Military Engineer Services-MES has published Tender For Provision Of Rain Water Drainage System Including Miscellaneous Connected Work At Abhm Annexe Under Ge New Delhi. Submission Date for this Tender is 17-12-2022. Drainage Tenders in NEW DElhi Delhi. Bidders can get complete Tender details and download the document.
| Sr No | CorrigendumDate | Corrignedum | CorrigendumType | NewSubmissionDate |
| 1 | 10-Dec-2022 | Bid Auto Extn Corrigendum | Bid Auto Extn Corrigendum | 17-12-2022 |
| Sl. No. | Item Description |
| 1 | Excavating in trenches not exceeding 1.5 m wide and not exceeding 1.5m in depth etc not exceeding 10 Sqm on plan for shafts, cesspits, manholes pier holes, foundation etc and getting out in soft/loose soil incl removing the surplus soil or unserviceable material out side the MOD land complete all as specified & directed. (Note - Excavation any type of soil soft/Hard/Disintegrated/Rock carried out by only manually without any damages, and no extra cost paid by MES/Govt for repairs of damages any type of existing services) |
| 2 | Excavating in trenches not exceeding 1.5 m wide and not exceeding 1.5m in depth etc not exceeding 10 Sqm on plan for shafts, cesspits, manholes pier holes, foundation etc and getting out in hard/dense soil incl removing the surplus soil or unserviceable material out side the MOD land complete all as specified & directed. (Note - Excavation any type of soil soft/Hard/Disintegrated/Rock carried out by only manually without any damages, and no extra cost paid by MES/Govt for repairs of damages any type of existing services) |
| 3 | Item No 02 above here-in-before but exceeding 1.5m to 3.0m deep. |
| 4 | Retuning filling, including spreading, levelling, watering and well ramming in layers not exc. 25 cm each layers with soft/hard soil complete all as specified & directed. |
| 5 | Demolition of cement concrete unreinforced of any description and in any position not other wise specifically providedas in drain copings and similar situations complete all as specified & directed. |
| 6 | Demolition of reinforced cement concrete of any description and any position no otherwise specifically ( below or above ground level) including cutting of reinforcement as required to facilitate demolition complete all as specified & directed. |
| 7 | Demolition of brick work or stone boulder masonry, built in cement mortar including all quoins, arches, pillars, drains, culverts and walls etc but excluding ashlar facings, dressed stone work and pre cast concrete articles, built in cement mortar complete all as specified & directed. |
| 8 | M&L for 100 mm thick PCC 1:3:6, type C-1(using 20 mm graded stone aggregate) as in hard standing, paths, floor etc. finished rough surface without using extra cement completeall as specified. |
| 9 | M&L for PCC 1:3:6, type C-1(20 mm agg) as in drain finished even & smooth surface without using extra cement completeall as specified. |
| 10 | M&L pre cast reinforced cement concrete 1:2:4 type B-1 using 20 mm graded stone aggregate as in cover slabs for manholes, drains and such similar works including set inCM 1:6. complete all as specified. |
| 11 | M&L for lean concrete 1:4:8 type D 2 (using 40 mm graded stone aggregate)as in foundation filling and mass concrete complete all as specified and directed. |
| 12 | M&L for reinforced cement concrete M-25 (Design Mix) using 20 mm graded aggregate as in foundations, including rafts, footings, foundation beams, plinth beams, bases for columns, etc; basement slabs, under-reamed piles and mass concrete complete all as specified and directed. |
| 13 | M&L for reinforced cement concrete M-25 (Design Mix) using 20 mm graded aggregate as in columns, pillars, piers, posts and struts etc complete all as specified and directed. |
| 14 | M&L for flat form work to sides of concrete foundation, footings, bases of columns, raft and raft beams sides and soffits (if any) of foundation and plinth beams and similar work vertical or batterfinished rough surface of concrete complete all as specified and directed. |
| 15 | M&L for flat form work square, rectangular to sides of pillars, posts, sturts, piers, columns and stanchions and similar work vertical or batter finished rough surface of concrete complete all as specified and directed. |
| 16 | M&L for reinforced cement concrete M-25 (Design Mix) using 20 mm graded aggregate as in slab supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, chajja, deck slab and in shelves and the like complete all as specified and directed. |
| 17 | M&L Form work to soffits of suspended slab such as roof slab, floor slab, landings and similar work flatfor fair finished surface complete all as specified and directed. |
| 18 | M&L for black or any coloured granite (of any type)work 18-20 mm thick table rubbed and polished as in platform, face lifting of lift area and like , machine cut laid over and including 15 mm thickscreed bed in CM 1:4,laid and jointed with grey cement slurry and incl pointing in white cement (1:2) using marble dust with admixture of pigment to match with granite shade including cutting, rounding edges and polishing complete. |
| 19 | Ditto All as per item No 18 above butasin vertical surfaces such as dado/skirting laid over and including rendering premix/ready-mix plaster10 mm thick on brick or concrete surfaces of ceiling, chajaas, columns, beams and similar work in CM 1:4 finished even & smooth without using extra cement over a coat of UltraTech seal and dry 5 plush as bonding agent jointed with grey cement slurry and incl pointing in white cement (1:2) using marble dust with admixture of pigment to match with marble shade including cutting and polishing complete. |
| 20 | Supply only liquid water proofing compound. |
| 21 | Dismantling wrought iron or mild steel work of any description and any positions not other wise provided for complete all as specified and directed. |
| 22 | S&F framed work such as grills, gratings framed and hung gates, including pintels, hinges, stopes, hand made sliding bolt etc with ends of bars shouldered and/or riveted, welded or forged into spikes framed guard bars, barred doors & walk ways railings frame work of water tank and similar work up to six story bldg. including necessary safety precaution confirming to Fe-290 Gde -E-165 |
| 23 | M&L for preparation of new steel surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specifies and as directed. |
| 24 | Taking down cement plaster of any description on brick, concrete or stone walls, columns, drains, raking out joints, hacking for key and scrubbing down with water etc to receive new plaster complete all as specified and directed. |
| 25 | M&L for preparation new plastered surface of wall and applying two coats of cement base paint over a coat of priming plastered and other surfaces with alkali-resistant priming paint complete all as specifies and as directed. |
| 26 | M&L for premix/ready-mix plaster15mm thick on brick or concrete surfaces of walls, chajja, roofs, beams, columns etc in CM 1:4 finished even & smooth without using extra cement over a coat of UltraTech seal and dry 5 plush as bonding agent including necessary form work safety precaution up to six storey bldgs. complete all as specified & directed. |
| 27 | M&L brick work with sub class "B" bricks, straight or curved on plan exc. 6.00 m mean radius built in CM 1:4 complete all as specified. |
| 28 | As per item no 27 above here-in-before but except brick. |
| 29 | M&L TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending, spirally for hooping for columns, hooking ends and binding withmild steel wire (annealed) not less than 0.9mm dia or securing with clipsall as directed by Engr-in-Charge. |
| 30 | Ditto as per item no 29 above here-in-before but 6 to 8 mm dia |
| 31 | M&L for extra for forming fair finished drain or channel 30 cm or overinner girth in cement concrete, using extra cement, including forms, moulds, mi- tred/stopped ends etc complete all as specified & directed at site. |
| 32 | M & L for PCC (1:2:4) type B-1 (using 20mm graded crushed stone aggregate) as in plinth courses, string courses, mud stops or roof kerbs, benching, copings, channels, slightly chamfered or rounded on edge including necessary use of form work complete all as specified & directed at site. |
| 33 | Demolition and breaking up drain pipes (salt glazed ware, AC or reinforced concrete, PVC) set in cement mortar, bore of pipe 150mm including removal of rubbish out side of MoD Land. |
| 34 | M & L Cement concrete 1:3:6 type C-2 (using 40mm graded crushed stone aggregate) in concrete bed to drain pipes including packing under and haunching against the sides of pipe of 150 mm bore after they are laid and tested. |
| 35 | M & L Salt glazed stone ware ( SGSW ) drain pipes, Grade ‘A’ 150 mm bore, laying level or to falls in trenches, on concrete bed or directly on hard grounds and making joints and testing complete. |
| 36 | M&L cutting into existing manholes for connecting new drains, making good to pipes and rendering, cutting out existing benching for and forming branch channel ( 1/2 round or 3/4 section) in cement concrete 1:2:4 type B-1, smooth finished and reforming benching as required for 150 mm internal dia of pipes. |
| 37 | S&F precast fibre concrete or polymer concrete grade of M-30 with 8mm dia TMT bar 90mm C/C both bays reinforced concreteuse vivro-compaction techniquescircular manholes cover frame and gratings, lifting holes heavy duty of size 560 ofcircular manholes cover 80 mm thick KCC MHCF 01confirming to IS: 12592 and IS:1726, factory made arean. exc. 0.50 sqmcomplete all as specified and directed by Engr-in-charge. |
| 38 | S&F precast fibre concrete or polymer concrete grade of M-30 with 8mm dia TMT bar 90mm C/C both bays reinforced concreteuse vivro-compaction techniquesrectangular draincover (medium duty)of size 600X450X90mm thick DC-01 , confirming to IS: 12592 and IS:1726, factory made arean. exc. 0.50 sqmcomplete all as specified and directed by Engr-in-charge. |
| 39 | S&F precast fibre concrete or polymer concrete grade of M-30 with 8mm dia TMT bar 90mm C/C both bays reinforced concreteuse vivro-compaction techniquesrectangular draincover (medium duty)of size 900X450X90mm thick, DC-04 confirming to IS: 12592 and IS:1726, factory made arean. exc. 0.50 sqmcomplete all as specified and directed by Engr-in-charge. |
| 40 | M&L for 75 mm thick PCC 1:3:6, type C-1 (using 20 mm graded stone aggregate) as in hard standing, paths, floor etc. finished rough surface without using extra cement completeall as specified. |
| 41 | M&L machine pressed pre cast concrete interlocking decorative paver block PU coated of any size and shape confirming to IS 15658-2006 of 80 mm thickness M-40 grade with grey cement and no pigment, size and shape of paver as approved complete all as specified and directed. |
| 42 | M&L for concrete work in pavement/hard-standing of flexural strength 40kg/per square centimetre in filled using 400 kg of cement per cubic metre, thickness of concrete (using 20 mm graded stone aggregate) finished rough surface without using extra cement incl. necessary use of form work complete all as specified and directed. |
| 43 | M&L laying of fine aggregate ( sand) 50 mm thick for laying of interlocking paver vide item No 41 above including watering and consolidation etc complete all as specified. |
Copyright © 2024 · All Rights Reserved. Terms of Usage | Privacy Policy
For Tender Information Services Visit : TenderDetail
