|
| 1 | Earth work in excavation (As per I.S. 3114/1965 for laying of different types and sizes of pipes so as to give one meter average cover over the socket of pipe with disposal of excavated earth within initial lead lift as per specification and direction of engineer-in-charge. |
| 2 | Earthwork in backfilling the trenches after laying different types and sizes of pipes with earth removed during excavation within initial lead and lift as per specification and direction of engineer-in-charge |
| 3 | Providing coarse clean sand in filling in foundation trenches or in plinth including ramming and watering in layers not exceeding 150mm thick with all leads and lifts including\" cost of all materials, labour, royalty and taxes all complete as per building specification and direction of E/l (Mode of measurement complacted volume). |
| 4 | DI PIPE: Providing and supplyinng ISI mark centrifugally cast(spun) Ductile Iron pipes of 100mm and above all diameter for water works with socket and spigot ends confirming to IS:8349/2000 in standard working lengths of 4.5,5.5,6.0 m for cloassification K-7 and K-9 suitable for push on joint (Rubber Gasket D jointing) with cement mortar lining inside the pipes with outside zinc and bituminous coating Rate are ex factory, excluding transportation, taxes and duties, contractor\"s profit & overhead charges etc. Based on WPI 119.9 of may 2018(including cost of one gasket for each pipe)K-7 100 mm dia |
| 5 | Supplying labours, tools, tackles, lubricants etc, for laying and jointing C.I.S/S tyton pipes (class LA)/D.I. pipe in trenches supplyng rubber gasket(rubber gaskets confirming to I.S.S - 5382- 1969) and making gasket joints including providing night guard, barrier and red light to safe guard against accident all complete...... direction of E/I100mm |
| 6 | Labour charge for one cutting of cast iron/D.I. and specials including supplying necessary tools and plants, chipping or filling the surface finish as per specification and direction of E/I100 mm |
| 7 | Providing and supplying ISI standard D.I. specials & fitting with sealed rubber gasket of S.B.R. complete with cast iron follower gland and M.S. nut bolts coated or otherwise protected from rusting and suitable for D.I. pipes complete as per IS-9523 class-K-12 (ex facory) inspection charge transportation, CP extra100-300 mm |
| 8 | Providing double flange sluice valve (size 50mm to 1200mm) confirming for IS-2906/14846 including worn gear arrangements as per test pressure stainless steel spindle caps transportation etc all complete.100 mm |
| 9 | Supplying labour and tools for fixing C.I. sluice valce in trenches with a pair of C.I. tail piece including making lead caulked joints and flanged joints as per I.S.S. Specification, including supplying all jointing materials….. Direction of E/I 100 mm |
| 10 | Supplying materials and labour for construction of 600X600X90 mm stop cock chamber of brick masonary with 125mm thick brickwork of designation 75b in cement mortar(1:6) with 12 mm thick cement plaster in cm(1:6) on inside only having 50mm thick R.C.C. cover having 12mm dia lifting rings, 2 nos stop cock chamber will rest over 80mm thick p.c.c. (1:3:6) over one brick flat soling, including cost of earthwork, all complete job, as per approved design, specifications and direction of E/I |
| 11 | SITC of vertical wet well type pumps with motor stool, shaft,column pipe,tee thrust, bearing housing, pressure guage, dial, type brearing temperature guage conforming to IS:1710 & min efficiancy not less than 87% having rated discharge capacity as mention below against total static head 10 metre complete with all accessories as per specification & approved make, including carryingof third party inspection , erection, commisioning teating, trial run,& one year defect liability. (2.00 cumec) |
| 12 | Panell: SITC workof 6.6 KV or3.3 KV, 630 Ampawitch board (panel) as out going motor feeder panel indoor VCB type HT motor complete with temprature scanner, all associated equipment and accessories and match with existing system including termination kits IS-3427 |
| 13 | Supply delivery at site with necessary packing, receiving, unloading shifting, shifting, installation, testing and commissioning of horizontalcentrifugal split casting pumps with miotor as per IS 12615-2011 or amended up to date, CI casing and cavsing ring. SS 316 impleller, SS 410 shaft sleeve , coupling guard, common base plate , foundation bolts etc complete with all respoect as per the specification. |
| 14 | SITC of 6.6 KV Vaccum contactor (VC) draw out type complete trolley suitable for 400 Amperes existing motor feeder panel. |
| 15 | Supplying XLPE / PVC insulated, armoured cable 1100 V grade with ISI mark Three core, solid / stranded aluminium conductor with 6 mm thick 25 mm width M.S. spacer with G.I. Earth wire 6 sq mm, complete in an approved manner.2 core 10 sq mm |
| 16 | 3.5 core 35 sqmm |
| 17 | 3.5 core 50 sqmm |
| 18 | PVC/XLPE insulated PVC sheathed hevy duty, armoured cable with aluminium conductor for working voltage upto and including 1100 volts (conforming to IS:1554, part - 1)16 sqmm, 4 core |
| 19 | 35sqmm, 3.5 core |
| 20 | Earth work in excavation in foundation trenches in ordinarysoil (vide classification of soil item A ) & disposal of excavated earth as obtained to a distanceupto 50 m including all lifts,levelling, ramming the foundation trenches,removing roots of trees, shrubs all complete as per approved design, building specification &directionof E/Incharge. |
| 21 | Filling in foundation trenches and plinth in layers not exceeding 150 mm. thick well watered, rammed, fully compacted and fine dressed with earth obtained from excavation of foundation trenches within a lead of 50 M. and lift of 1.5 M all complete as per building specification and direction of E/l (Mode of measurement compacted volume). |
| 22 | Providing and laying in position cement concrete of specified grade excludingg the cost of centering and shuttering - all work up to plinth level:1:3:6 (1 cement : 3 coarse sand(zone-III) : 6 grade stone aggregate 20 mm nominal size) |
| 23 | Providing designation 75B one brick flat soling joints filled with local sand incluing cost of watering taxes royalty all complete as per building specification and direction of E/I |
| 24 | Providing and laying in position specified grade of reinforcement cement concrete , excludingg the cost of centering ,shuttering, finishingand reinforcement - all work up to plinth level:1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 grade stone aggregate 20 mm nominal size) |
| 25 | Providing tor steel reinforcement of 10mm, 12mm & 16 mm dia. bars as per approveddesign and drawingwith cutting, bending and binding with annealed wire with cost of wire removal of rust , placing the rods in position (including carraige of bars to work site) all complete as per building specification and direction of E/I. 10 mm (TMT coilFe 500 ) (only valid for Tata (Tiscon), SAIL ,JSPL Electrosteel steel Ltd.Bokaro and vizag (RINL) |
| 26 | 12 mm (TMT coilFe 500 ) (only valid for Tata (Tiscon), SAIL ,JSPL Electrosteel steel Ltd.Bokaro and vizag (RINL) |
| 27 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. |
| 28 | Silent type D.G set of capacity 200KVA with AMF Panel IS/IEC 60034-1 IS:1460 IS:13018 |
| 29 | Reinforcement cement concrete work in walls (any thickness), including attached pillasters, buttresses, plinth and string courses, fillets,columns,pillars,piers,abutments,posts and struts etc. above plinth level upto floor five level, excluding cost of centering , shuttering, finishing and reinforcement :1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 grade stone aggregate 20 mm nominal size) |
| 30 | Reinforced cement concrete work in beams,suspended floors,roofs having slope up to 15 ° landings,balconies, shelves,chajja,lintels,bands,plain window sills,stair cases and spiral staircases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 graded stone agggregate 20 mm. nominal size) |
| 31 | Providing designation 75 B brick work in C.M. (1:6) in foundation and plinth with approved quality of clean coarse sand of F.M. 2 to 2.5 including providing 10mm thick mortar joints, cost of screening materials, raking out joints to 15mm depth, curing, taxes and royalty all complete as per building specification and direction of E/l. |
| 32 | Providing designation 75 B brick work in C.M. (1:6) in superstructure with approved quality of clean coarse sand of F.M. 2 to2.5 including providing 10 mm thick mortar joints cost of screening materials , scafolding , raking out joints to 15mm depth curing, taxes and royalty all complete as per building specification and direction of E/l. |
| 33 | Providing 12 mm. thick cement plaster (1:6) with clean coarse sand of F.M. 1.5 including screening, curing with all leads and lifts of water,scafolding taxes and royality all completed as per building specification and direction of E/I |
| 34 | Providing 6 mm. thick cement plaster (1:4) in ceiling with clean coarse sand of F.M. 1.5 including screening, curing with all leads and lifts of water,scafolding taxes and royality all completed as per building specification and direction of E/I |
| 35 | White washing three coats over new surface with approved quality of lime including cost of cleaning surface throughly and removing the scales of smoke and mosh marks with jhama rubbing,scafolding , washing , of floors and taxes all complete as per building specification and direction of E/I. |
| 36 | Providing, hoisting and fixing above plinth level up to floor five level precastreinforced cement concrete in shelves, including setting in cement mortar1:3 (1cement : 3 coarse sand), cost of required centering, shutteringand finishing with neat cement punning on exposed surfaces but ,excluding the cost of reinforcement, with 1:1.5:3 (1 cement : 1.5 coarsesand(zone-III) derived from natural sources : 3 graded stone aggregate20 mm nominal size derived from natural sources). |
| 37 | Providing tor steel reinforcement of 10mm, 12mm & 16 mm dia. bars as per approveddesign and drawing 12 mm (TMT coilFe 500 ) (only valid for Tata (Tiscon), SAIL ,JSPL Electrosteel steel Ltd.Bokaro and vizag (RINL) |
| 38 | Providing Tor steel reinforcement of 8 mm dia of rod as per approved design and drawing 8 mm. T.M.T. Fe 500 (only valid for TATA (Tiscon),SAIL, JSPL,Electrosteel stees ltd. Bokaro & Vizag (RINL)) |
| 39 | Dismantling R.C.C. work including stacking serviceable materials in countable stacks with in 15 m. leads and disposal of un serviceable materials with all leads all complete as per direction of E/I. |
| 40 | Construction of Granular sub-base by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with front end loader at OMC, and compacting with vibratory roller to achieve the desired density, completed as per clause 401. (i) Rate per cum for grading -i material. |
| 41 | Construction of un-reinforced, dowel jointed, plain cement concrete pavement over a prepared sub base with approve grade cement @ 400 kg per cum, coarse and fibe aggregate conforming to IS 383, maximum size of coarse aggregate note exceeding 25mm , mixedin a batching and mixing plant as per approved mix design transported to site , laid with a fixed form of slop form paver, spread,compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitidunal joints , joint filler , seperation membranes , sealant primer , joints sealant , debonding strip, dowel bar, tie rod, admixture as approoved , curing compound, finishing to lines and grades as per drawing. |
| 42 | ADD GST @18% |
| 43 | ADD LABOUR CESS @1% |
