Supply, Installation And Demonstration Of Different Equipments, Instruments, Trainer Kits, Models, Study Setups Etc. For Different Laboratories Of Renewable Engineering Department Of Basirhat Government Polytechnic, Bhyabla,Basirhat, North 24 Pgs Supply, Installation And Demonstration Of Different Equipments, Instruments, Trainer Kits, Models, Study Setups Etc. For Different Laboratories Of Renewable Engineering Department Of Basirhat Government Polytechnic, Bhyabla,Basirhat, North 24 Pgs , Setup To Plot Current – Voltage (I-V) Characteristics Of Single Crystalline Silicon Solar Cell , Setup To Plotcurrent – Voltage (I-V) Characteristics Of Poly Crystalline Silicon Solar Cell And Find Out The Following To Study – I) The Solar Cell Parameters – O.C. Voltage (Voc), Short Circuit Current (Isc), Voltage-Current-Power At Maximum Power Point (Vmp, Imp, Mpp), Fill Factor, Efficiency. , Study The Effect Of Shading On Parameters Of Solar Cell Connected In Series-Parallel Combination. , Study The Effect Of Tilt Angle On Solar Cell Parameters (Voc, Isc, Vmp, Imp, Mpp, Fill Factor, Efficiency) , Assemble And Dismantle The Solar Pv System. , Set Up For Performance Analysis Of Single Phase Bridge Inverter With R-L Load And Voltage Control By Single Pulse Width Modulation. , Study Of Solar Smart Metering System And Its Troubleshooting. , Experiment To Run Water Pumping System Using Solar Power. , Solar Street Lighting System For Dc Supply. , Identify Different Components Of Solar Street Lighting System For Ac Supply. , Assemble The Components Of Solar Home Lighting System & Study The System. , Setup To Measure Beam, Diffuse And Global Radiation On Horizontal And Tilted Surface Using Pyranometer And Plot Radiation Vs. Time Characteristics For Certain Duration. , Datalogger , Multimeter , Setup For Characterization Of A Solar Flat Plate Collector And Evaluate Its Parameters. , Setup For Characterization Of Evacuated Tube Collector And Evaluate Its Parameters. , Setup For Characterization Of A Solar Concentrating Collector And Evaluate Its Parameters. , Setup To Measure Thermal Performance Of A Solar Cooker With Varying Reflector. , Setup To Measure The Parameters Of A Solar Dryer. , Setup To Plot And Analyse The Characteristics Curve Of Strain Gauge. , Setupto Plot And Analyse The Characteristics Curve Of Lvdt With Distance As Input. , Setupto Plot The Load Cell Characteristics Using Different Load As Input. , Setup To Measure Level Of A Tank Using Gauge Glass, Differential Pressure Transmitter. , Setupto Measure Level Of A Tank Using Displacer, Ultrasonic Level Meter. , Setup To Measure The Flow Of Liquid Using Rotameter, And Differential Pressure Transmitter. , Setup To Measure The Temperature Using Pt100 And Thermocouple. , Identification Of Different Parts Of C Type Burdon Tube Pressure Gauge. , Study Of Operation Of Dead Weight Tester And Calibration Of Pressure Gauge Using It. , Study & Measure Calorific Value Of Solid Fuel Using Bomb Calorimeter. , Study Of Different Parts Of Water Turbines Such As Pelton Wheel, Francics And Kaplan. , Study Of Schematic Layout Of A Hydroelectric Power Plant. , Study Of Different Parts Of Vane Pump / Gear Pump Generally Used In Hydraulic System. , Study The Different Parts Of A Hydraulic Trainer System. , Setup To Determine Brake Power, Indicated Power, Efficiencies Of Four Stroke Cycle Diesel Engine. , Identify The Different Parts Of A Dc Machine And Make A Report On It. , Setupfor Speed Control Of A Dc Shunt Motor Below And Above Its Rated Speed. , Identify The Different Parts Of A Single-Phase Transformer And A Three-Phase Transformer (From A Slide If Machine Is Not Available) & Make A Report On It. , Identify The Different Parts Of A 3-Phase Induction Motor And Make A Report On It. , Setup For No-Load Test And Blocked-Rotor Test Of A 3-Phase Induction Motor & Determine Equivalent Circuit Parameters. , 3-Phase, 5Kva, 415V Variac , Setupto Plot The O.C.C. Of An Alternator & Observe The Effect Of Excitation And Speed On Induced E.M.F.Ii) Perform Experiment To Find The Percentage Regulation Of 3-Phase Alternator By Synchronous Impedance Method At Various Power Factor And Load. , Setupto Synchronise Two 3-Phase Alternators By – A) Three Lamp Method OrB) Synchroscope And To Study The Sharing Of Load Between The Alternators. , Identify Different Parts Of Permanent Magnet Synchronous Generator (Pmsg) And Make A Report On It. , Identify The Different Parts Of An – A) Electromagnetic Energy Meter, B) Electronic Energy Meter Make A Report On It. , Setup To Calibrate Single Phase Energy Meter Using Resistive Or Inductive Loads. , Setupto Measure Energy Of 3- Phase Balanced Load Using Electronic Energy Meter. , Setup To Measure 3-Phase Power Of Balanced 3-Phase Load By 2-Wattmeter Method. , Setupto Measure Current Ratio, Voltage Ratio And Polarity Test Of Ct And Pt. , Set Up A Small Wind Turbine (Swt) System And Identify Its Specified Components. , Setup To Test The Performance Of Squirrel Cage Induction Generator (Scig) – Measurement Of Active And Reactive Power With Respect To Speed Of Scig And Its Analysis. , Setupto Test The Performance Of Permanent Magnet Synchronous Generator (Pmsg) – A) No Load Test, B) Load Test. , Set Up Of A Anaerobic Digestion Biogas Plant ToI) Measure The Calorific Value Of The Biogas.Ii) Measure The Yield Of The Biogas Changing The Input Parameters E.G. Temperature, Input Raw Materials.Iii) Calculate The Efficiency Of The Biogas Plant.Iv) Set Up Of A Gas Cleaning System With H2s And H2o Filter. , Study The Construction And Operation Of Energy Efficient Lamps – Cfl, Led, Fluorescent Lamp. , Setupto Calculate Power And Energy Consumed By A Florescent Lamp Using Electronic Ballast And Magnetic Ballast. , Setupto Compare Lighting Energy Consumption Of A Model Room Using Only Artificial Lighting And Artificial Lighting Integrated With Natural Daylighting. , Study The Parts Of A – I) Lead-Acid Battery And Experiment For Charging & Discharging Characterization Of The Battery And Measure Its Parameters. , Study The Parts Of A Ni-Cd Battery And Experiment For Charging & Discharging Characterization Of The Battery And Measure Its Parameters. , Study The Parts Of A Li-Ion Battery And Experiment For Charging & Discharging Characterization Of The Battery And Measure Its Parameters. , Setupconnect Lead-Acid Batteries In Different Connections To Verify Its Voltage & Ampere-Hour.
