Construction Of Interlocking Pavement And Other Work In Sarvajanik Dharmshala And Interlocking Pavement Near Chotu Khan House Ward No 09
Tender Value
5.77 Lakhs
Estimated cost
Bid Submission
08 Nov 2021
0 days left
EMD
11540
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Bhadra → Rajasthan
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Construction Of Interlocking Pavement And Other Work In Sarvajanik Dharmshala And Interlocking Pavement Near Chotu Khan House Ward No 09
BOQ
| Sl. No. | Item Description |
| 1 | Earth work in excavation for roadway, including trimming bottom and side slopes in accordance with requirement of line, grades and cross sections, including disposal of surplus material with all lift and lead upto 1000 metre as per MoRT&H specification clause 301. |
| 2 | Providing and laying lean cement concrete 1:4:8 in Sub- base over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 25 mm,aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in concrete mixer, laid manualy, compacted with surface vibrator, finishing and curing complete asper clause 601, 112 of MoRT&H specification including all material, labour, machinery, lighting, guarding and maintenance of diversion. |
| 3 | Brick work with FPS bricks of class designation 75 in foundationand plinth in:.Cement mortar 1:6 (1 cement : 6 coarse sand) |
| 4 | Providing and laying damp-proof course 50mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20mm nominal size). |
| 5 | Brick work with FPS bricks of class designation 75 in superstructure above plinth level upto two stories in all shapes and sizes in :Cement mortar 1:6 (1 cement : 6 coarse sand) |
| 6 | Cement plastering including T&P, scaffolding, material and complete labpour, including cost of water, curing, racking of joints etc. with 12mm cement plaster of mix :1:6 (1 cement : 6 fine/ coarse sand) |
| 7 | Finishing walls with water proofing cement paint of required shade New work (Two or more coats applied @ 3.84 kg/10 sqm). |
| 8 | Providing and fixing of precast concrete interlocking tiles of desired shape of M 30 grade manufactured from fully computerized automatic stationery hydraulic viebro pressed machine and fully computerized automatic batching plant of class A1/A2 as per BS 6717:2001. The CC interlocking paving blocks be laid on average 50mm. thick bed of coarse sand and the joint is to be filled with fine sand. Laying procedure on compacted sub-base as defined.Complete job is to be executed as per the instruction of Engineer incharge. The rates to be inclusive of all lead & Lifts etc. complete as per specifications. Tensile splitting strength, abrasion and braking load etc. as per BS 6717:2001, Grey cement. 80mm thick |
| 9 | Earth work in excavation in foundation, trenches etc. including dressing of sides and ramming of bottoms, including getting out the excavated material, refilling after laying pipe/ foundation and disposal of surplus excavated material at a lead upto 50m suitable site as per direction of Engineer for following depths, below natural ground / Road top level.In all types soils/ saturated soil such as moorum, sand, sandy silt, clay, black cotton soil, kankar, etc.Depth upto 1.5 m |
| 10 | Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering - All work upto plinth level :1:4:8 (1 Cement : 4 fine/ coarse sand : 8 graded stone aggregate 40mm nominal size). |
| 11 | Brick work with FPS bricks of class designation 75 in foundationand plinth in:.Cement mortar 1:6 (1 cement : 6 coarse sand) |
| 12 | Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centring, shuttering, finishing and reinforcement - All work upto plinth level1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20mm nominal size) |
| 13 | Reinforcement for R.C.C. work at all levels including straightening,cutting, bending, placing in position and binding all complete.Thermo-Mechanically Treated bars. |
| 14 | Centring and shuttering with plywood or steel sheet upto two stories or height upto 7.5 metre above plinth level including strutting, propping etc. and removal of form for :Lintels, beams, plinth beams, girders, bressumers and cantilevers. |
| 15 | Brick work with FPS bricks of class designation 75 in superstructure above plinth level upto two stories in all shapes and sizes in :Cement mortar 1:6 (1 cement : 6 coarse sand) |
| 16 | Reinforced cement concrete work in beams, suspended floors,roofs having slope upto 15° landings, balconies, shelves, chajjas,lintels, bands, plain window sills, staircases and spiral stair cases upto two stories excluding the cost of centring, shuttering, finishing and reinforcement:M-20 Grade Concrete (1:1½:3 (1 cement : 1½ coarse sand : 3graded stone aggregate 20 mm nominal size) -As per design mix) |
| 17 | Cement plastering including T&P, scaffolding, material and complete labpour, including cost of water, curing, racking of joints etc. with 12mm cement plaster of mix :1:6 (1 cement : 6 fine/ coarse sand) |
| 18 | Centring and shuttering with plywood or steel sheet upto two stories or height upto 7.5 metre above plinth level including strutting, propping etc. and removal of form for :Suspended floors, roofs, landings, balconies and access platform. |
| 19 | Providing and fixing 1st quality MAT finished ceremic tile size300x300mm confirming to IS : 13755 and IS : 15622 colour such as white, grey, ivory, fume red brown, light green, light blue and other light shades in floors, steps, pillars etc. laid on a bed of neat cement slurry finished with flush pointing in the white cement mixed with pigment to match the shade of the tile complete (including the costof cement mortar bed 1:4). |
| 20 | Providing and fixing stone slab table rubbed, edges rounded and polished of size 75x50 cm deep and 1.8 cm thick fixed in urinal partitions by cutting a chase of appropriate width with chase cutter and embedding the stone in the chase with epoxy grout or with cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 6 mm nominal size) as per direction of Engineer-incharge and finished smooth.White Agaria Marble Stone |
| 21 | Providing and fixing white vitreous china flat back or wall corner typelipped front urinal basin of 430x260x350mm and 340x410x265mmsizes respectively. |
| 22 | Providing and fixing PTMT 15 mm Urinal spreader size 95x69x100mm with 1/2\" BSP thread and shapes. Weighing not less than 60gms. |
| 23 | Providing and fixing white vitreous china pedestal type (European type/ wash down type) water closet pan. |
| 24 | Providing and fixing P.V.C. low level flushing cistern with manuallycontrolled device (handle lever) conforming to IS : 7231, with allfittings and fixtures complete.10 litre capacity - White |
| 25 | Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply including all CPVC plain & brass threaded fittings i/c fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and testing of joints complete as per direction of Engineer in Charge. internal work expose on wall15 mm nominal outer dia .Pipes. |
| 26 | 20 mm nominal outer dia .Pipes. |
| 27 | Providing and fixing on wall face Unplasticised Rigid PVC Single socketed pipes rain water pipes conforming to IS : 13592 Type A including jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion..75 mm dia |
| 28 | 110 mm dia |
| 29 | Providing and fixing on wall face Unplasticised - PVC moulded fittings/ accessories for Unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A including jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion. Single tee with door 75x75x75 mm |
| 30 | Single tee with door 110x110x110 mm |
| 31 | Bend 87.5° 75 mm di |
| 32 | Bend 87.5° 110 mm di |
| 33 | Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810gms 15 mm nominal bore. |
| 34 | Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 15 mm nominal bore |
| 35 | Providing and fixing wash basin with C.I. brackets, 15 mm C.P. brass pillar taps,32 mm C.P. brass waste of standard pattern,including painting of fittings and brackets, cutting and making good the walls wherever require :White Vitreous China Flat back wash basin size 550x400 mm with single 15 mm C.P. brass pillar tap. |
| 36 | Wiring of light point / fan point / exhaust fan point / callbell point with 1.5 sq. mm FR PVC insulated unsheathed1.1kV grade flexible copper conductor and 1.5 sq.mmFR PVC insulated copper earth conductor (IS:694) ofapproved make in double lock/ ISI marked single lockpvc casing capping & it\"s accessories, 18 SWG M.S.box with earth terminal, screwless cage connectors forneutral looping in switch board & false ceiling point, 6 Aswitch 3.0 mm thick phenolic laminated sheet, zincplated / brass screws, cup washers , makingconnections, testing etc. as required. short point |
| 37 | medium point |
| 38 | P & F strip type fluorscent tube fitting fabricated from(CRCA sheet and finished with powder coating / stoveenamelled paint)/(extruded non corrosive UV resist EPchannel) complete with accessories like (OCCB, starter,starter seat)/ EB, rotor holder, terminal block dulyprewired with copper conductor including makingconnection, testing etc. as required. ( without tube) 1x36 watts with EB |
| 39 | P & F Fluorscent tube rod in existing fixtures as required T5 Lamps 28 Watts |
| 40 | P & F heavy duty, Double ball bearing and with sturdymesh guard; Aluminium alloy one piece blade wallmounting oscillating type air circulator conforming toIS:2997, including fixing with anchor bolts, regulatormaking connection testing etc. as required 600 mm sweep With three speed regulator group 2 |
| 41 | P & F heavy duty, Double ball bearing and with sturdymesh guard; Aluminium alloy one piece blade wallmounting oscillating type air circulator conforming toIS:2997, including fixing with anchor bolts, regulatormaking connection testing etc. as required 600 mm sweep With three speed regulator group 2 |
| 42 | P & F heavy duty, Double ball bearing and with sturdymesh guard; Aluminium alloy one piece blade wallmounting oscillating type air circulator conforming toIS:2997, including fixing with anchor bolts, regulatormaking connection testing etc. as required 600 mm sweep With three speed regulator group 2 |
AI Tender Summary
Tender Timeline
Oct 16, 2021
11:30 IST
Tender Published
Tender notice published.
CompletedNov 08, 2021
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedNov 09, 2021
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender