|
| 1 | Complete dismantling of L & T make feeder breaker no. 17 with secondary crushing unit and operator cabin etc. |
| 2 | Structural steel work riveted, bolted, or welded in built up sections, trusses and framed work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete (Labour rate). |
| 3 | Installation, commissioning, and trial run of complete feeder breaker along with secondary crusher. |
| 4 | Installation of conveyor structure including levelling, centering etc. (top rollers, brackets, motor, gear box, conveyor pulleys etc.) |
| 5 | Painting of Structural steel work with 3 coats including one coat of primer of red oxide or equivalent primer paint of approved brand & two coat enamel paint approved brand of required shade directed by Engr I/c. |
| 6 | Excavation for foundation in soft soil including dressing of sides and ramming of bottom lift up to 1.5 mtr including getting out the excavated soil and disposal of surplus excavated soil as directed within lead of 50 mtr. All kind of soil. |
| 7 | Providing and laying in position cement concrete 1:3:6 (1 cement: 3 coarse sand: 6 graded stone aggregate 40mm nominal size) |
| 8 | Providing and laying in position reinforced cement concrete 1:2:4 (1 cement:2 coarse sand:4 graded stone aggregate 20mm nominal size) (excluding reinforcement) |
| 9 | Providing of mild steel round bar for reinforcement |
| 10 | Fixing of corrugated G.S. sheet roofing including vertical/curved surface fixed with polymer coated “J” or ‘L” hooks, bolts and nuts 8mm diameter with bitumen and GI limpet washer or with GI limpet washers fitted with white lead and including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/vertical or curved surfaces) excluding the cost of purlins, rafters & trusses and including cutting to size and shape wherever required (0.63 mm thick with zinc coating not less than 275 gram/m^2) with material. |
| 11 | Installation and commissioning of G.I. pipe complete with G.I. fitting and clamps including cutting and making good the walls (40mm dia nominal bore) |
| 12 | Fixing and gun metal gate valve with C.I. wheel of approved quality (screwed end) (40 mm nominal bore) with material |
| 13 | Installation and commissioning of G.I. pipe complete with G.I. fitting and clamps including cutting and making good the walls (25mm dia nominal bore) |
| 14 | Fixing of spray nozzles solid cone discharging 25 LPM, 4kg/m^2and made out of SS304BSP thread with material |
| 15 | Fixing and gun metal gate valve with C.I. wheel of approved quality (screwed end) (25 mm nominal bore) with material |
| 16 | Cleaning of fallen coal/dust/muck etc in the existing structures & surroundings |
| 17 | Fixing and installation of control panel Part no. BD-400FS, vide part no. BD-400-FS-1000 |
| 18 | Providing and fixing of weather proof electrical flap gate actuator, non-integral starter suitable for ON/OFF duty, thrust 1500kg, stroke 400mm, linear speed, 30mm per sec, operating time: 20.83 sec. |
| 19 | Total impact of GST for the purpose of CTC |
