 Pcs ) , ( Ii ) At Vill- Helnasusunia, Gp- Jagadalla-Ii Under Block Bankura-I ( 5 Pcs ) , ( Iii ) At Vill- Uporsole, Gp- Jagadalla-Ii Under Block Bankura-I ( 4 Pcs ) , ( Iv ) At Vill- Kargahir ( Natunbasti ) & Samsan, Gp- Anchuri Under Block Bankura-I ( 5 Pcs ) Of Bankura District.
BOQ
| Sl. No. | Item Description |
| 1 | Supply & Delivery Of Module 75-100 Wp Solar panel (ERTL & Flash tested), the module shall contain poly crystalline silicon solar cell and must have a testing confirming to IEC 61215 edition II certified, with building Blocking Diode with 10 years warranty , shall have device life more than 25 years limited power less not more than 10% of nominal output at the end of 10 years and not more than 20% at the end of 25years.The solar module shall be able to withstand the temp extremes ranging from -10*C to + 85*C and the wind load of wind speed @120km/hr. Maximum mean hour rain fall of 40mm, humidity level up to 90% MNRE approved grade solar panel. Cell material - Poly crystal silicon solar cell. Capacity - The power output of the module (s) should not less than 60 Watt peak. the operating voltage corresponding to the power output mention above should be 16.5v .The pcb of the PV module under STC should be at least 21v.calculation under average daily isolation of 5.5KWhr/sq.mt, on a horizontal surface. (MAKE LIST ANNEXED) |
| 2 | Supply & delivery of Battery 12.8V , 24-30 AH Lithium Ferro battery ,with in-built BMS Control technology ,BMS should be >10Amp, DOD>80% warranty 5 years. The battery should be of >1600cycle life (Make list annexed) |
| 3 | Supply & Delivery of 18Watt 1650 lumens ,(Color temp 5500K-6500K), Lumen efficiency 110 Lumen/Watt, DC LED light luminary with high lumens@60%, < 80degree optical lens control automatic Dusk to Dawn sensor with intelligent dimming programmed base control . IP 65 protection, having die cast aluminum body rust proof with all fixing accessories , LED light 4 hrs @ 100% , next 1 hour @50% and rest of night 30% with in- built PWM charge controller with DDP , OCP, RPP protection. The system should be design to automatically switch on at dusk, operate through out the night and automatically switch off at sun rise.(Make list annexed) |
| 4 | Supply & Delivery of Pole 6mtr,Suitable for wind speed 120km /Hr mast be hot deep galvanized dia 76mm ,of 2mm thick luminaries carriers suitable to install 2 no luminaries along with module mounting structural fixtures & all fittings complete (Make List ANNEXED) |
| 5 | The pole foundation & erection (Civil work) Erection single GI Modular pole of length as given below with /without sole place & cap etc in ordinary cement concrete (mix 1:2:4) with graded stone chips (20 mm) foundation of size 0.5m x 0.5m maximum round base block below sole plate /pole jhama metal incl. cc (1:3:6) upto 1 meter. |
| 6 | Supply & Delivery Cables as per requirement (Havels/Polycab/Finolex) andAccessories as required. The electric cable used shall be 2 core PVC insulated copper cable of size 1.5sqmm . The size of wire between solar module and battery .The all wire cover by insulating PVC pipe . the battery lead should be provided with the suitable battery clip. |
| 7 | Supply & Delivery of Charge controller : A new generation programmable charge controller to charge the system with maximum operation ability and with facilities like battery over charge cut off system and battery reverse polarity in built system etc. (Make list annexed) |
| 8 | Installation ,Testing & Commissioning of System |
| 9 | Supply & Erection of Informatory Board of Marble Plaque of small sizes: 4 nos at 4 above said locations As approved by EIC |
| 10 | Sub Total |
| 11 | GST 18% |
| 12 | CESS 1% |
AI Tender Summary
Tender Timeline
Dec 20, 2023
11:30 IST
Tender Published
Tender notice published.
CompletedJan 08, 2024
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedJan 11, 2024
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender