|
| 1 | Excavating supplying filling of local earth (including royalty) by mechanical transport upto a lead of 5 km also including ramming and watering of the earth in layers not exceeding 20 cm in trenches, plinth, side of funding etc. complete. All kinds of soil in area 425 sq. mt. |
| 2 | Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and confirming to IS 15622 of approved make in all colours and shades laid on 20 mm thick cement mortar 1:4 (1 cement : 4 coarse sand) including grouting the joints with white cement and matching pigments etc.complete. Size of Tile 600X600 mm |
| 3 | Chequerred precast cement concrete tiles 22 mm thick in footpath & courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc.complete, on 20mm thick bed of cement mortar 1:4 (1 cement : 4 coarse sand). Dark shade pigment using ordinary cement. |
| 4 | Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength , thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding laver through vibratory compaction by using plate vibrator filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand.Complete all as per direction of Engineer-in-Charge. 60 mm thick C.C paver block of M-35 grade with approved colour, design & pattern. |
| 5 | Steel work including, foundation, erection (2x2 inch) steel poles of thickness 2mm and framing with (1.5 x 1.5 inch) steel pipes of thickness 1.5mmin built up with tubular, round square or rectangular hollow tubes trusses etc.including cutting hosting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc complete. Hot finished welded type tubes. |
| 6 | Providing and fixing precoated galvanized iron profile sheet (size, shape and pitch of corrugation as approved by Staff-in-charge 0.50 mm (+0.05%). Total coated thickness with zinc coating 120 gm per Sqm as per IS:277 in 240 mpa steel grade.5-7 microns epoxy primer on both side of side sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 mt.or as desired by staff-in-charge.The steel shall be fixed using self drilling/self tapping screws of size (5.5x55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces in including the cast of purlins, rafters and trusses and including cutting to sixe and shape wherever required. |
| 7 | Providing and applying white cement based putty of average thickness 1mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. |
| 8 | Finishing walls with Acrylic smooth exterior paint of required shade. New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20Kg/10 sqm) |
| 9 | Wall painting with acrylic emulsion paint of approved brand and manufacturer to give and even shade.Two or more coat on new work. |
| 10 | Painting with synthetic enamel paint of approved brand and manufacturer to give an even shade. |
| 11 | 12 mm thick plastering of cement mortal 1:4(1 cement : 4 fine sand) at and around platform. |
| 12 | Half Brick masonry with common burnt clay F.P.S (non modular) bricks of class designation 7.5 in foundations and plinth in : Cement mortar1:4 (1 cement : 4 coarse sand) |
| 13 | Brick edging 7 cm wide 11.4 cm deep to plinth protection with common burnt clay F.P.S (non modular) bricks of class designation 7.5 including grouting with cement mortar 1:4 (1 cement: 4 fine sand) |
