Tender For 217 Panichola Swajaldara Kudivella Padhathi Naveekaranam

Sharing tender

1 New Motor Fixing And Renovation Of Pump House 2 4.1.3:Providing And Laying In Position Cement Concrete Of Specified Grade Excluding The Cost Of Centering And Shuttering - All Work Up To Plinth Level:1:2:4 ( Cement : 2 Coarse Sand ( Zone-Iii ) : 4 Graded Stone Aggregate 20 Mm Nominal Size ) 3 4.3.1:Centering And Shuttering Including Strutting, Propping Etc. And Removal Of Form Work For:Foundations, Footings, Bases For Columns 4 50.6.1.8:Solid Block Masonry Using Pre Cast Solid Blocks ( Factory Made ) Of Size 40X20x15cm Or Nearest Available Size Confirming To Is 2185 Part I Of 1979 For Super Structure Up To Floor Two Level With Thickness 15Cm In: Cm 1:6 ( 1 Cement : 6 Coarse Sand Etc Complete 5 5.22.6:Steel Reinforcement For R.C.C Work Including Straightening, Cutting, Bending, Placing In Position And Binding All Complete Upto Plinth Levelthermo - Mechanically Treated Bars Of Grade Fe-500D Or More 6 13.1.1:12 Mm Cement Plaster Of Mix:1:4 ( 1 Cement : 4 Fine Sand ) 7 13.37.1:White Washing With Lime To Give An Even Shade:New Work ( Three Or More Coats ) 8 13.45.1:Finishing Walls With Textured Exterior Pint Of Required Shade:New Work ( Two Or More Coats Applied @ 3.28 Ltr / 10 Sqm ) Over And Including Priming Coat Of Exterior Primer Applied @ 2.20 Kg / 10 Sqm 9 10.5.2:Providing And Fixing 1 Mm Thick M.S. Sheet Door With Frame Of 40X40x6 Mm Angle Iron And 3 Mm M.S. Gusset Plates At The Junctions And Corners, All Necessary Fittings Complete, Including Applying A Priming Coat Of Approved Steel Primer.Using Flats 30X6 Mm For Diagonal Braces And Central Cross Piece 10 50.10.2:Steel Work For Purlin / Single Section With G I Pipes Including Cutting, Hoisting, Fixing In Position And Applying A Priming Coat Of Approved Steel Primer, Including Welding And Bolted With Special Shaped Washers Etc. Complete 11 Od322180 / 2022-2023:Providing And Fixing Precoated Galvanised Iron Profile Sheets ( Size, Shape And Pitch Of Corrugation As Approved By Engineer-In-Charge ) 0.35 Mm ( +0.05% ) , Total Coated Thickness With Zinc Coating 120 Grams Per Sqm As Per Is: 277, In 240 Mpa Steel Grade, 5-7 Microns Epoxy Primer On Both Side Of The Sheet And Polyester Top Coat 15-18 Microns. Sheet Should Have Protective Guard Film Of 25 Microns Minimum To Avoid Scratches During Transportation And Should Be Supplied In Single Length Upto 12 Metre Or As Desired By Engineer-In-Charge. The Sheet Shall Be Fixed Using Self Drilling / Self Tapping Screws Of Size ( 5.5X55mm ) With Epdm Seal, Complete Upto Any Pitch In Horizontal / Vertical Or Curved Surfaces, Excluding The Cost Of Purlins, Rafters And Trusses And Including Cutting To Size And Shape Wherever Required. 12 4.1.8:Providing And Laying In Position Cement Concrete Of Specified Grade Excluding The Cost Of Centering And Shuttering - All Work Up To Plinth Level:1:4:8 ( 1 Cement : 4 Coarse Sand : 8 Graded Stone Aggregate 40 Nominal Size ) 13 Od330268 / 2022-2023:Supplying, Conveying, Fitting, Trial Running And Commissioning Of Electrically Driven Best Quality Reputed Make Isi Marked , Open Well / Bore Well Submersible Pump Set Having Bronze Impeller &Amp; Stainless Steel Shaft Capable Of Discharging Required Lpm Against A Total Required Head Including All Accessories Such As Panel Board, Suitable Starter, Flat Submersible Cable Of Sufficient Grade, Delivery Pipe ( Up To 10 M ) Connecting To The Pumping Main Etc. Complete. The Warranty Shall Be For A Minimum Period Of Two Years. 1 Hp To 10 Hp.