Tender For Submersible With Water Tank Near Shakti Pada Gantait At Chhatarkol(Sansad)
Tender Value
Ref. Documents
Estimated cost
Bid Submission
14 Mar 2023
0 days left
EMD
3500
Bank guarantee accepted
Document Fee
250
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
sabang → West Bengal
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Submersible With Water Tank Near Shakti Pada Gantait At Chhatarkol(Sansad)
Corrigendum
| Sr No | Corrigendum Date | Corrigendum | Type | New Submission Date |
|---|---|---|---|---|
| 1 | 14-Mar-2023 | CORRIGENDUM FOR DATE EXTENSION | Date | 15-Mar-2023 |
BOQ
| Sl. No. | Item Description |
| 1 | Labour for boring tubewell of required dia by water jet system through any type of soil strata including hire and labour charges for boring pipes,scaffolding,tools and plants as nessary and taking out them and lowering of pipes,strainers,blind pipes etc and fixing the same complete,including bucket washing and have a minimum 50mm gap in between the outside of the tubewell pipe and the bore.a) For depth upto 150mtr for 50mm dia tubewell with top enlargement of 100mm dia Note:-Where no lowering of pipe is involved the corresponding rate would be reduced by 30% for minimum dia of boring pipe.i) 100mm dia boring etc. with top enlargement. |
| 2 | Supplying ,delivering at worksite of including cost of transportation to workesite of the following pipes ,strainers,accessaries etc as per direction (a)supply at worksite P.V.C. pipe light duty (Schdule - 40) confirming to ASTMD-1785,and threaded to match with GI Pipes i) 100mm dia P.V.C Pipe(s-40) |
| 3 | iii) 100 mm dia P.V.C. strainer |
| 4 | iv) 100 mm dia end plug |
| 5 | vi) 100mm dia housing clampincluding fitting,fixing all complete |
| 6 | vii) Solvent |
| 7 | viii) 100mm dia M.S. / G.I.top cap |
| 8 | a) Supplying , fitting and fixing 1.5 H.P. Submersible pump with motor (KSB/Cromtom Greves/Texmo or any other stander approved brand) including starter with control panel board(240 V/5AMP with all complete ( 1.5 H.P.) |
| 9 | b) Supplying fitting and fixing 40 mm dia PVC Column pipes for underground workof approved make (medium duty)ASTMD-1785 and threaded to match with GI pipes as per IS :1239 with all necessary accessories. |
| 10 | c) Supply of G.I.bend 40mm dia |
| 11 | d) Supply ofG.I.TATA short piece(150mm long) 40mm dia |
| 12 | e) Supplying , fitting ,fixing finolex brand flate cable Make- Finolex/ Havells (240V/2.5 AMP) |
| 13 | Packing the annular space between the outside of the tube well pipes & strainers and the bore with pea size washed gravel of approved quality having size from 2 mm to 5 mm including cost ofmaterils and labour complete. |
| 14 | Washing and development of tubewell with air compressor pump and engine for 8 hours contineous pumping per day with nessary arrangement for testing yield in galons per hour with V notch including hire and labour charges for all tools and plants and Scaffolding as required complete in all respect. |
| 15 | Supply of 1000 Lit. P.V.C( ISI) Water storage Tank of approved quqlity with closed top with lid-Multilayer |
| 16 | Labour for hoisting plastic water storege tank upto 1000 litre capacity upto 1 st storyed from GL. |
| 17 | Supplying ,fitting and fixing polythene Bib cock/stop cock (HD) with plastic inlet (EMCO/ATLAS or equivalent) 15 mm dia |
| 18 | supply of 25 mm P.V.C pipes & fittings(medium duty)conforming to ASTMD-1785 delivery purpose. |
| 19 | Supply &fittings of 15 mm p.v.c pipe(medium duty) |
| 20 | Supplying,fitting & fixing push cock of approved make 15 mm (polythene Push cock) |
| 21 | Earth work in excavation of foundation trenches in all sort of soils (including mixed soil but excluding laterite or sand stone ) including removing ,spreding or staking the spoils with in a lead of 75m as directed ,the item includes necessary triming the sides necessary triming the sides of trencheslevelling, dressing and ramming the bottom ,bailing out water as required complete. (ordinary mix soil to be excavated by spade) depth of excavation not exceeding 1.500 m.. |
| 22 | Filling in foundation or plinth by fine sand in layers not exceeding 150 mm as directed and consolidating the same by through Saturation with water,ramming complete.including the cost of supply of sand. |
| 23 | Cement concrete with graded jhama khoa(30 mm.size) excluding shuttering. PCC(M10)In ground floor and foundation. |
| 24 | Ordinary cement concrete ( Mix – 1:1.5:3) with graded stone chips (20 mm Nominal size ) excluding shuttering and reinforcement if any. as per relevant ( IS Codes) Pakur variety. InGroundfloor. |
| 25 | Hire and labour charges for shuttering and necessary staging upto 4 m using approved stout props and 20 mm to 30 mmthick wooden shutter blank & approved thickness with required tracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works. As per decision & direction of EIC.with out staging |
| 26 | Hire and labour charges for shuttering and necessary staging upto 4 m using approved stout props and 20 mm to 30 mmthick wooden shutter blank & approved thickness with required tracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works. As per decision & direction of EIC.With Staging |
| 27 | Reinforcement for reinforced concrete work in all sorts of structures including distribution bars ,stirrup,bindersetc initial straightening and removal of loose rust(if Necessary)cutting to requisite length,hooking and bending with 16 guage black annealed wire at every intersection,complete as per drawing & direction.(Tor Steel) |
| 28 | 125 mm th. Brick work with 1st Class Brick in cement mortar (1:4) in superstructure Gr. Fioor. |
| 29 | Collection sample of water of the tube well in clean and washed container and sending the sample to the laboratory for chemical and arsenic testing and send report. |
| 30 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface](ii) With 1:4 cement mortar (c) 15 mm thick plaster |
| 31 | neat cement punning 1x2.5x2.5=6.25sqm |
| 32 | (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary: Same as item no 22 |
| 33 | Supplying, fitting and fixing in position G.I. pipes of TATA make for underground works with all necessary accessories,specials viz.socket, bend, tee, union, cross, elbow, nipple, short piece etc.including cost of all materials,jointing materials ,cutting pipes,making threads,cutting trenches upto 1.5 metre below surface in all sorts of soil and refilling the same as directed with two coats of painting on G.I. pipes and specials with bituminous paint complete in all respect. (Payment will be made on the centre line measurement of the total pipe line including all specials No separate payment will be made for accessories, specials.Payment for painting will be made seperately) |
| 34 | Writing and fixing of display board & Photograph (3 stagr)of new Submersible Pump |
| 35 | Add : CGST @ 9% |
| 36 | Add : SGST @ 9% |
| 37 | Add : Labour Welfare Cess @ 1% |
AI Tender Summary
Tender Timeline
Mar 06, 2023
11:30 IST
Tender Published
Tender notice published.
CompletedMar 14, 2023
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedMar 17, 2023
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender