Law and Justice Local Bodies Closing in 0 days TDR #31307930

Conversion Of Sub-Center To Su-Sasthya Kendra ( Hwc ) At Bakharpur Sub- Center Under Kaliachak-I Dev. Block, Malda

Issued by Local Bodies · kaliachak, West Bengal
Tender Value
2.86 Lakhs
Estimated cost
Bid Submission
09 Mar 2022
0 days left
EMD
5800
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
kaliachak → West Bengal
EMD Exemption
Not Available
Quantity
Not Available

Project Description

Conversion Of Sub-Center To Su-Sasthya Kendra ( Hwc ) At Bakharpur Sub- Center Under Kaliachak-I Dev. Block, Malda

BOQ

Name of Work: Conversion of Sub-Center to Su-Sasthya Kendra (HWC) at Bakharpur Sub-Center, under Kaliachak-I Dev. Block, Malda. (XV-Finance)
Sl. No. Item Description
1ORIGINAL WORKS
2Stripping off worn out plaster and raking out joints of walls, celings etc. upto any height and inany floor including removing rubbish within alead of 75m as directed.
3125 mm thick brick work with 1st class bricks in cement morter (4:1)
4Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course,scaffolding /staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface]i) With 6:1 cement Plaster. b) 20 mm thick plaster.
5Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course,scaffolding /staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface]i) With 6:1 cement Plaster. c) 15 mm thick plaster.
6Providing waterproofing treatment over concrete roof surface (old or new) by the application of two coats of slurry prepared with latex of approved brand, water and cement in the proportion of (LP.W. Cement - 1:4:6) by volume, with brush in a time gap of minimum 4(four) hours to 14(fourteen) hours between the two layers, laying 20mm thick and sand and cement consolidated plaster (1:4) admixed with Plastocrete Super of approved brand 0.2% by weight of cement, laying flat 1st class Brick Bats/ Bricks over the mortar keeping a gap of 10-20 mm between two bats, filling the vertical joints with the aforesaid mortar, providing a second layer of 20 mm thick sand and cement plaster (1:4) admixed with Plastocrete Super as above over the bricklayer, the top surface of the treatment should be chequered to provide the antistrip property(a) By Bricks (cement 25.66 kg/ Sq.m)
7Supplying best Indian sheet glass panes set in putty (as per I.S specification) and fitted and fixed with teak wood beads and nails complete. (In all floors for internal wall & upto 6 m height for external wall)(i) 3 mm thick (weighing 7.4 kg/Sq.m)
8Wood work in door and window frame fitted and fixed in position complete including a pretective coat of painting at the contact surface of the frame excluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals)
9Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings In ground floor.
10Supplying, fitting and fixing M.S. clamps for door and window frame made of flat bent bar, end bifurcated with necessary screws etc. by cement concrete(1:2:4) as per direction.40mm x 6mm 200mm length.
11Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark.(vii) 100mm x 58mm x 1.9 mm
12Iron hasp bolt of approved quality fitted and fixed complete (oxidised) with 16mm dia rod with centre bolt and round fitting. (b)250 mm long.
13Iron socket bolt of approved quality fitted and fixed complete.(c) 150mm long x 10mm dia bolt.
14Iron socket bolt of approved quality fitted and fixed complete.(b) 100mm long x 10 mm bolt.
15Anodised aliminium D-type handle of approved quality manufactured from extruded section conforming to I.S. specification (I.S. 230/72) fitted and fixed complete:(a) With continuous plate base (Hexagonal/ Round rod)(b) with round base.(ii) 100 mm grip x 10 mm dia rod.
16Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.
17Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.
18Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary :(ii) Two coats (white in shade)(a) On timber or plastered surface :With super gloss (hi-gloss) -
19Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary :(ii) Two coats (white in shade)On steel or other metal surface :With super gloss (hi-gloss) -
20Applying Exterior grade Acrylic primer of approved quality and brand on plastered or cencrete surface old or new surface to receive decorative textured (matt finish) or smooth finish acrylic exterior emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer\"s specification and as per direction of the EIC.In Ground Floor(b) Two coats.
21Protective and Decorative Acrylic exterior emulsion paint of approved quality, as per manufacturer\"s specification and as per direction of Engineer-in-Charge to be applied over acrylic primer as required. The rate includes cost of material, labour, scaffolding and all incidental charges but excluding the cost of primer In Ground floor (Two Coat).c) Super Protective 100% Acrylic Emulsion
22Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.With Sand Cement Mortar (1:3) 15 mm thick & 2 mm thickcement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m. (a) Area of each tile upto 0.09 Sq.m
23Earthwork in excavation in foundation trenches or drain in all sorts of soil (including mixed soil but excluding laterite or sandstone) including removing, spreading & stacking the spoil within a lead of 75m as directed. The item includes necessary trimming the sides of trenches. Levelling, dressing and ramming the bottom, bailing out of water as required complete.
24(I) Cement concrete (1:3:6) with graded stone ballast (40 mm size excluding shuttering) In ground floor(A) [Pakur Variety]
25Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. (Rajmahal Variety)
26Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction (upto roof of ground floor)(JSW/JSPL/SHYAM/SRMB/BMASL/ELECROSTEEL/SSL)
27(M) DRAIN, DOWN PIPES, CHIMNEY ETC
28Supplying, fitting and fixing G.I. pipes of TATA make with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads, fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paintin any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials.(a) For Exposed Work.(ii) 65 mm dia. medium quality
29Galvanised corrugated iron sheet work (excluding the supporting frame work) fitted and fixed with 10 mm. dia J or L hook-bolts, limpet and bitumen washers and putty complete with 150 mm. end lap and one corrugation minimum side lap. (Payment to be made on area of finished work)
30Supplying and laying true to line and level vitrified tiles of approved brand (size not less than 600 mm X 600 mm X 10 mm thick) in floor, skirting etc. set in 20 mm sand cement mortar (1:4) and 2 mm thick cement slurry back side of tiles using cement @ 2.91Kg./sqM or using polymerised adhesive (6 mm thick layer applied directly over finished artificial stone floor/Mosaic etc without any backing course) laid after application slurry using 1.75 Kg of cement per sqM below mortar only, joints grouted with admixture of white cement and colouring pigment to match with colour of tiles / epoxy grout materials of approved make as directed and removal of wax coating of top surface of tiles with warm water and polishing the tiles using soft and dry cloth upto mirror finish complete including the cost of materials, labour and all other incidental charges complete true to the manufacturer\"s specification and direction of Engineer-in-Charge.
31Supplying, fitting and fixing bib cock or stop cock.(b) (i) Chromium plated Stop Cock (Equivalent to Code No. 513(A) & 513(B) & Model - Tropical / Sumthing Special of ESSCO or similar.
32ELECTRIFICATION WORKS
33GOODS AND SERVICE TAX @ 12%
34LABOUR AND WELFARE CESS @ 1%

AI Tender Summary

OUR REF NO 31307930
AUTHORITY Local Bodies
TENDER VALUE 2.86 Lakhs
LAST DATE 09-03-2022
Authority
Authority Name District Magistrate
Work Description Conversion Of Sub-Center To Su-Sasthya Kendra ( Hwc ) At Bakharpur Sub- Center Under Kaliachak-I Dev. Block, Malda
Basic Detail
Tender No N.I.E.T No. BDO/KCK-I/NIET- 08 (e) of 2021-2022
Bidding Type Tender
Location
City kaliachak
State West Bengal
Key Dates
Publish Date 03 Mar 2022
Submission Date 09 Mar 2022
Open Date 11 Mar 2022
Finance
Tender Value 2.86 Lakhs
Tender Fee Ref. Documents
EMD 5800
Exemption Not Available
Document List
5318a664-83fc-4c2f-9e7d-37e5dd22ad8a.html
BOQ_716549.xls
Tendernotice_1.pdf
Tendernotice_2.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Mar 03, 2022
11:30 IST

Tender Published

Tender notice published.

Completed
Mar 09, 2022
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Completed
Mar 11, 2022

Bid Opening Date

Technical bids will be opened and evaluated.

Completed

Tender Documents

Download All (ZIP) ↓
html

5318a664-83fc-4c2f-9e7d-37e5dd22ad8a.html

xls

BOQ_716549.xls

pdf

Tendernotice_1.pdf

pdf

Tendernotice_2.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender

TenderDetail
Loading tenders