Urban Development Department-UDD has published Tender For To Select An Agency For Establishment And Commissioning Of Material Recovery Facility ( Mrf ) And Waste To Compost Plant At Palashbari, Assam. Submission Date for this Tender is 10-11-2023. Waste recycling service Tenders in guwahati Assam. Bidders can get complete Tender details and download the document.
| Sl. No. | Item Description |
| 1 | Setting up of Waste to Compost facility |
| 2 | Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width aswell as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m |
| 3 | Providing and laying in position cement concrete of specified grade excluding the cost of cantering and shuttering - All work up to plinth level |
| 4 | Brick work with common burnt clay modular bricks of class designation 7.5 in foundation and plinth |
| 5 | Brick work with common burnt clay F.P.S. (non-modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes |
| 6 | Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level |
| 7 | Soling (or subbase) of well burnt soling bricks including filling of interstices and rolling.(Old size bricks, one layer laid on flat.) |
| 8 | 15 mm cement plaster on the rough side of single or half brick wall of mix |
| 9 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. |
| 10 | Providing & fixing UV stabilised fiberglass reinforced plastic sheet roofing up to any pitch, including fixing with polymer coated "J" or "L" hooks, bolts & nuts 8mm dia. G.I. plain/bitumen washers complete but excluding the cost of purlins, rafters, trusses etc. The sheets shall be manufactured out of 2400 TEX panel roving’s incorporating minimum 0.3% ultra-violet stabiliser in resin system under approximately 2400 psi and hot cured. They shall be of uniform pigmentation and thickness without air pockets and shall conform to IS 10192 and IS 12866.The sheets shall be opaque or translucent, clear or pigmented, textured or smooth as specified. |
| 11 | Providing and fixing bolts including nuts and washers complete |
| 12 | White washing with lime to give an even shade |
| 13 | With ready mixed red oxide zinc chromate primer of approved brand and manufacture on steel galvanised iron/ steel works |
| 14 | Setting up of Waste to Material Recovery Facility. |
| 15 | All kind of soil |
| 16 | Sand filling under floors or in foundations including watering and consolidation |
| 17 | Soling (or subbase) of well burnt soling bricks including filling of interstices and rolling. (Old size brick , one layer laid flat.) |
| 18 | 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) |
| 19 | Supply and installation of Balling machine of required capacity including all accessories complete as per direction of Engineer-in-Charge |
| 20 | Supply and installation of Conveyor Belt of required capacity including all accessories complete as per direction of Engineer-in-Charge |
| 21 | Internal electrification |
| 22 | PVCsinglecoresheathedcableWiring withcopperconductorcablesinstove enamelledStee l Conduit .One light point or one fan point controlled by one switch with cables 1.5 sq. mm size |
| 23 | Wiring for light point with 1.5 Sq.mm FR PVC insulated copper conductor single core cable in surface/ recessed PVC conduit along with 2 No 2.5 sq. mm FR PVC insulated copper conductor single core cable for loop earthing as required. |
| 24 | Wiring for light/ power plug with 4 X 4 sq. mm FR PVC insulated copper conductor single core cable in surface/ recessed PVC conduit along with 2 No 4 sq. mm FR PVC insulated copper conductor single core cable for loop earthing as required. |
| 25 | Supplying and fixing of following sizes of PVC conduit along with accessories in surface/recess including cutting the wall and making good the same in case of recessed conduit as required. 25 mm |
| 26 | Supplying and fixing metal box of following sizes (nominal size) on surface or in recess with suitable size of phenolic laminated sheet cover in front including painting etc as required. |
| 27 | supply and fixing following modular base & cover plate on existing modular metal boxes etc as required. 4/5 module Supply and fixing following modular switch andsocket on the existing modular plate & switchbox including connections but excludingmodular plate etc as required |
| 28 | Supplying and fixing suitable size GI box with modular plate and cover in front on surface or in recess, including providing and fixing 3 pin 5/6 amps modular socket outlet and 5/6 amps modular switch, connection, painting etc as required |
| 29 | Supplying and fixing suitable size GI box with modular plate and cover in front on surface or in recess, including providing and fixing 6 pin 15/16 amps modular socket outlet and 15/16 amps modular switch, connection, painting etc as required |
| 30 | supply and fixing stepped type electronic fan regulator on the existing modular plate switch box including connections but excluding modular plate etc as required |
| 31 | Supply and fixing call bell/ buzzer suitable for D.C/ A.C single phase 230 volts complete as required. |
| 32 | Supply and fixing 3 pin, 5 amp. Ceiling rose on the existing junction box/ wooden block including connection etc as required. |
| 33 | Supply and fixing brass batten/ angle holder including connection etc as required |
| 34 | Installation, testing and commissioning of ceiling fan, including wiring the down rods of standard length(up to 30 cm) with 1.5sq mm FR PVC insulated, copper conductor single core cable, including providing and fixing phenolic laminated sheet cover on fan box etc as required |
| 35 | Installation , testing and commissioning of prewired, fluorescent fitting/compact fluorescent fitting of all types, complete with all accessories and tube etc directly on ceiling/wall, including connection with 1.5 sq. mm FR PVC insulated, copper conductor, single core cable and earthing etc as required. |
| 36 | Installation , testing and commissioning of prewired, fluorescent fitting/compact fluorescent fitting of all types, complete with all accessories and tube etc. including supplying and fixing ball and socket arrangement 2no down rods of 20mm dia X 1.6mm thick steel conduit upto 30cm length painting and wiring the down rods and connection with 1.5 sq mm FR PVC insulated, copper conductor, single core cable and earthing etc as required. |
| 37 | Installation of exhaust fan up to 510 mm sweep in the existing opening including making the hole to suit the size of the above fan making good the damage connection testing commissioning etc as required. |
| 38 | Extra for cutting and threading of G.I pipe heavy gauge down rod for ceiling fan etc. as required |
| 39 | Supply and fixing following way, single pole and neutral, sheet steel, MCB distribution board, 240 volts, on surface/ recess, complete with tinned copper busbar, neutral busbar, earth bar, din bar, detachable gland plate, interconnections, phosphatized and powder painted including earthing etc as required. 2-way single door |
| 40 | Supply and fixing 6 amps to 32 amps rating 240 volts "B" series miniature circuit breaker suitable for lighting and other loads of following poles in the existing MCB DB complete with connection testing and commissioning etc. as required 6/32 amps, single pole B series |
| 41 | Providing and fixing 4 mm dia copper wire on surface or in recess for loop earthing as required |
| 42 | External Electrification |
| 43 | Material & Labour Steel tubular swaged poles complete with cast iron base plate, finial taper plug, bolts, nuts & screws as specified type 410 SP-22 (8.5 metres long) |
| 44 | exc 60 cm girth including holderbats, distance pieces, etc. (length measured over bends, branches etc.) Aluminium paint (each coat) |
| 45 | Fixing only street light fitting, for 70/80 watt vapour or sodium vapour lamp, complete with ballast and capacitor comprising of cast aluminium housing, a pair of aluminium reflectors, a highly transparent clear acrylic cover hinged to the canopy at one end and fixed by means of single spring action at the other, suitable for mounting on 40mm or 50mm dia. G.I. mast or bracket arms with pole fixing attachments and fixing of lamp |
| 46 | Supply and fixing of junction box of size280 X 170 X 130 mm with hinges and locking arrangement & MS clamp made of 50 X 6 mm flat complete in all respect. |
| 47 | Supply and laying of following sizes Al. conductor PVC insulated armoured seathed cable of 1100 V grade at a depth of 750 mm B. G. L |
| 48 | supply and fixing of G.I. pipe of 80 mm dia along the pole for protection of underground cable as required |
| 49 | Ditto, but using galvanised iron strip 25×4mm as earthing lead. |
| 50 | Supply and fixing of feeder pillar of M.S cubicle box of size 100 x 75 x 40 cm made from 2 mm M.S sheet using angle of size 40 x 40 x 6 mm duly hinged and locking arrangement, painting two coats of enamelled paint over red oxide primer providing aluminium Bus-bar or suitable size with 100 A/415 V TPN rewirable type main switch with cement concrete foundation providing 1 Mtr GI pipe on 100 mm dia complete in all respects as per direction of E/I. |
| 51 | Supply and making of earth main hole of size 1" x 1" and 2" deep with 1" x 1" CI chamber brick work etc |
| 52 | LT panel / Feeder Pillar having one no incoming panel, 5 nos, outgoing panel and one number change over switch for DG set. |
| 53 | ELECTRONICS EQUIPMENTS REQUIRED ATSITE |
| 54 | Supply and installation of 1000kg and 100g Accuracy Heavy Duty Steel Platform Digital Weighing Scaleincluding all equipment , materials , complete with all taxes. |
| 55 | The equipment / facilities to be provided at each Customer Handling Cell are proposed Computer with in-built modem & fax software |
| 56 | Printer |
| 57 | Telephone (land line) |
| 58 | Wireless/ Mobile phone |
| 59 | Complaint logbook |
| 60 | Table |
| 61 | Chairs |
Copyright © 2024 · All Rights Reserved. Terms of Usage | Privacy Policy
For Tender Information Services Visit : TenderDetail
