| 1 | 1 | Clearing and Grubbing Road Land including uprooting wild vegetation , grass,bushes,shurbs,saplings and trees of girth upto 300mm, removal of stumps of such trees cut earlier and unseviceable materials & stacking of serviceable materials to be used or auctioned upto a lead of 1000m including removal and disposal of top organic soil not exceeding 150mm in thickness as per technical specification(clause201.1) | | 1.03 | Ha |
|---|
| 2 | 2 | Scarifying the existing bituminous road surface to a depth of 150 mm and disposal of scarified material with a lift upto 3 m and lead upto 1000 m as per Technical Specification Clause 301.4. @ 12% of over all area. | | 2080.23 | sqm |
|---|
| 3 | 3 | Construction of Embankment with material obtained from borrow pits with a lift upto 1.5 m , transporting to the site spreading , grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m & 100 m as per Technical Specification Clause 301.5 . (Including Royality & Labour Cess). For 1000 m lead | | 2781 | Cum |
|---|
| 4 | 4 | Construction of Subgrade and Earthen Shoulders with 5% Local sand mixed with Rotavator to achive minimum Socked CBR value of 5 %. | | 420 | cum |
|---|
| 5 | 5 | Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401. (To achive minimum CBR value of 50% ) | | 197.31 | Cum |
|---|
| 6 | 6 | Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with three wheel 80-100 kN static roller in stages to proper grade and camber, applying and brooming, crushable screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 2 as per Technical Specification Clause 405. | | 561.19 | Cum |
|---|
| 7 | 7 | Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405. | | 1079.45 | Cum |
|---|
| 8 | 8 | Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per Technical Specification Clause 502 | | 14514.5 | Sqm |
|---|
| 9 | 9 | Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.225 to 0.3 kg per sqm on the prepared bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503. Over WBM III. | | 14392.6 | Sqm |
|---|
| 10 | 10 | Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.22 to 0.25 kg per sqm on the prepared granular surface tretaed with Primer and clened with hydriloc broom as per technical specification aclouse 503. Over Bitumminous Surface. | | 19698.8 | Sqm |
|---|
| 11 | 11 | Providing, laying and rolling of close-graded premix surfacing material of 20 mm thickness composed of 11.2 mm to 0.9 mm (Type-A) or 13.2 mm to 0.9 mm (Type-B) aggregates using penetration grade bitumen mixed with upto 8% of waste plastic (as per the code or as per th direction of EI) to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 8-10 kN static roller and finishing to required level and grades as per Technical Specification Clause 509 | | 14392.6 | Sqm |
|---|
| 12 | 12 | Providing and laying bituminous concrete with 100-120 TPH batch type hot mix plant producing an average output of 75 tonnes per hour using crushed aggregates of specified grading, premixed with bituminous binder @ 4.5 to 5.0 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic pave finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 508 complete in all respects. | | 492.47 | cum |
|---|
| 13 | 13 | Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401. (To achive minimum CBR value of 50% ) | | 115.8 | Cum |
|---|
| 14 | 14 | Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405. | | 172.13 | Cum |
|---|
| 15 | 15 | Construction of un-reinforced, jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using water or else (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501. | | 367.2 | cum |
|---|
| 16 | 16 | Laying brick soling layer on prepared sub-grade with brick on end edging according to lines, graded and cross-section shown on the drawing filling joints with sand and earth, spreading 25 mm thick layer of earth over brick soling, watering and rolliing the same with three wheel road roller 80-100 kN as per Technical Specification Clause 412 | | 300 | sqm |
|---|
| 17 | 17 | Providing and laying of a reinforced cement concrete pipe duct, 300 mm dia, across the road (new construction), extending from drain to drain in cuts and toe of slope to toe of slope in fills,constructing head walls at both ends, providing a minimum fill of granular material over top and sides of RCC pipe as per IRC:98, 1997,bedded on a 0.3 m thick layer of granular material free of rock pieces, outer to outer distance of pipe at least half dia of pipe subject to minimum 450 mm in case of double and triple row ducts, joints to be made leak proof, invert level of duct to be above higher than ground level to prevent entry of water and dirt, all as per IRC: 98 - 1997 and approved drawings.\n | | 217.5 | m |
|---|
| 18 | 18 | Reinforced cement concrete M15 grade boundary pillars/local stone of standard design as per IRC:25, fixed in position including finishing and lettering but excluding painting as per drawing and Technical Specification Clause 1704 | | 132 | Nos |
|---|
| 19 | 19 | Reinforced cement concrete M15 grade kilometre stone/local stone of standard design as per IRC:8 fixing in position including painting and printing, etc as per drawing and Technical Specification Clause 1703 | | | |
|---|
| 20 | 20 | ii) Km stone | | 7 | N |
|---|
| 21 | 21 | iii) 200 m stone | | 23 | N |
|---|
| 22 | 22 | Providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per IRC:67 made of encapsulated lens type reflective sheeting vide Clause 1701.2.3 fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete 450 mm x 450 mm x 600 mm, 600 mm below ground level as per drawings and Technical Specification Clause 801 | | | |
|---|
| 23 | 23 | 600 mm equilateral & triangle, | | 4 | N |
|---|
| 24 | 24 | 600 mm circular , | | 6 | N |
|---|
| 25 | 25 | 800 mm x 600 mm rectangular, | | 4 | N |
|---|
| 26 | 26 | 600 mm x 450 mm rectangular, | | 2 | N |
|---|
| 27 | 27 | 900 mm side octagon, OR | | 1 | N |
|---|
| 28 | 28 | Providing and erecting direction and place identification retro-reflectorised sign as per IRC:67 made of encapsulated lens type reflective sheeting vide Clause 1701.2.3, fixed over aluminium sheeting, 2 mm thick with area not exceeding 0.9 sqm supported on a mild steel single angle iron post 75 x 75 x 6 mm firmly fixed to the ground by means of properly designed foundation with M-15 grade cement concrete 450 x 450 x 600 mm, 600 mm below ground level as per approved drawing and Technical Specification Clause 1701 | | 3 | No. |
|---|
| 29 | 29 | Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The finished surface to be level, uniform and free from streaks and holes. | | 1039.38 | Sqm |
|---|
| 30 | 30 | Planting of trees by the road side (Avenue trees) in 0.60 m dia holes, 1 m deep dug in the ground, mixing the soil with\ndecayed farm yard/sludge manure, planting the saplings, backfilling the trench, watering, fixing the tree guard and\nmaintaining the plants for one year | | 344 | each |
|---|
| 31 | 31 | Providing and fixing of typical PMGSY/ MMGSY informatory sign board with Logo as per MORD specifications and drawing. Three MS Plates of 1.6 mm thick, top and middle plate duly welded with MS flat iron 25mm x 5m size on back on edges. The lower plate will be welded with MS angle iron frame of 25mm x 25mm x 5mm. The angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos. 75mm x 75 mm of 12 SWG sheet tubes posts duly embedded in cement concrete M-15 grade blocks of 450mm x 450mm x 600mm, 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and Annexure 1700.1 | | 4 | No. |
|---|
| 32 | 32 | Cost Estimate for Repair of R.C.C. Slab Culvert -4 Nos. | | | |
|---|
| 33 | 33 | Brick masonry work in cement mortar 1:3 in parapet excluding pointing and plastering as per drawing and technical specifications Clauses 600, 900 and 1208.4 | | 0.411 | cum |
|---|
| 34 | 34 | Plastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1204 | | 115.63 | sqm |
|---|
| 35 | 35 | Painting two coats including primer coat after filling the surface with synthetic enamel paint in all shades on new, plastered / concrete surfaces as per drawing and Technical Specification Clause 1701 | | 115.63 | sqm |
|---|
| 36 | 36 | Providing and laying neat cement punning 1.5 mm thick as per Specification etc as per direction. | | 30.08 | sqm |
|---|
| 37 | 37 | Providing Weepholes in brick masonary , Plain / Reinforced concrete abutement , wing wall , return wall with 100 mm dia AC pipe extending through the full width of the structure with slope of 1V: 20H towards drawing | | 56 | Nos. |
|---|
| 38 | 38 | GST @ 12% ON (PART A) | | 1 | Rupees |
|---|
| 39 | 39 | LABOUR CESS @ 1% ON (PART A) | | 1 | Rupees |
|---|
| 40 | 40 | SIGNORAGE (As calculated) | | 1 | Rupees |
|---|
| 41 | 41 | TOTAL COST OF 5 YEAR ORDANARY MAINTENANCE PER QUARTTERLY(IN LACS) | | 20 | Rupees |
|---|
| 42 | 42 | GST @ 12% ON (PART B) Maintenance | | 1 | Rupees |
|---|
| 43 | 43 | LABOUR CESS @ 1% ON (PART B) Maintenance | | 1 | Rupees |
|---|
| 44 | 44 | SIGNORAGE (As calculated) | | 1 | Rupees |
|---|
