Undertaking 6K Routines On Dg 1 Of Onboard Naval Vessel Undertaking 6K Routines On Dg 1 Of Onboard Naval Vessel
Tender Value
Ref. Documents
Estimated cost
Bid Submission
05 Oct 2021
0 days left
EMD
Ref. Documents
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Naval Ship Repair Yard ,Naval Base ,Karwar → Karnataka
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Undertaking 6K Routines On Dg 1 Of Onboard Naval Vessel Undertaking 6K Routines On Dg 1 Of Onboard Naval Vessel
BOQ
| Sl. No. | Item Description |
| 1 | SERVICES |
| 2 | 6000H2,Fuel System:(a) Clean and calibrate injectors and record test pressures in service log. Also change injector inlet screen.(b) Replace rocker cover gaskets.(c) Adjust valve tappet clearances within limits and record in service log.(d) Replace fuel pump filter (screen and magnet).(e) Calibrate PT fuel pump and record in service log. |
| 3 | 6000H3,Air system:(a) Clean turbocharger, compressor wheel and diffuser(b) Check turbo charger radial/end bearing clearance in-situ.Note: Renew ‘O’ ring and Teflon Gasket when turbocharger is Opened for checking clearances.(c) Torque manifold nuts or cap screws as per specifications. |
| 4 | 6000H4,Charge Air Cooler & Fresh Water Cooler:(a) Clean the internal passages of Charge Air Cooler and Fresh water Cooler coolant side using Restore Plus as laid down in operating Manual.(b) Renew coolant in the system(c) Inspect Charge Air Cooler air side and if required clean using hot Water and pressure test up to 2kg/cm2. |
| 5 | 6000H6,Check thickness of vibration damper at 0, 90, 180 and 270 Degree Positions. Replace damper if variation of the 4 readings exceeds 0.010 inch (0.25mm) or exceeds max allowable thickness. Checks to be undertaken in coupled condition. |
| 6 | 6000H8,Check crank end clearances with a dial indicator, attaching against damper Min- 0.13 mm, Max-0.51 mm. |
| 7 | 6000H11,For 1710/28GC1 engines - Undertake inspection of two representative pistons liners and bearings of the engine. Inspection of balance liners and bearings is to be scheduled based on inspection report of the two sample liners. |
| 8 | Load Trials DG 1 |
AI Tender Summary
Tender Timeline
Sep 29, 2021
11:30 IST
Tender Published
Tender notice published.
CompletedOct 05, 2021
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedOct 06, 2021
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender