Thanjavur District- Construction Of Panchayat Office Buildings At Koonanchery Panchayat In Papanasam Block In Thanjavur District Under Agamt Ii 2021-2022
Tender Value
25.48 Lakhs
Estimated cost
Bid Submission
10 Oct 2022
0 days left
EMD
25480
Bank guarantee accepted
Document Fee
25480
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
papanasam → Tamil Nadu
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Thanjavur District- Construction Of Panchayat Office Buildings At Koonanchery Panchayat In Papanasam Block In Thanjavur District Under Agamt Ii 2021-2022
BOQ
| Sl. No. | Item Description |
| 1 | PART :3.Construction of Panchayat office Building@Konnanchery Panchayat |
| 2 | Earth work excavation and depositing on bank with in initial lead of 10 m and initial lift of 2m in hard stiff clay, stiff black cotton soil, hard red earth,earth mixed with small sized boulders and hard gravelly soil as per specification etc.,complete for foundation. |
| 3 | Collection and supply of sand and filling in to the basement including cost and conveyanceto the siteand all labour charges for filling as per standard speecifications., etc complete |
| 4 | Cement concrete 1:4:8 mix (one cement four sand and eight aggregate) using 40mm gauge handbroken granite stone jelly for foundation including dewatering if found ecessary and laid in layers of not more than 15 cm thick and compacted,etc., complete complying withstandard specfication. |
| 5 | Collection and supply of gravel for filling from approved quarry including cost and conveyance of all materials to site and all labour charges etc., complete.. |
| 6 | Brick work in cement mortar 1:5 mix using country bricks 83/4\"x41/4\"x23/4\" and conveyance of all materials to site and all labour charges etc complete.(Below Basement) |
| 7 | Brick work in cement mortar 1:5 mix using country bricks 83/4\"x41/4\"x23/4\" and conveyance of all materials to site and all labour charges etc complete.(Abow Basement) |
| 8 | Supplying and erecting centering for sides and soffits of RCC slabs of plane surface like lintels, beams etc., including strutting 3m high using mild steel sheets of size 90cm x60cm x and B.G 10 stiffened with M.S angles of size 25mm x 25mm x \"3mm laid over silver Oak (C.W) joists of size 10cm x 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification. (Below Basement) |
| 9 | Supplying and erecting centering for sides and soffits of RCC slabs of plane surface like lintels, beams etc., including strutting 3m high using mild steel sheets of size 90cm x60cm x and B.G 10 stiffened with M.S angles of size 25mm x 25mm x \"3mm laid over silver Oak (C.W) joists of size 10cm x 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification. (Above Basement) |
| 10 | Suppling, fabricating and placing in position of MS(or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost ofsteel and binding wire also in all floors as per standard specification. |
| 11 | Reinforced Cement concrete 1:1.5:3 (one cement, one and halfsand &three course aggregate) using 20mm gauge hand broken/ Hard granite blue stone for all RCCitemsof works excluding centering shuttering and cost of reinforcement but including curing etc.,complete as directed by departmentalofficer etc., complete. |
| 12 | Providing granolithic floor finish of 25mm thick with plain cement concrete 1:2:4 (One Cement, Two sand and Four aggregate) using 10 to 12mm Hard broken stone jelly including laying, finishing and the top rubbed smooth with power trowel, thread lining, curing etc. complete complying with standard specification and as directed by the departmental officers. (The rate is inclusive of necessary planking for panellingwherever necessary and as directed by the departmental officers) |
| 13 | Paving the Floor with Vitrified tiles in CM 1:3 20mm thick includingcost and conveyance of all materials to site and all labour charges etc complete |
| 14 | Paving the floor with design scratch proof ceramic tiles (colour and shade as directed) of size 305mm x 305mm x 6 mm in all floors over a base layer of cement mortar 1:3 (one cement and three sand ) 20mm thick laid in-situ and pointed with same coloured cement etc, complete as per standard specification. |
| 15 | Dadooing walls withGlazed tiles of sizes 300mm x 200mm x 6mm size of approved make, quality and colourset in cement mortar 1:2 (one cement ,two sand) over 10 mm base layer plastering and pointing with white cement neatly as directed etc., complete as per standard specification |
| 16 | Weathering course with brick jelly lime concrete using 20mm brick jelly with of 32:12.5 including cost and conveyance of all materials to site and all labour charges for mixing , laying ,and finishing etc complete and finshed with one course of pressed tiles of size 23x23x2cm with cement mortar 1:3 mix and pointed with the same oiled mortar including cost and conveyance of all materials to site and all labour charges etc complete for 10 Sqm |
| 17 | Finishing the top of the roof with one course of Machine PressedTiles of size 23x23x2 cm of approved quality laid in CEMENT MORTAR 1:3(One cement and three sand) 12 mm thick mixed with water proofing compound conforming to ISS by 2% weight of cement used and the joint pointed neatly to full depth of tiles with the same water proofing compound mixed with cement mortar,red oxide, etc., complete complying with standard specification |
| 18 | Plastering surfaces of RCC itemssuch as slabs, beams, sunshades with cement mortar 1:3 mix using 10mm thick including packing, providing cement mortar beading for sunshades staircase ,steps, lands slabs etc.,as directed by departmental officers etc, complete complying with standard specifications. |
| 19 | Plastering with cm 1:5 mix (one cement and five sand) to 12 mm thick including cost and conveyance of all materials in all floors etc.,as directed by departmental officers etc, complete complying with standard specifications. |
| 20 | White washing two coats using shell lime inculding cost and conveyance of all materials to site and all labour charges etccomplete |
| 21 | Supplying and painting the walls with two coats of oil bound distemper over one coat of water based cement primer including cost for distember, primer, cleaning and scrapping the walls, rendering the wallssmooth with necessary putty, brushes, scaffolding arrangements, labour charges, etc., as per standard specification.(The colour and shade of the distemper shall be got approved by the Executive Engineer before use of work). For INNER WALL and Ceiling. |
| 22 | Exterior Emulsion Paint of First qualityof approved colourover aPrimingCoat including thorough scrapping, clean removal of dirt and including necessary plaster of paris putty wherever required etc, complete complying with standardspecification |
| 23 | Fabrication and supply of mild Steel Doors, Windows, Ventilator & Jolly of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 |
| 24 | Steel door ( 1.10 x 2.10 m ) |
| 25 | Fabrication and supply of mild Steel Doors, Windows, Ventilator & Jolly of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 |
| 26 | Steel window (1.20 x 1.30m) |
| 27 | Fabrication and supply of mild Steel Doors, Windows, Ventilator & Jolly of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 |
| 28 | Steel window (1.50 x 1.30m) |
| 29 | Supplying and Erecting Pull and Push Type Rolling Shutter with ISI make of approved size and section using 18 GI sheet. The shutter shall be painted with one coat of red oxide primer and the rate is inclusive of hood covers, transportation charges etc (Manually operated) Upto 8 Sqm - SOR page 50 - 129 / A / a |
| 30 | Solid PVC door shutter using 19 gauge 19mm sq.tubes for styles and outer frames, 15mm MS sq tubes for top lock and bottom rails. The sheet tubes shall be covered with 5mm thick and solid PVC sheets including all charges etc., complete. |
| 31 | Fabrication and supply of steel grill gate using structural steel in all aspects as dirercted |
| 32 | Painting two coats over new iron works using ready mixed enamel paint inculding cost and conveyance of materials and all labour charges etc.,complete |
| 33 | Wiring with 2 x 1.5 sq.mm. (22/0.3) PVC insulated SC unsheathed copper conductor of 1100V grade insuitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A FT switch with painting of suitable colour for open PVC light point / fan point (for electronic regulator) (5 points per coil) (SD 18) |
| 34 | Wiring with 2 x 1.5 sq.mm. (22/0.3) PVC insulated SC unsheathed copper conductor of 1100V grade insuitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mm TW switch box with 3mm thick hylem sheet cover for 5A 3pin non interlocking wall socket with 5A flush type switch with continuous earth wireconnection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed PVC plug point (SD 38) |
| 35 | Supply and fixing of TNEB meter board suitable for 32A single phase service connection with 32A fuse unit (500V) 32A neutral link and earth link (1\" x 1/8\" copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1\" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit (SD 125) |
| 36 | Supply and fixing of 1200 mm ( 48\") AC ceiling fan complete with stepped electronic 300 W regulator with 300 mmdown rod on the existing clamp. (SD 110) |
| 37 | Supply and run of 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated SC unsheathed copper conductor of 1100 V grade in 25 mm dia GI pipe ( Class\"B\" ) suitably bent at both ends with necessary angle iron upright and end supports for mains (SD 69) |
| 38 | Supply and fixing ofWT bulk head fitting with guard ( Philips / Bajaj / Crompton / K Lite ) suitable for suitable for 11W CFL lamp with CFL (SD 83) |
| 39 | Supply and fixing of single box type 4\"40W fluorescent fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed copper leads from terminals to the fitting (SD 88) |
| 40 | Supply and fixing of 16 Amps DPIC Switch of 500 V with fuse and neutral (Side Handle) on suitable TW box PWD Earthing (SD 142) |
| 41 | Providing and fixing of PVC rain water down fall pipe 110mm dia with necessary T WClamps, Plug, Shoes, bend, Screws, nails etc., complete |
| 42 | PVC sintex tank including all charges etc., complete |
| 43 | Supplying and fixing in position White Glazed European Water Closet of best quality and approved make with 100mm \"P\" os \"S\"\" trap with Double flapped rigit P.V.C. seat cover with C.P. brass hinges with 12.5 litres PVC Low Level Flushing Tank with all internal fittings and labour charges, inclusive of fixing lowlevel flushing tank and including giving necessary connection to cast iron soil pipes/ PVC pipes by dismandling brick masonry, reinforced cement concrete roof/floor slab and making good the disturbed portion to original condition without leakage etc., complete complying with standard specifications and as directed by the departmental officers. |
| 44 | Supplying and fixing in position Indian water closet of size 580 X 440mm, white glazed earthen ware of approved quality with \"P\" trap or \"S\" trap confirming to IS:2556 -Part XII with sand cushion and forming flooring alround the closet using 40mm broken brick jelly in lime concrete1:2:5 ( one part of lime, two parts of sand and five parts of brick jelly) 100mm thick and finishing the top to required slope and including giving necessary connection to cast iron soil pipes/ PVC pipes by dismandling brick masonry, reinforced cement concrete roof/floor slab and making good the disturbed portion to original condition without leakage etc., complete complying with standard specifications and as directed by the departmental officers. |
| 45 | Supply and fixing of RCC rings with lids. |
| 46 | 900mm dia rings |
| 47 | 900mm dia lids |
| 48 | GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column \"BB\" for all works in this package} |
AI Tender Summary
Tender Timeline
Oct 01, 2022
11:30 IST
Tender Published
Tender notice published.
CompletedOct 10, 2022
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedOct 11, 2022
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender