|
| 1 | PART- A :Gas Burner. Arrangement of all safety equipment\"s for the protection of staff i.e. masks, ladder, oxygen cylinder, helmet, gumboot, torch etc. and other necessary equipment required for the protection of staff working in Gases zone. |
| 2 | Dismantling of existing gas burner by dismantling of old rusted/burnout T, pipe fitting, valve, burners, Handi etc. closing of valve to stop the Gas at Burner point. |
| 3 | Replacement of 02 Nos. burn out CI T-section of size approx. (19.5 inch X 12 inch, 8mm thick) i/c03 Nos. Flange of each T-section of size 150mm dia 10mm thick as per the site requirement/existing structure with the help of all labour like helper, beldar, fitter, supervisor and along with T&P and transportation of complete arrangement at site of work and as per the direction of engineer in-charge. |
| 4 | Supply of MS nut bolt with washers (sizing should be as per the site requirement. |
| 5 | Supply of rubber packing 3mm thick |
| 6 | Cleaning/servicing of 02 Nos. Handi& complete burners with the help of special workmanship tools etc as per the direction of engineer in-charge. |
| 7 | Cleaning/servicing of valves including their connecting lines (approx. 150mm dia) with the help of special workmanship tools etc as per the direction of engineer in-charge. |
| 8 | Painting of complete job as per the direction of engineer in-charge. |
| 9 | Testing & commissioning of the gas burner after repairing/ servicing as per the site requirement. |
| 10 | PART- B :Dip Trap. Dismantling the dip traps from the chamber after separate the drain line with the help of hydraulic crane/required tools & tackles etc. this work also include the fixing of MS dead flange as per site requirement. |
| 11 | Fabrication/Fixing of 01 No. New SS Dip trap sizing as per existing/actual,made out of 8 mm SS-304 sheet and support with the 03 Nos. SS-304 angle of size(5mm thick,50x50 mm) with one No. SS-304, 25 mm thick dead flange and 02 Nos. SS-304, 10mm thick Blank flange with SS Nut, Bolts & washer sizing as per actual site requirement, this work include men and material along with T&P and transportation of complete arranged at site of work & complete levelling as per the direction of engineer in-charge. |
| 12 | Repairing/Servicing/cleaning of existing Dip traps and fixing of repaired Dip traps with required hardware good and manpower/crane as per the site requirement/direction of engineer in-charge. |
| 13 | Supply of MS nut bolt with washers(sizing should be as per the site requirement. |
| 14 | Supply of rubber packing 3mm thick |
| 15 | Painting of complete all Job as per the direction of engineer in-charge. |
| 16 | Testing & commissioning of the all dip traps after completion of work as per the site requirement. |
