|
| 1 | Demolishingdry brick work manually /by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge |
| 2 | Removing mortar from bricks and cleaned bricks including stacking within a lead of 50 m (stacks of cleaned bricks shallbe measured). |
| 3 | Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. |
| 4 | Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m. |
| 5 | Providing and laying 50mm thick damp- proof course with cement concrete 1 :2:4 (1 cement : 2 coarse sand (zone-Ill): 4 graded stone aggregate 12.5mm nominal size) |
| 6 | Providing and laying in position machine batched and machine mixed design mix M- 25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer-in- charge. |
| 7 | Providing and laying in position machine batched and machine mixed design mix M- 25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve work ability without impairing strength and durability as per direction of Engineer-in- charge. |
| 8 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shutting -All work below plinthlevel andup to floor IV level |
| 9 | Centering and shuttering including strutting, propping etc. and removal of form work for Foundations, footings, bases for columns etc.for mass concrete. |
| 10 | Centering and shuttering including strutting, propping etc. and removal of form work for Suspended floors,roofs,landing and balconies and accessplatform |
| 11 | Centering and shuttering including strutting, propping etc. and removal of form work for Columns, piers, abutments, pillars, posts and struts. |
| 12 | Lintels, beams, plinth beams, girders, bressumers and cantilever |
| 13 | Steel reinforcement TMT Fe-500D or more for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect below plinth level & above plinth level |
| 14 | Brick work with common burnt clay non- modular bricks of class designation 7.5 in foundation and plinth in cement mortar 1:6 |
| 15 | 15 mm cement plaster on the rough side of single or half brick wall of mix 1 :4 (1 cement: 4 fine sand) |
| 16 | 12 mm cement plaster of mix 1 :4 (1 cement:4 fine sand |
| 17 | Finishing walls with Acrylic Smooth exterior paint of required shade : New work (Two or more coat applied @ 1.67 litre/10 and including priming coat of exterior primer applied @ 2.20kg/10 sqm) |
| 18 | Providing and applying two coats white cement based putty of approved brand and manufacturer, over plastered surface and grinding the surface smooth with sand paper to get en even and smooth finish including cost and carriage of all material , labour charges, scaffolding, sundries etc. complete |
| 19 | Providing and laying vitrified floor tile in different sizes (thickness to be specified by the manufacturer with water absorption less than 0.08% and conforming to IS:15622, of approved make,in all colours and shades,Laidon 20 mm thickness cement mortar 1:4 (1 cement : 4 coarse sand ), joining with grey cement slurry @3.3 Kg/sqm including grouting the joints with white cement and matching pigments etc. complete. |
| 20 | DemolishingR.C.C work by mechanical means and stockpiling at designated locations and disposal of dismantled material up to a lead of 01 kilometre,stackingserviceable and unserviceable materialseparatelyincluding cuttingreinforcement bars. |
| 21 | Providing and laying Polished Granite stone flooring in required design and pattern , in linearas well as curvilinear portions of the building all complete as per the architectural drawing with 18 mm thick stone slab over 20 mm(average ) thick base of cement mortar 1:4 (1 cement :4 coarse sand laid and joined with cement slurry andpointingwith while cement slurry admixed with pigment of matching shade including rubbing ,curing and polishing etc.all complete asspecified and as directed by the Engineer -in - Charge . |
| 22 | 10 cm thick(average) mud phaska of damped brick earth on roofs laid to slope consolidation and plastered with 25 mm thick mud mortor mixed with bhusa @35 kg per cum of earth and gobrileaping with mix1.1(clay :1 cow dung) and covered with flat tile bricks ,grouted with cementmortar 1:3( 1 cement : 3 fine sand) mixed with 2% of integral water proofing compound by weight of cement and finishing neat: With common burnt clay non modular brick tile of class designation 10 |
| 23 | Providing and fixing premium/superior white vitreous chinaware pedestal type water closet (European type) with seat and lid, 10 litre low level white vitreous chinaware flushing cistern & C.P. flush bend with fittings & C.I. brackets, 40 mm flush bend, overflow arrangement with specials of standard make and mosquito proof coupling of approved municipal design complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required.(Make- Jaquar/American Standard/Cera/Hindware/Parryware/Other Reputed brands.) or as approved by Engineer-in-Charge. |
| 24 | Providing and fixing 8 mm dia C.P. S.S. Jet with flexible tube up to 1 metrelong with S.S. triangular plate to European type W.C. of quality and make as approved by Engineer - in - charge. |
| 25 | Providing and fixing White vitreous chinawareflat back or wall cornertype lipped fronturinal basin of 430* 260*350* mm or 340*410* 265 mm sizes mm sizesrespectively |
| 26 | Providing and fixing partitions for different type of urinals. |
| 27 | Providing and fixing C.P. brass long body bib cock of approved quality conforming to IS standards and weighing not less than 690 gms. (Make- Reputed Brands |
| 28 | Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810 gms. (Make- Reputed Brands) |
| 29 | Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 |
| 30 | Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, i/c fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and testing of joints complete as per direction of Engineer in Charge. |
| 31 | Providing and placing on terrace (at all floor levels) polyethylene water storage tank, IS: 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank |
| 32 | Providing and fixing of PVC heavy duty & ISI marked pipe. Make- Finolex/Apollo/Supreme/D-plast/Astral100 mm Dia |
| 33 | Providing and fixing wash basin withC.I Brackets,15 mm CP brass pillartaps,32mm C.Pbrass wasteof standard pattern ,including paintingpainting offitting and brackets ,cutting and making good the wallswherever required |
| 34 | Providingand Fixing white vitreous chinaware pedestalfor wash basin completely recessedat the back for the receptionof pipe and fitting |
