Supply Of Procurement Of Direct Online Starter Wall Mounting Type And Direct On Line Starter For 35T Jmp Jack.Procurement Of Direct Online Starter Wall Mounting Type And Direct On Line Starter For 35T Jmp Jack., Direct Online Starter Wall Mounting Type Wi-Bihar
TDR : 28030178
Tender Notice
BOQ
Expired
Bihar
Supply Of Procurement Of Direct Online Starter Wall Mounting Type And Direct On Line Starter For 35T Jmp Jack.Procurement Of Direct Online Starter Wall Mounting Type And Direct On Line Starter For 35T Jmp Jack., Direct Online Starter Wall Mounting Type Wi
Procurement of Direct Online Starter wall mounting type and Direct On line Starter for 35T JMP Jack.
2
Direct Online Starter wall mounting type with push button control, suitable for 3 phase 50 HZ. 415 Vfor 30 HP Motor. The contactor coil of the starter must be suitable for 415 V. 50 HZ. AC supply. The starter shallbe complete with over load and NO Volt. Protection. Material Specification: IS: 8544 (Part-1) IS: 13947- 4 - 1.Make: BCH / SIEMENS / Havells / Jeevan / SCHNEIDER / L&T.
3
Direct On line Starter with 2 sets of 3 pole / 4 pole contactors (2 sets AC contactor coils, 25 AMPeach), each set controlled separately by 415V. 50HZ AC Contactor Coils. One set of contactor coil is to becontrolled by the forward direction of rotation through an inching type push button and the other set throughanother inching button to control the reverse direction of 7.5 HP, 3Phase, 50HZ, 415Volts, AC Motor. There mustbe electrical interlocking contact to prevent both set of contactors to close simultaneously. Each of above pushbuttons should have one normally closed auxiliary contact and one stop push buttons are required. The startershall be complete with over load, shall be wired and shall be provided with power plug and socket with lockingarrangement as shown in schematic Drawing No. 1736/23 and 1737/23 Alt.-1. Each starter is to be provided with2 Nos. power plug and sockets and 2 Nos. of control plug and sockets. Maximum Dimension of the starter shouldnot excessed 280mm (B) X 360mm (L) X 162mm (T) irrespective of Dimension given in Drawing. MaterialSpecification: IS: 13947 Pt.-4 Sec.-1, 1993, Make: BCH / SIEMENS / Havells / Jeevan / SCHNEIDER / L&T.
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
