|
| 1 | Surface Dressing of the ground in any kind of soil including removing vegetation inequalities not exceeding 15 cm depth and disposal of the rubbish within a lead upto 75 m as directed. |
| 2 | Earth work in excavation of foundation trench in all sorts of soil (including mixed soil but excluding laterite of sand stone) including the spoils with in a lead of 75,m as directed. The includes necessary trimming the sides of trenches leveling dressing and ramming the bottom bailing out water as required complete.(a) Depth of excavation not exceeding 1.5m |
| 3 | Earth work in filling in foundation trenches or plinth with good earth,in layers not exceeding 150 mm. including watering & ramming etc. layer by layer complete. (Payment to be made on the basis of measurement of finished qty. of work ) With earth obtained from excavation of foundation |
| 4 | Vide Page No. 2 Item No. 4 (B) Filling in foundation or plinth by fine sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. (payment to be made on measurement of finished quantity)B) Do - by fine sand |
| 5 | Vide Page No. 11 Item No. 1Single Brick flat soling of picked jhama brickincluding raming and dressing bed to properlevel and filling joints with powdered earthor local sand. |
| 6 | Vide Page No. 12 Item No. 5Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. |
| 7 | Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (upto roof of ground floor)(c) Steel shuttering or 9 to 12 mm thick approved quality ply board shuttering in any concrete work,Footing, Column, Tie beam, Linte Beam, Goof Slab, For ramp |
| 8 | Vide Page No. 15 Item No. 7Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes.Footing,Column,Tie beam,Lintel Beam,Roof Slab |
| 9 | Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction.(a) For works in foundation, basement and upto roof of ground floor/upto 4 m(i) Tor steel/Mild Steel(JSW/JSPL/SHYAM/SRMB/BMASL/ELECTROSTEEL) |
| 10 | Brick work with 1st class bricks in cement mortar (1:6),In superstructure, ground floor,For 250 th,Deduction for R.S.Deduction for netting (Front) |
| 11 | 125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in ground floor.For 125 th,Drain |
| 12 | Labour for Chipping of concrete surface before taking up Plastering work.Ceiling |
| 13 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface]20 mm thick out side plaster (with 1:4 cement morter)Outer WallsDrain,Deduction for Ramp,Deduction for R.S.Deduction for netting (Front),Ramp Sides |
| 14 | 10 mm thick inside plaster (with 1:4 cement morter), Ceiling |
| 15 | 15 mm thick inside plaster (with 1:4 cement morter),Inner Walls, |
| 16 | Ordinary Cement concrete (mix 1:2:4) with graded stone chips (6mm nominalsize) excluding shuttering and reinforcement,if any, in gound floor as perrelevant IS codes. |
| 17 | (a) Applying 2 coats of bonding agent with synthetic multi functional rubber |
| 18 | emulsion having adhesive and water proofing properties by mixing with water,in proportion (1 bonding agent : 4 water : 6 cement) as per Manufacturer\"s,specification [Cement to be supplied by the Department],Side surface of Ramp |
| 19 | 18 mm. to 22 mm. thick, kota stone slab set in 20 mm thick (avg) cement mortar (1:4) in floor, stair & lobby including pointing in cement slurry with admixture of pigment matching the stone shade, including grinding & polishing as per direction of Engineer - in - charge to match with the existing work. [Slurry for bedding @ 4.4 kg/Sq.m andpointing @2.0 kg/Sq.m] |
| 20 | Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.(B) WallWith Sand Cement Mortar (1:3) 15 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m.(a) Area of each tile upto 0.09 Sq.m(ii) Other than Coloured decorative including white |
| 21 | M.S. works in framed gratings of window etc.made of round or square bars and frame work or M.S. flats (with the bars securely fixed to the flat bar frame ) with or without intermediate flat bar stiffener and fixed with necessary screws etc. complete , as directed.In ground floor.ISA50X50X6 @ 4.50 kg./m,FLAT20X6 @ 0.95 kg./m |
| 22 | Vide Page No. 81 Item No. 16 (b) Supplying fitting and fixing steel rolling grills link type, shutter with 18 B.G .of approved type steel to the section 75mm wide, fitted with coil wire spring to necessiate the fitting of required Nos. of C.I. Pulleys on heavy type solid drawn seamless steel tube complete with locking arrangements both inside and outside specially builtup side guide channels including providing a hood for the steel rolling shutter in the room, painting two coats of approved aluminium paint over a coat of red lead primer complete. |
| 23 | Square or hexagonal mesh netting made with 18 B.W.G. galvanised wire, fittedand fixed complete as per design (excluding the supporting framework butincluding local sal wood battens of size 37.5mmx25mm).In ground floor. (b)25 mm mesh |
| 24 | Applying decorative cement based paint of approved quality after preparing the surface including scraping the same thoroughly (plastered or concrete surface) as per manufacturer\"s specification.In Ground floor:(iii) Two coats.Outer Walls,Deduction for Neat cement punning,Inner Walls,Deduction for netting (Front) |
| 25 | Priming one coat on timber or plaster surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand paering etc.Outside over neat cement punning area, Side surface of Ramp |
| 26 | Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.Netting (Front),Rolling Shutter,Gretting over internal drain |
| 27 | Painting with best quality synthetic enamael paint of approved make and brand including smoothening surface by sand paering etc. including using of approved putty etc. on the surface if necessary On steel or other metal surface :With super gloss (hi-gloss)-Two Coats ( With any shade except white ),Outer Walls |
| 28 | Supplying, fitting and fixing PVC pipes of approved makeof (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz.socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting will be made seperately)(a) (b) For Concealed WorkPVC Pipes (Dia),15 mm, Walls |
| 29 | 25 mm, Walls |
| 30 | 40 mm, Walls |
| 31 | Supplying, fitting & fixing UPVC pipes A- Type and fittings conforming toIS:13592-1992 with all necessary clamps nails, including making holes inwalls, floor etc. cutting trenches in any soil through masonry concretestructures etc if necessary and mending good damages including joining withjointing materails (Spun Yarn, Valamoid/Bitumen/M-Seal etc) complete. A) UPVC PIPE< i 110 mm Dia. |
| 32 | B) UPVC Fittings,ii) 110 mm. Dia. |
| 33 | b) Plain Y,ii) 110 mm. Dia. |
| 34 | c) Bend 87.5 degree,ii) 110 mm. Dia. |
| 35 | d) Shoe,ii) 110 mm. Dia. |
| 36 | Supplying P.V.C. water storage tank of approved quality with closed topwith lid (Black) - Multilayer(a) 500 litre capacity |
| 37 | Supplying, fitting and fixing pillar cock of approved make.Polythene Piller Cock (EMCO / ATLAS or equivalent)(i) 15 mm,internal area |
| 38 | GST |
| 39 | Labour Welfare Charge@1% |
