|
| 1 | Supply , Transportation and errection of 9MTR long ST Poles (410 SP-33) completely errected in the pit of 1/5th of the pole length including excavation and back filling of the pole pit. (as per REC Standard) |
| 2 | Supply, Transportation and errection of 8MTR long ST Poles (410-SP 15) completely erected in the pit of 1/5th of the pole length including excavation and back filling of the pole pit . (as per REC standard) |
| 3 | Supply,Carraige upto site,, laying ,stringing, tensioning , binding of ACSR Conductor, (50mm2 ACSR Conductor) as per REC standard. |
| 4 | Supply,Carraige upto site,, laying ,stringing, tensioning , binding of ACSR Conductor, (30mm2 ACSR Conductor) as per REC standard. |
| 5 | Supply, transportation and fixing of GI Channel /Angle Iron for Cross Arms, Braces, Transformer Belt, F-Top, Collers etc for Sub Station and poles (Complete Job including Nuts & Bolts and Washers) |
| 6 | Supply and fixing of 11kV Polymeric composite Pin Insulator 12kV, 5kN, Lighting Impulse 75kV Positive and 80kV Negative, creepage distance 320mm |
| 7 | Supply and fixing of LT Shackle Insulators with G.I Mukhi Clamps (Scaffolding G.I LT Clamps) including nuts and bolts as per REC standard |
| 8 | Earthing ofHT/LT PolesComplete by GI Pipe 40 mm 3mtr long through GI Strip 25x3 mm |
| 9 | Supply, Carriage up to site, Installation, testing and Commissioning of danger Plates |
| 10 | Supply, Carriage up to site, Installation, testing and Commissioning of anti-climbing devices with clamps |
| 11 | Cement bottoming of S.T poles in 1:2:4 mix1/6th of the height ofpole below the ground and 1ft above the ground cylnerical shapewith circularradius 9” from the pole centre) using 40mm crushed stone aggregate mix. As per Drawing 0.5 cum/polePit =( 600x600x1600)& Tappered at the Top. (as per REC standard) for 9 MTR ST Pole |
| 12 | Cement bottoming of S.T poles in 1:2:4 mix1/6th of the height ofpole below the ground and 1ft above the ground cylnerical shapewith circularradius9” from the pole centre) using 40mm crushed stone aggregate mix. As per Drawing 0.45 cum/pole (Pit 600x600x1433.3 mm) for 8 MTR ST Pole |
| 13 | Painting of ST Poles with one coat of red oxide and two coats of aluminum paint to give an even shade using anti corrosive paint of standard brand (Nerolac/ Asian) paints) including cost of paint. |
| 14 | Pre, during and post geo tagged photographic evidence consisting of 5x7 inch photographs in coffee table book (covering each pole/Sub Station) |
