Design, Development, Manufacture, Supply, Installation, Testing And Commissioning Of Microprocessor Controlled Igbt Based 3 Phase Propulsion Equipment For Memu (On Board - 08 Car Rakes) As Per Rdso Spec No. Rdso/Pe/Spec/Emu/0163 - 2012 (Rev-1) With Addend

Sharing tender

Supply Of , Traction Transformer Complete With Cooling System & Accessories Like H.T Cable Along With Protection Shield In Passenger Compartment And Under Frame Area, Thermostat Etc. Related Protection Equipment And With Safety Chain Arrangement Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories Including Oil Pump, Oil Cooling Blowers Etc. As Per Clause 4.1 Rdso Specification ( One Set Per Basic Unit ) , Gapless Lightning Arrestors As Per Clause 4.2 Of Rdso Specification ( One Set Per Basic Unit ) ., Igbt Based Pwm Power Converter Inverter Complete With Dc Link With 100 Hz Resonance Filter And / Or Any Other Equipment Necessary To Reduce The Effect Of Other Harmonics On S&T Equipment, Pre-Charging Resistor, Braking Resistor And Associated Power / Control Contactors, Power & Control Cables, Cooling System With Accessories Such As Equipment Anchoring Arrangement To Coach Body & Ht Compartment Interlock System Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories Including Brake Control Electronics Complete System Fulfilling The Brake Blending Requirements Including Wheel Slip / Slide Protection And Anti Skid Controls As Per Clause 4.12 ( 4.12.1 To 4.12.7 ) Of Rdso Specification And Auxiliary Machines As Required ( One Set Per Motor Coach ) ., Asynchronous Axle Hung Nose Suspended Traction Motors With Roller Bearing Suspension Compatible With Pinion, Gear, Gear Case, Nose Suspension Block And All Associated Hardware, Air Bellows / Air Filters And Speed / Temperature Sensor Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories., Microprocessor Based Tcms / Multiplexing System / Equipment For Inter Coach Data Transmission And Controls And Other Accessories Including Fault Diagnosis And Display System In The Driving Cab, Multiplexing Cables And Connectors In Assembled Form And Prewired Modular Type Panels Wherever Required ( One Set Per Rake ) ., Auxiliary Converter, Igbt Based, Complete With Cooling System And Accessories For Supply To Auxiliary Machines Including Motor Compressor Set, Battery Charging, Lighting And Ventilation Of 4 Car Unit And Lighting / Ventilation Of Adjacent 4 Car Unit In Case Of Extended Auxiliary Load Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, With Accessories Such As Equipment Anchoring Arrangement To Coach Body, Equipment Mounting And Earthing Hardware And Accessories Including Auxiliary Machines As Required ( One Set Per Basic Unit ) ., Pneumatic System Comprising Of Main Air Compressor ( Splash Lubricated / Oil Free ) Along With Mounting Frame Assembled With 3 Phase Induction Motor, Filters, And Pressure Switches, Control & Air Dryer, Filters Etc., As Per Clause 4.14.17 Of Rdso Specification. The Bidder Should Indicate The Type Of Compressor Offered In This Bid. ( One Set Per Basic Unit ) , Vacuum Circuit Breaker ( Ac ) With Earthing Switch And Ht Door Interlocks ( One Set Per Basic Unit ) , High Rise Pantograph Complete Suitable For Ac Application With Mounting Insulators And Necessary Control Valves And Isolating Cocks Including Interconnecting Bus Bars And Associated Hardware For Roof Equipment ( One Set Per Basic Unit ) ., All Control, Power, Data And Communication Cables Including Wiring Of Lights, Fans And Papis Along With Terminal Equipment For Proper Working Of Entire System And All Accessories. Cables Shall Be Supplied As Harness, Duly Cut To Size, Marked, Connectorised / Crimped Along With Protective Accessories For Protection Against Abrasion And Grouped According To Area Of Use. Please Refer Clause 4.17.2 ( Xiii ) Of Rdso Specification In This Regard ( One Set Per Rake ) ., Complete Pre-Fabricated Drivers Desk And Cab Equipment. The Cab Shall Include All The Cab Equipments E.G. Combined Master-Cum-Brake Controller, Instrument Panel With Back-Lit Instruments, Gauges For Pneumatic Indications, Control Panels, Drivers Diagnostic Display Unit & Drivers Log In Device, Etc., Ergonomically Designed Driver Desk / Console, Pre-Wired And Terminated On A Terminal Board And Multi-Pin Plugs / Sockets For Inter- Equipment Connections. Cab-Equipment Shall Also Include Pneumatic Horns, Electric Motor Driven Wind Screen Wipers, Sunscreens, Head Light, Flasher Light, Marker Cum Tail Light, Safety Related Equipments Like Bell Code System., All The Above Equipment Shall Include Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories ( One Set Per Dmc ) ., Led Lights Including Emergency Lights And Bldc Fans For Passenger Area ( 450 Mm Sweep ) And ( 400 Mm Sweep ) For Drivers Cab& Ht And Lt Compartments, Alarm Mechanism Having Push Button And Led Indication With Transparent Polycarbonate Enclosure & External Led Indicator ( Pail-Passenger Alarm Indication Light ) With Release Push Button With Ss Enclosure On Either Side Of The Coach And Modular Type Switches For Fans, Including Mounting Hardware And Accessories ( One Set Per Rake ) ., Set Of Mcbs, Contactors, Relays Etc. For Propulsion System, Control, Auxiliary Etc. In Prewired And Assembled Condition With Modular Type Panels Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories ( One Set Per Basic Unit ) ., Parking Brake Equipment Complete With Control, Associated Valves & Wiring Etc. As Per Clause 4.12.8 Of Rdso Specification ( One Set Per Rake ) ., Load Weighing Sensors With Adequate Redundancies As Per Clause 4.12.10 Of Rdso Specification ( One Set Per Rake ) ., Passenger Information Comprising Single Front Led Destination Board In Dmcs ( Head Code ) And Communication System Including 02 Nos. Of Double Side Display Units And 02 Nos. Single Side Display Units Per Coach For Passenger Area, Loud Speakers, Gps Antenna Etc., As Per Clause No. 4.6.2 Of Rdso Specification Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories ( One Set Per Rake ) ., Laptops With Necessary Interfacing Equipment For Diagnostics, Inter Vehicular Coupler Assembly Complete With Connectors As Per Clause No. 4.17.4 Of Rdso Specification Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves And Mounting & Earthing Hardware And Other Associated Accessories ( One Set Per Rake ) ., Speed Indicating Cum Recording System As Per Clause No. 4.9.4 Of Rdso Specification ( One Set Per Dmc ) ) , Set Of Potential Transformer & Current Transformer As Per Clause No. 4.1.8 Of Rdso Specification ( One Set Per Basic Unit ) ., Roof Mounted Cab Air-Conditioning Unit ( 2.0Tr Min ) With Control Panel Along With Mounting Frame And Anchoring Arrangement To Coach Body And All The Accessories / Hardware Generally Conforming To Icf Specification No. Icf / Elec / 110, Cs-1& 2 Or Rdso Specification No. Rdso / 2007 / El / Spec / 0055 ( Rev-1 ) . ( One Set Per Dmc ) , Provision Of Networking System Including Cctv Cameras In All Coaches, Nvrs, Outer Vehicle Front Camera And Rear View Cameras In Dmc Coaches, Display In The Driving Cabs, Gps Antenna Etc., Generally Conforming To Icf Specification No.Icf / Elec / 166 ( Rev.00 ) ( One Set Per Rake ) ., Cable Transit System With Epdm Rubber Modules As Per Clause No. 4.17.2 ( Xii ) Of Rdso Specification And Conforming To Rdso / 2008 / El / Spec / 0067 ( Rev 2 ) Of January 2015 For Cable Entry From Under Frame / Above Roof / End Wall To Passenger Compartment, Drivers Cab, Ht / Lt Compartment Etc., ( One Set Per Rake ) ., Auxiliary Compressor With Mounting Frame, Anti-Vibration Mountings, Mounting Hardware And Accessories Etc.As Per Clause 4.14.14 Of Rdso Specification ( One Set Per Basic Unit ) ., Design And Supply Of Trays For Laying Of Harnessed Cables Including Its Accessories As Per Clause 4.17.2 ( Xiii ) Of Rdso Specification ( One Set Per Rake ) ., Set Of Ht Room Filters ( One Set Per Dmc ) , Material Handling, Loading & Installation, Fitment, Cabling And Wiring Work With Accessories, Connection, Securing, Supervision, Testing And Commissioning Of All The Electrical Equipment / Fittings Inside The Coach, Driving Cab, End Walls, Over The Roof, Ht / Lt Compartment, Under Frame And Bogie Etc. The Cabling And Wiring As Per Clause 4.17 Of Rdso Spec. No. Rdso / Pe / Spec / Emu / D / 0163 ( Rev.1 ) -2012 With Rdso Addendum 1, 2&3 Cables Shall Confirm To Rdso Spec. Elrs / Spec / Elc / 0019 Or Latest. ( One Set Per Rake ) ., Special Tools For Assembly / Disassembly Of Traction Motor Including Equipment For Extraction Of Pinion & Bearings., Lifting Frames And Special Fixtures For Equipment Viz., Traction / Auxiliary Converter & Transformer., Traction Transformer Complete With Cooling System & Accessories Like H.T Cable Along With Protection Shield In Passenger Compartment And Under Frame Area, Thermostat Etc. Related Protection Equipment And With Safety Chain Arrangement Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories Including Oil Pump, Oil Cooling Blowers Etc. ( One Set Per Basic Unit ) , Igbt Based Pwm Power Converter Inverter Complete With Dc Link With 100 Hz Resonance Filter And / Or Any Other Equipment Necessary To Reduce The Effect Of Other Harmonics On S&T Equipment, Pre-Charging Resistor, Braking Resistor And Associated Power / Control Contactors, Power & Control Cables, Cooling System With Accessories Such As Equipment Anchoring Arrangement To Coach Body & Ht Compartment Interlock System Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories Including Brake Control Electronics Complete System Fulfilling The Brake Blending Requirements Including Wheel Slip / Slide Protection And Anti Skid Controls As Per Clause 4.12 ( 4.12.1 To 4.12.7 ) Of Rdso Specification And Auxilary Machines As Required ( One Set Per Motor Coach ) ., Auxiliary Converter, Igbt Based, Complete With Cooling System And Accessories For Supply To Auxiliary Machines Including Motor Compressor Set, Battery Charging, Lighting And Ventilation Of 4 Car Unit And Lighting / Ventilation Of Adjacent 4 Car Unit In Case Of Extended Auxiliary Load Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, With Accessories Such As Equipment Anchoring Arrangement To Coach Body, Equipment Mounting And Earthing Hardware And Accessories Including Auxiliary Machines As Required ( One Set Per Basic Unit ) ., Asynchronous Axle Hung Nose Suspended Traction Motors With Roller Bearing Suspension Compatible With Pinion, Gear, Gear Case, Nose Suspension Block And All Associated Hardware, Air Bellows / Air Filters And Speed / Temperature Sensor Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories, Combined Master & Brake Controller With Accessories ( One Set Per Dmc ) ., Set Of Brake Equipment Including Electronic Cards Etc. & Parking Brake Equipment: A ) Becu B ) Brake Blending Equipment C ) Parking Brake, Main Compressor ( Splash Lubricated / Oil Free ) With Three Phase Induction Motor Including Pressure Switches, Controls & Air Dryer Etc., As Per Clause 4.14.17 Of Rdso Specification. Offered Type Of Compressor Shall Be Supplied ( One Set Per Dmc ) ., Set Of Mcbs, Contactors, Relays Etc. For Propulsion System, Control, Auxiliary Etc. In Prewired And Assembled Condition With Modular Type Panels Including Termination Crimping Lugs, Cable Markers With Heat Shrinkable Sleeves For Power And Control Cables, Equipment Mounting And Earthing Hardware And Accessories ( One Set Per Basic Unit ) , Gapless Lightning Arrestors As Per Clause 4.2 Of Rdso Specification ( One Set Per Basic Unit ) , Vacuum Circuit Breaker ( Ac ) With Earthing Switch And Ht Door Interlocks ( One Set Per Basic Unit ) ., High Rise Pantograph Complete Suitable For Ac Application With Mounting Insulators And Necessary Control Valves And Isolating Cocks Including Interconnecting Bus Bars And Associated Hardware For Roof Equipment ( One Set Per Basic Unit ) ., Led Based Light Fittings Including Passenger Compartment Light Fittings, Head Lights, Flasher Lights & Tail Lamp With Control Unit And Marker Light& Fans ( One Set Per Dmc ) ., Roof Mounted Cab Air-Conditioning Unit ( 2.0Tr Min ) With Control Panel Along With Mounting Frame And Anchoring Arrangement To Coach Body And All The Accessories / Hardware Generally Conforming To Icf Specification No. Icf / Elec / 110, Cs-1& 2 Or Rdso Specification No. Rdso / 2007 / El / Spec / 0055 ( Rev-1 ) . ( One Set Per Dmc ) ., Set Of Ht Filters ( One Set Per Dmc )