Construction Of Main Outer Boundary Wall At Dr R.P. Govt. Medical College At Tanda In Distt Kangra ( Deposit Work ) ( Sh-Construction Of Boundary Wall, Retaining Wall And Other Work Etc ) Construction Of Main Outer Boundary Wall At Dr R.P. Govt. Medi
Tender Value
40.06 Lakhs
Estimated cost
Bid Submission
15 Sep 2021
0 days left
EMD
67600
Bank guarantee accepted
Document Fee
2000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Tanda → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Construction Of Main Outer Boundary Wall At Dr R.P. Govt. Medical College At Tanda In Distt Kangra ( Deposit Work ) ( Sh-Construction Of Boundary Wall, Retaining Wall And Other Work Etc ) Construction Of Main Outer Boundary Wall At Dr R.P. Govt. Medical College At Tanda In Distt Kangra ( Deposit Work ) ( Sh-Construction Of Boundary Wall, Retaining Wall And Other Work Etc )
BOQ
| Sl. No. | Item Description |
| 1 | Excavation in foundation, trenches etc. in earth work in all classification of soil such as pick work, jumper work, pick jumper work, blasting work, jumper blasting work, soft and hard blasting and saturated soil, de-watering, including wedging out rocks where blasting work is prohibited, chiseling or any other mixed variety of soil, de-watering and/or removal of slush and incidentals, lift upto any heights, stacking the excavated soil not more than 3 mtrs (Three meters) clear from the edge of excavation and then retuning the stacked soil in 15cm (Fifteen centimeter)layers, whenrequired into plinths, sides of foundation etc; consolidating each deposited layer by ramming, watering and then disposing of all excavated earth including carriage of materials within all leads, lifts and other incidentals and as directed by the Engineer-in-Charge. |
| 2 | Providing and laying cement concrete 1:5:10 (One cement; five sand; ten graded broken/crushed stone aggregate 40mm (Forty milimetres) nominal size) mechanically mixed and curing complete excluding cost of forms work in foundation and plinth including carriage of materials within all leads, lifts and other incidentals as per approved drawing, design and as directed by the Engineer-in-Charge. |
| 3 | Providing and laying Autoclayed cellular Aerated concrete blocks 200mm (Two hundred milimetre) thick confirming to IS:2185 (iii) 1984 bonded together with ploymer based mortar and finished with 12mm (Twelve milimetre) thick cement plaster 1:6 on both side complete as per HPPWD specifications or as directed by the Engineer-in-Charge, including carriage of material within all leads, lifts and other incidental. |
| 4 | Second class brick work using common burnt clay building bricks in super structure upto any floor level in cement mortar 1:6 (One cement: Six sand) as per approved drawing, design and as directed by the Engineer-in-Charge, including entire carriage of materials within all leads, lifts and other incidentals. |
| 5 | Providing from work of ordinary timber plankings so as to give a rough finish including centring,shuttering, strutting and propping etc. height of propping and centring below supporting floor to ceililng for all heights/depths and removal of the same for insitu reinforced concrete and plain concrete work in vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters,buttresses, plinth and string courses, Vertical fins and vertical sun breakers and the like as per approved drawing, design and as directed by the Engineer-in-Charge, including carriage of materials within all leads, lifts and other incidentals. |
| 6 | Providing and laying cement concrete work 1:2:4 (One Cement : Two Sand : Four graded stone aggregate 20 mm (Twenty millimetres) nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in suspended floors, roofs, landings, shelves their supports balconies, beams, girder, bressumers and cantileverscomplete as per direction of Engineer-In-Charge, including carriage of material within all leads, lifts and other incidentals. |
| 7 | Providing and laying upto first floor two level reinforced cement concrete 1:2:4 (One cement : Two Sand : Four graded stone aggregate 20mm (Twenty millimetres) nominal size) to give a smooth and even surface including centring and shuttering etc. but excluding cost of reinforcement in string courses, copings, bed plates, anchor blocks, plain windows sills and the like as directed by the Engineer-in-Charge, including entire carriage of materials within all leads, lifts and other incidentals. |
| 8 | Providing Tor steel reinforcement for reinforced cement concrete work including bending, binding and placing in position complete including cost of binding wires complete as directed by the Engineer- Incharge, including carriage of materials within all leads, lifts and other incidentals |
| 9 | 15mm (Fifteen milimetres) thick cement plasters in single coat on rough side of brick/concrete/stone walls for interior plastering upto all floor level including arises, internal rounded angles, chamfers and or rounded angles not exceeding 80mm (Eighty milimetres) in girth and finished even and smooth with cement mortar 1:4 (One cement : Four sand) upto any height as directed by the Engineer-in-Charge, including entire carriage of materials within all leads, lifts and other incidentals. |
| 10 | Applying priming coat on new concrete/masonry/asbestos cement/plastered surfaces after and including preparing the surface by thoroughly cleaning oil, grease, dirt and other foreign matter and sand papering as required with readymixed primer complete as per the directions of Engineer-Incharge including carriage of materials within all leads, lifts and other incidentals. |
| 11 | Finishing wall with weather proof exterior grade emulsion of approved design (Apexultima) or its equarlied on undecorated wall surfaces (two coats) to give an even shade and final finish after throughly cleaning the surface to remove all dirt, dust and other foreign matter etc including sand paper smooth complete as per directed by the Engineer- Incharge, including carriage of materials within all leads, lifts and other incidentals. |
| 12 | Steel work welded in built up sections,trusses and framed work, including cutting, hoisting ,fixing in position and applying a priming coat of red lead paint in beams joists channels, angles, tee ,flats with connecting plates or angle cleats as in main and cross beams,hip and jack rafters,purlins connected to common rafters and the like as directed by the Engineer-Incharge including carriage of materials within all leads, lifts and other incidentals. |
| 13 | Providing and fixing 250x16mm(Two hundred fifty into sixteen milimetres) nominal size anodized aluminium sliding door bolts anodized transparent or dyed to required colour and shade with necessary screws etc. completedincluding entire carriage of materials within all leads, lifts and other incidentals |
| 14 | Applying priming coat over new steel & other metal surfaces after and including preparing the surface by thoroughly cleaning oil grease dirt and other foreign matter and scoured with wire brushes fine steel wool scrapers and sand paper complete with ready mixed priming paint brushing red lead,Red-oxide/zinc oxide chrome complete as directed by the Engineer- Incharge, including carriage of materials within all leads, lifts and other incidentals |
| 15 | Painting two coats (excluding priming coat)on new steel and other metal surface under coat with ready mixed paint brusing to give an even shade including cleaning the surface all dirt, dust and other foreign matter with white readymixed paintcomplete and as directed by the Engineer-in-Charge within all leads, lifts of materials and other incidentals |
| 16 | Earthwork in excavation for structures as per drawing and technical specifications Clause 305.1 including setting out, construction of shoring and bracing, removal of stumps and other deleterious material and disposal upto a lead of 50 m, dressing of sides and bottom and backfilling in trenches with excavated suitable material,including carriae of material within all leads, lifts and other incidentals as per specifications, approved drawing, design, specifications and as directed by the Engineer-in-charge. |
| 17 | Providing and laying concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 with cement concrete 1:5:10 (One cement: Five sand : Ten graded/crushed stone aggregate 40mm (forty millimeter) nominal size), as directed by the Engineer-Incharge including carriage of materials within all leads, lifts and other incidentals. |
| 18 | Providing weepholes in brick masonry/stone masonry, plain/reinforced concrete abutment, wing wall, return wall with 100 mm dia PVC pipe extending through the full width of the structures with slope of 1(V):20(H) towards drawing face complete as per drawing and technical specifications clauses 614, 709, 1204.3.7 as per drawing and HP.PWD technical specifications,andas directed by Engineer-Incharge including carriage of material within all leads, lifts and other incidentals. |
AI Tender Summary
Tender Timeline
Sep 07, 2021
11:30 IST
Tender Published
Tender notice published.
CompletedSep 15, 2021
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedSep 15, 2021
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender