Tender For Construction Of Bridge Over Dholia River Between Village Sonpur And Siyardih Under Phulwadia Panchayat In Thakurgangti Block, District Godda.
Tender Value
2.92 Crore
Estimated cost
Bid Submission
16 Jan 2023
0 days left
EMD
5.85 Lakhs
Bank guarantee accepted
Document Fee
10000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
thakurgangti → Jharkhand
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Construction Of Bridge Over Dholia River Between Village Sonpur And Siyardih Under Phulwadia Panchayat In Thakurgangti Block, District Godda.
BOQ
| Sl. No. | Item Description |
| 1 | Excavation for strucutres Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material.Mechanical MeansDepth upto 3 m |
| 2 | Levelling Course for Pile capProviding and laying of PCC M15 levelling course 100 mm thick below the pile cap.PCC Grade M15 using batching plant & Concrete pump |
| 3 | Bored cast-in-situ M35 grade R.C.C. Pile excluding Reinforcement complete as per Drawing and Technical Specifications and removal of excavated earth with all lifts and lead upto 1000 m.Pile diameter-1200 mm |
| 4 | Cement Concrete for Reinforced Concrete in Pile Cap complete as per Drawing and Technical SpecificationRCC Grade M25 RCC Grade M25 using batching plant & Concrete pump |
| 5 | Supplying, Fitting and Placing un-coated HYSD bar Reinforcement in Foundation complete as per Drawing and Technical Specifications. |
| 6 | Providing Steel Liner 10 mm thick for Curbs and 6 mm thick for Steining of Wells including Fabricating and Setting out as per Detailed Drawing. |
| 7 | Plain/Reinforced cement concretein sub-strucutre complete as per drawing and Technical specificationsRCC Grade M25RCC Grade M25 using batching plant, transit mixer & concrete pumpHeight upto 5m |
| 8 | Height 5 to 10m |
| 9 | Supplying, fitting and placing HYSD bar reinforcement in sub structure complete as per drawing and technical specifications |
| 10 | Supplying , fitting and fixing in position true to line and level elastomeric bearing conforming to IRC:83 (Part-II) section IX and clause 2005 of Mort&H specification complete including all accessories as per drwaing and technical specifications |
| 11 | Providing weep holes in Brick masonry/ Plain/Reinforced concrete abutment , wing wall/ returen wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1V:20 H towards drawing face. Complete as per drawing and technical specifications. |
| 12 | Back filling behind abutment, wing wall, return wall complete as per drawing and technical specificationsSandy material |
| 13 | Providing and laying of filter media with granular materials/stones crushed aggregates satisfying the requirements laid down in clause 2504.2.2 of MoRT&H specifications to a thickness of not less than 600 mm with smaller size towards the soil and bigger size towards the wall and provided over the entire surface behind abutment , wing wall and return wall to the full heightcompacted to a firm condition complete as per drwaing and technical specification. |
| 14 | RCC Grade M30 Using Batching Plant,Transite Mixer and Concrete Pump.For T-beam & slab, 25-35 per centof (a+b+c) Height 5m to 10m |
| 15 | Supplying, fitting and placing HYSD bar reinforcement in super-structure complete as per drawing and technical specifications |
| 16 | Providing and laying Cement concrete wearing coat M-30 grade including reinforcement complete as per drawing and Technical Specifications |
| 17 | Construction of RCC railing of M30 Grade in-situ with 20 mm nominal size aggregate, true to line and grade, tolerance of vertical RCC post not to exceed 1 in 500, centre to centre spacing between vertical post not to exceed 2000 mm, leaving adequate space between vertical post for expansion, complete as per approved drawings and technical specifications. |
| 18 | Drainage Spouts complete as per drawing and Technical specification |
| 19 | PCC M15 Grade leveling course below approach slab complete as per drawing and Technical specificationPCC Grade M15 using batching plant & Concrete pump |
| 20 | Reinforced cement concrete approach slab including reinforcement and formwork complete as per drawing and Technical specification |
| 21 | Strip Seal Expansion JointProviding and laying of a strip seal expansion joint catering to maximum horizontal movement upto 70 mm, complete as per approved drawings and standard specifications to be installed by the manufacturer/supplier or their authorised representative ensuring compliance to the manufacturer\"s instructions for installation. |
| 22 | Providing and laying pitching on slopes laid over prepared filter media including boulder apron laid dry in front of toe of embankment complete as per drawing and Technical specifications.Stone/Boulder |
| 23 | Providing and laying Filter material underneath pitching in slopes complete as per drawing and Technical specification |
| 24 | Plain/Reinforced cement concretein sub-strucutre complete as per drawing and Technical specificationsPCC Grade M20Height upto 5mPCC Grade M20 using batching plant, transit mixer & concrete pump |
| 25 | Clearing and Grubbing road land Clearing and grubbing road land including uprooting rank vegetation, grass, bushes, shrubs, sapling and tress girth upto 300 mm, removal of stumps of tree cut earlier and disposal of unserviceable materials and stacking of sericeable material to be used of auctioned, up to a lead of 1000 metres including removal and disposal of top organic soil not exceeding 150mm in thickness.By Manual means:- In area of thorny jungle |
| 26 | Construction of Embankment with Material obtained from Borrow pits.Construction of Embankment with approved material obtained from Borrow pits with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of Table 300-2. |
| 27 | CompactingOriginal groundCompactingOriginal ground supporting sub-gradeLoosening of the ground upto a level of 500 mm below the sub-grade level, watered, graded and compacted in layers to meet requirement of Table 300-2 for sub-grade construction. |
| 28 | Granular Sub-Base with Graded Material (Table:- 400-1)By Mix in Place MethodConstruction of granular sub-base by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with front end loader at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401.Rate per cum for grading-IMaterial |
| 29 | Wet Mix Macadam (Plant Mix Method)Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with grader in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density. |
| 30 | Prime Coat over WMM/WBMProviding and applying primer coat with SS1 grade bitumen emulsion on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means. |
| 31 | Tack Coat on Bituminous surfacesProviding and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.25 kg per sqm on the prepared bituminous surface cleaned with mechanical broom. |
| 32 | Open-Graded Premix SurfacingProviding, laying and rolling of open-graded pemix surfacing of 20mm thickness composed of 13.2mm to 5.6mm aggregates using viscosity grade bitumen to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable hot mix plant of appropriate capcity not less than 200 tonnes/hour, laying and rolling with a smooth wheeled roller finished to required level and grades. |
| 33 | Seal CoatCase-II : Type BProviding and laying of premix sand seal coat with HMP of appropriate capacity not less than 200 tonnes/hours using crushed stone chipping 6.7mm size and penetration bitumen of suitable grade. |
| 34 | Providing and laying pitching on slopes laid over prepared filter media including boulder apron laid dry in front of toe of embankment complete as per drawing and Technical specifications.Stone/Boulder |
| 35 | Excavation for strucutres Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material.Mechanical Means |
| 36 | Sand Filling in foundation trenches as per drawing & technical specification |
| 37 | PCC 1:3:6 in FoundationPlain cement concrete 1:3:6 nominal mix in foundation with crushed stone aggregate 40 mm nominal size mechanically mixed, placed in foundation and compacted by vibration including curing for 14 days. |
| 38 | Stone masonry work in cement mortar 1:3 in foundation complete as per drawing and technical specifications.Random Rubble masonry (coursed/uncoursed) |
| 39 | Stone masonry work in cement mortar 1:3 for substructure complete as per drawing and technical specificationsRandom Rubble Masonry (Coursed/uncoursed) |
| 40 | Providing weep holes in Brick masonry/ Plain/Reinforced concrete abutment , wing wall/ returen wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1V:20 H towards drawing face. Complete as per drawing and technical specifications. |
| 41 | Pointing with cement mortar (1:3) on brick work in substrucutre as per technical specifications |
| 42 | Plain/Reinforced cement concretein sub-strucutre complete as per drawing and Technical specificationsPCC Grade M20Height upto 5mPCC Grade M20 using batching plant, transit mixer & concrete pump |
| 43 | Carriage of MaterialsSand (Local) - 8 KM (7 KM S + 1 KM US) |
| 44 | Cement (Godda) - 47 KM |
| 45 | Boulder - 35 KM |
| 46 | Aggregate - 77 KM |
| 47 | Steel (Godda) - 47 KM |
| 48 | Bitumen (Bokaro) - 267 KM |
| 49 | Bitumen Emulsion (Bokaro) - 267 KM |
| 50 | GST @ 18% |
| 51 | Labour cess @ 1% |
AI Tender Summary
Tender Timeline
Jan 06, 2023
11:30 IST
Tender Published
Tender notice published.
CompletedJan 16, 2023
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedJan 18, 2023
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender