| 1 | 0 | SCHEDULE 'A' | BI01010001010000000000000515BI0100001112 | | |
|---|
| 2 | 1 | Surface excavation n.exc 30 cm deep averaging 15 cm deep and getting out in soft/loose soil including Clearing away all grass vegetation, saplings, shrubs, brushwood, undergrowth, roots, and trees not exceeding 30 cm girth (measured one metre above ground level) and removing rubbish upto a distance of 50 metres complete all as specified and as directed.. | | 200 | Sqm |
|---|
| 3 | 2 | M&L Excavating in trenches n.exc 1.5 m wide and n.exc 1.5 m in depth for foundation etc or for shafts wall cesspits manholes pier holes etc. n exc 10 sqm m on plan and n exc. 1.5 m in depth and getting out in any type of soil. | | 101 | Cum |
|---|
| 4 | 3 | Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm thick using excavated soft/loose soil all as specified. | | 77.9 | Cum |
|---|
| 5 | 4 | M&L River Sand filling under Paver blocks including spreading, levelling, watering and consolidating all as specified and directed. | | 30 | Cum |
|---|
| 6 | 5 | Removing excavated soil n exc 50 m and depositing where directed at a level n exc 1.5m above the starting point. | | 117.9 | Cum |
|---|
| 7 | 6 | M&L Hardcore of guage n.exc. 63mm, deposited spread & levelled in layers n.exc.15CM thick, watered & rolled/ rammed to a true surface using broken stone or boulders all as specified and as directed by engineer-in-charge. | | 75 | Cum |
|---|
| 8 | 7 | M&L Moorum / Red bajri filling in floors or pavings laid in layers n.exc 15cm thick, spread, levelled and rammed including watering all as directed by Engr-in-Charge. | | 35 | Cum |
|---|
| 9 | 8 | M&L Plain cement concrete, type C2, (1:3:6, using 40mm graded stone aggregates) as in foundation, filling and mass concrete etc all as specified and as as directed by engineer-in-charge.\n\nNote: The proportioning of cement and aggregate for mixing by weight shall be as directed by the Engineer-in-charge. | | 2 | Cum |
|---|
| 10 | 9 | M&L Plain cement concrete, type B0, (1:2:4, using 12.5mm graded stone aggregates) as in cills, steps, bands, plinth courses,copings,bedplates,filiing gaps etc., and the like including weathering,slightly rounded or chamfered angles throating,necessary formwork, complete all as directed | | 20 | Cum |
|---|
| 11 | 10 | M&L Precast cement concrete block masonary, type C1 (1:3:6) using 20mm graded stone aggregates with solid blocks, exc 10cm in width and setting in cement mortar 1:6, complete all as specified and directed. | | 15 | Cum |
|---|
| 12 | 11 | M&L PCC type C1, 1 : 3 : 6, (20mm graded aggregate) as in precast cement concrete in window or door cills, lintels, bressumers, steps, quion blocks ( use with masonry), string courses, copings, kneelers, apex stones, road kerbs, pier caps, columns, posts, boundary pillars, bed plates, pintle blocks, anchorage blocks, bounders (for stone walling), corbels, brackets, etc (of any section indicated), with plain fair faces including chamfers, weatherings, throating etc, and setting in cement mortar 1:6 complete with joints to match. | | 35 | Cum |
|---|
| 13 | 12 | M&L 20 mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cill, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and directed. | | 45 | Sqm |
|---|
| 14 | 13 | M&L 75 mm thick, Plain Cement concrete, type D-2, 1:4:8 (using 40mm graded stone aggregate) as in sub base of floors even and rough finished to receive topping layer complete all as specified and as directed by Engr-in-Charge. | | 950 | Sqm |
|---|
| 15 | 14 | M&L 80 mm thick, M-40 grade, machine pressed precast concrete interlocking paver block of any shape and size with grey cement and pigment confirming to IS 15658-2006 complete all as specified and as directed by Engr-in-Charge. | | 1100 | Sqm |
|---|
| 16 | 15 | M&L Rendering 15 mm thick in cement mortar 1:6 on fair faces of pcc block masonry and finished even and smooth without using extra cement complete all as specified and as directed by Engr-in-Charge. | | 25 | Sqm |
|---|
| 17 | 16 | M&L 450 mm bore (internal dia) Re-inforced concrete pipes, class NP-2, laid and jointed complete with collars complete all as specified and as directed by Engr-in-Charge. | | 12 | RM |
|---|
| 18 | 17 | Supply, lay & test cable XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cable (heavy duty)with stranded aluminium conductor, 1100 volts grade (Earthed ), of size 4 core 16 sq mm. all as specified and as directed by Engineer-in-Charge \nMake: havells/Plaza/Finolex | | 300 | RM |
|---|
| 19 | 18 | M&L Earthing complete with excavation and earth work in any type of soil with galvanized steel earth plate electrode size 60 cm x 60 cm x 6 mm thick buried directly in ground (earth pit not less than 2.25 mtrs below ground level) with top edge of the earth plate not less than 1.5 mtr below normal ground level connected to GI earth strip 32 x 6 mm by means of bolts nuts check nuts and washers of galvanized iron, all as shown in electrical plate No.3 of MES SSR Part-1 connected to main switch board or main control board all as specified and testing on completion including provision of earth strip protected by galvanised iron 40 mm dia bore light grade pipe and watering pipe shall be 20 mm bore medium grade, PCC pit with pre cast RCC cover, charcoal / salt funnel etc. complete all as directed.\nNOTE :\n(1) The conctrete pit shall be PCC 1:3:6 tye C -1, 40 mm thick pre cast cover slab of RCC (1:2:4) type B-1 using 20 mm graded stone aggregate reinforced with 8 mm TMT bars with suitable cast iron handle shall be provided\n(ii) Item includes the cost of 7.5 m GI pipe for protection of earth strip\n(iii) Item includes the cost of 7.5 mtr length earth strip 32 x 6 mm \n(iv) Result of earthing is not less than 2 Ohm | | 4 | Each set |
|---|
| 20 | 19 | S&F stainless steel tubular pipes of grade 316 as in posts and railing including cutting, welding, fabricating, polishing and making suitable arrangements for flag hoisting, pully,hooks,caps and other fixture | | 104 | Kg |
|---|
| 21 | 20 | Supply, install, commissioning of 12.5 M high mast, top section 100 mm and bottom section 360mm, Section Thickness -3 , PCD-445 MM (4 Hole) shaft in two section suitable for 50 m/sec wind speed as per IS:875 part-III along with head frame, luminaires carriage suitable upto 6 nos LED Flood light luminaires in Symmetrical arrangement and other accessories manufactured as per OEM including \nfollowing :-\na) Raising lowering system comprising double drum winch, 5 mm diameter SS wire rope, trailing cable, connector, integral power tool motor, manual handle, junction box, lightning finial & counter weight . (Wiring material from JB to individual luminaire & MCB in base compartment are not included and are a part of installation). \nb) Foundation bolts manufactured from special steel along with nuts, washers, anchor plate and common template.\nSize- M24 x 4 nos, 850 MM long, Anchore & Template Plate PCD- 445 mm (4 Hole)\nc) Outdoor stand mounted feeder pillar with 32A TPN MCB incomer, single dial time switch, 25 A TP contactor for the automatic switching of luminaries, power tool control with 2 no 9A contactors and raise lower push button, Incoming 35 sq. mm and out going 16 & 2.5 sq. mm terminals.\nd) Construction of shallow foundation with M20 grade concrete for the highmast considering the safe soil bearing capacity at site as 10 T/sqmtr at 2 metre depth with all materials as per OEM specification.\ne) Erection of 12.5 Mt high mast with the help of suitable tools and plants, wiring of luminaires with all wiring materials like PVC insulated PVC sheathed flexible cable of suitable copper conductor cores of 1.5 sq. mm, lugs etc.\nf) Installation of the mast feeder pillar as per OEM specification\nMake : Bajaj/Utkarsh/Surya\n\n | | 2 | Each Job |
|---|
| 22 | 21 | S&F 150 W LED Flood light fitting with ultra seek, light weight and with secondary optics, made of die cast aluminium housing with IP 66 rating, toughened glass, bolts, washers,and including electric connection using 3Core 1Sqmm PVC Insulated Copper Cable from control box to fitting complete all as specified and directed.\nMake: Bajaj (BJFL150WLED) / Wipro (LF-20-192-060-57-G2) | | 12 | Each |
|---|
| 23 | 22 | Supply and fix of Single Dome 60W LED Aviation Light comprising of aluminium housing with polycarbonate enclosure with integral driver, IP65 protection,240V, 50Hz bolts, washers,and including electric connection using 3Core 1Sqmm PVC Insulated Copper Cable\nMake: Bajaj (BGAV 302 LED)/ Equivalent in Wipro | | 2 | Each |
|---|
| 24 | 23 | Supply and lay 63 mm outer dia double wall corrugated (DWC) high density polythene pipes having corrugation on the outer wall and plain surface on the inner wall confirming to IS 16205 & IS14930 ( Part I and II) for protection of underground cables with all fittings. laid in trenches / road/ nallah or fixed along wall. poles or laid under floor (including cutting floor/Road and making good to match with existing adjoining surface etc for cable protection all as specified (excavation and earth work shall be measured and paid separately) \nMake: Rex/Poly/Gemini | | 300 | RM |
|---|
| 25 | 24 | Taking down Old Unserviceable High Mast pole carefully and stacking to MES store yard including all fittings and accessories. | | 1 | Each Job |
|---|
