Tender For Augmentation Of Water Supply At Tugapur No.6 By Resizing Of Cc Check Weir At Tugapur No.5 Source Under Sub Division No.Ii, Nacd, Apwd, Mayabunder.
Tender Value
21.12 Lakhs
Estimated cost
Bid Submission
23 Mar 2023
0 days left
EMD
42246
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
mayabunder → Andaman And Nicobar Islands
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Augmentation Of Water Supply At Tugapur No.6 By Resizing Of Cc Check Weir At Tugapur No.5 Source Under Sub Division No.Ii, Nacd, Apwd, Mayabunder.
BOQ
| Sl. No. | Item Description |
| 1 | Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-in-charge. |
| 2 | All kinds of soil |
| 3 | Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. |
| 4 | All kinds of soil. |
| 5 | Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth up to 30 cm measured at a height of 1 m above ground level and removal of rubbish up to a distance of 50 m outside the periphery of the area cleared. |
| 6 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : |
| 7 | 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 20 mm nominal size derived from natural sources). |
| 8 | 1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources: 6 graded stone aggregate 40 mm nominal size derived from natural sources). |
| 9 | 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources). |
| 10 | Centering and shuttering including strutting, propping etc. and removal of form for |
| 11 | Foundations, footings, bases of columns, etc. for mass concrete |
| 12 | Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. |
| 13 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. |
| 14 | Electric resistance or induction butt welded tubes |
| 15 | Providing and fixing bolts including nuts and washers complete. |
| 16 | Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete. |
| 17 | 40 mm thick with 20 mm nominal size stone aggregate |
| 18 | Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. |
| 19 | 12 mm cement plaster of mix : |
| 20 | 1:4 (1 cement: 4 fine sand) |
| 21 | Painting with black anti-corrosive bitumastic paint of approved brand and manufacture to give an even shade : |
| 22 | Two or more coats on new work |
| 23 | Carriage of MS Pipe, MS sheet by head load for an average lead of 4000 mtr. |
| 24 | Carriage of sand and stone aggregate below 40mm nominal size by head load for an average lead of 4000 mtr. |
| 25 | Carriage of cement by head load for an average lead of 4000 mtr. |
| 26 | Carriage of stone aggregate above 40mm nominal size by head load for an average lead of 4000 mtr. |
| 27 | Carriage of MS Pipe, MS sheet by head load for an average lead of 500 mtr. |
| 28 | Carrriage of sand and stone aggregate below 40mm nominal size by head load for an average lead of 500 mtr. |
| 29 | Carriage of cement of by head load for an average lead of 500 mtr. |
AI Tender Summary
Tender Timeline
Mar 07, 2023
11:30 IST
Tender Published
Tender notice published.
CompletedMar 23, 2023
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedMar 24, 2023
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender