Stock Storage Under Jsv Sub Division Mandap In Tehsil Dharampur District Mandi Hp Construction Of Store Room And Chowkidar Room
Tender Value
8.05 Lakhs
Estimated cost
Bid Submission
25 Apr 2022
0 days left
EMD
16120
Bank guarantee accepted
Document Fee
250
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
mandap → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Stock Storage Under Jsv Sub Division Mandap In Tehsil Dharampur District Mandi Hp Construction Of Store Room And Chowkidar Room
BOQ
| Sl. No. | Item Description |
| 1 | Excavtion in foundation, trenches etc. in all kinds of soil such as pick work jumper work, blasting work in soft/hard rock, chiselling in soft/hard rock including wedging out upto all lift, stacking the excavated soil upto all lead clear from the edge of excavation and then returning the stacked soil in 15cm layers when requaired into plinths, sides offoundation etc. consolidating each deposited layer by ramming and watering and thendisposing of all surplus excavated earth as per direction and to the entire satisfaction of Engineer-in-Charge upto all lead and lifts. |
| 2 | Providing and laying cement concrete 1:5:10 (1 cement :5 sand : 10 graded stone aggregate 40mm nominal size) with 15% Plum and curing complete excluding cost of form work in retainin walls/breast walls, the size of plums shall usually by 150mm to 300mm as per HPPWD specification as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 3 | Providing and laying cement concrete 1:1.5:3 (1cement :1.5 sand :3 graded stone aggregate 20mm. nominal size) and curing complete excluding cost of form work and reinforcement for feinforced concrete work in: |
| 4 | Foundation footings bases of columns and the like and mass concrete. as per the direction and to the entire satisfaction of Engineer-in-charge upto all lead and lift. |
| 5 | Suspended floors roofs, landings and shelves and their supports, balconies, beams, girders, bressumers and cantilevers upto floor two level. as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 6 | Column, pillar, posts and struts upto floor two level as per direction and to the entire satisfaction of Engineer-in-charge upto all lead and lifts. |
| 7 | Lintels,beams, girders, bressumers and cantilevers upto floor two level within all lead and lifts as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 8 | Brick work using common burnt clay 2nd class building bricks in super structureabove plinth level upto floor two level in cement mortar 1:4 (1 cement :4 sand) including curing complete as per direction and to the entire satisfaction of Engineer-in-charge |
| 9 | Half brick masonry in common burnt clay 2nd class building bricks in superstructure above plinth level upto floor two level in cement mortar1:4 (1 cement :4 sand) as per direction and to the entire satisfaction of Engineer-in-Charge upto all lead and lifts. |
| 10 | Providing wood work in frames of doors,windows,clerestory,windows and otherframes wrought,framed and fixed in position complete 2nd class Deodar wood as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 11 | Providing and fixing panelled glazed or panelled and glazed shutters for doors windows and clerestory windows. Including black enamelled iron butt hinges with necessary screws 40mm thick using 2nd class Deodar wood as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 12 | Providing and fixing wire guage shutters using galvanised M.S. wire guage of I.S. guage destination 85 G with wire of dia 0.56 mm for with necessary screws 40 mm thick 2nd class Deodar wood doors, windows and clerestory windows including bright finished black enamelled iron hinges. |
| 13 | Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm, so as to give a fair finish including centring, shuttering , strutting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4 meters and removal of the samefor insitu reinforced concrete and plain. |
| 14 | Vertical surfacessuch as wall (any thickness) partitions and the like including attached pillasters, buttresses plinth and string courses and the like in all leads and lifts as per direction and to the entire satisfaction of Engineer-in-charge. |
| 15 | Flat surfaces such as soffits of suspended floors, roofs, landings and the like floors upto 200mm kin thickness. as per the direction and to the entire satisfaction of Engineer-in-charge upto all lead and lift. |
| 16 | Edges of slabs and Breaks in floors and walls.Under 20 cm. Wide as per the direction and to the entire satisfaction of Engineer-in-charge. |
| 17 | 20mm Cement plaster in single coat on rough side of brick/stone masonry for interior plastering upto floor two level including arrises,internal rounded angles,chamfers and/or rounded angles not exceeding 80mm in girth and finished even and smooth.in cement mortar 1:6(1 cement:6 sand) as per the direction and to the entire satisfaction of Engineer-in-charge. |
| 18 | 15mm cement plaster in single coat on fair side of brick/concrete/stone walls for interior plastering upto floor two level including arrises, internal rounded angles, chamfers and/or rounded angles not exceeding 80mm in girth and finished even and smooth Cement mortar(1:6) (1 cement:6 sand) as per direction and to the entire satisfactionof Engineer-in-charge upto all lead and lifts. |
| 19 | 6mm thick cement plaster to ceiling in Cement Mortar 1:3 (1 cement: 3 sand) as per the direction and to the entire satisfaction of Engineer-in-charge. |
| 20 | Providing, Laying of Tor steel reinforcement for RCC work including bending binding and placing in position including wire upto all floor level as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 21 | Applying two coats of wood preservative on new wood and wood based surface after and including preparing the surface by thoroughly cleaning oil, grease, dirt and other foreign matter with ready mixed paint other than white as per direction and to the entire satisfaciton of Engineer-in-charge upto all lead and lifts. |
| 22 | Applying priming coat over new wood and wood based surface after and I/c preparing the surface by thoroughly cleaning oil, grease,dirt and other foreign matter with ready mixed paint other than white as per the direction and to the entire satisfaction of Engineer-in-charge . |
| 23 | Painting two coat (excluding Priming coat )on new wood and wood basedsurface with ready mixed paint brushing to give an even shade I/c cleaning of all dirt dust and other foreign matter, sand papering and stopping with while enamel paint as per direction and to the entire satisfaciton of Engineer-in-charge . |
| 24 | Painting one coat (excluding Priming coat ) on concrete/masonry/asbestos/stone/plastered wall surfaces wiith ready mix paint to give an even shade including thoroughly brushing the surface free from mortar drops, dust, loose material & other foreign matter and sand prepared smooth including applying of putty a required for metling the surface as per direction and to the entire satisfaciton ofEngineer-in-charge upto all lead and lift. |
| 25 | Finishing wallwith water proofing cement paint of approved brand and manufacture and of required shade on decorated wall surfaces (two coats) to give an even shade after thoroughly brushing the surface to remove all dirt and remains of loose powdered materials in all respect as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 26 | Providing 40 x 3 mm flat iron hold fast 40 cm long including fixing to frame with 10 mm dia meters bolts and nuts and wooden plug and embending in cement concrete block 30 x 10 x 15 cm (1:3:6) (1: Cement, 3: Sand, 6: Grade stone agg. 20 mm nominal size)as per direction and to the entire satisfaciton ofEngineer-in-charge upto all lead and lift. |
| 27 | Stone/boulder filling under floor/behind retaining walls complete within all lead and lifts as per direction and to the entire satisfaction of Engineer-in-Charge. |
| 28 | Supplying and fixing rolling shutters of approved make made of 80 mm X 1.25mm M.S laths interlocked together through their entire length and joined together at the end by end locks mounted on specially designed pipe shaft,with brackets side guides and arrangements for inside and outside locking with push pull operation complete but excluding the cost of the top cover and spring shutter having below 3.5 mtrsas per direction and to the entire satisfaction of Engineer-in-Charge. |
| 29 | Cement concrets flooring 1:2:4 (1 cement :2 sand :4 graded stone aggregate 20mm nominal size) laid in one layer finished with a floating coat of neat cement (40 mmthick) as per direction and to the entire satisfaciton ofEngineer-in-charge upto all lead and lift. |
| 30 | Providing and fixing in position collapsible steel shutters with vertical channels 20mmx10mmx 2mm and braced with flat iron diagonals 20mmx5mm size with top and bottom rail of T-iron 40mmx40mmx6mm with 38mm dia steel pulley complete with bolts and nuts locking arrangements, stoppers, handles including applying a priming coat of red lead paint. |
| 31 | Water purifier with container 25 Liters capacity (Aquaguard Model MAGNA HD RO+UV) as per direction and to the entire satisfaciton ofEngineer-in-charge upto all lead and lift. |
AI Tender Summary
Tender Timeline
Apr 18, 2022
11:30 IST
Tender Published
Tender notice published.
CompletedApr 25, 2022
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedApr 25, 2022
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender