| 1 | 1 | SITC of High Mast/ Mini Mast | | | |
|---|
| 2 | 1.01 | 90.15.2.3 : Supply installation testing and commissioning of High Mast using Octogaonal Pole made single/two sections of hot dip galvanised GI sheet 100mm top diameter, 360mm bottom diameter thickness 3mm mm suitable for wind speed as per IS 875 Part III with head frame assembly two point suspension system with steel wire rope 5mm dia double drum winching system w and including round arm galvanized luminary carriage suitable to install 6/8 nos luminaries in symmetrical arrangement control gear box and lighting spikes with single phase operation power tool installed inside the base compartment including connector foundation bolt 4 nos fixed in existing RCC foundation and junction box etc, complete 12 Meters | | 3 | each |
|---|
| 3 | 1.02 | 90.15.1.3 : Supply installation testing and commissioning of Octogaonal Pole made of hot dip galvanised GI sheet 70mm top diameter. 175 mm bottom diameter thickness 3mm base plate dimensions of 275x275x16 mm suitable for wind speed as per IS 875 Part III fixed head frame including round arm luminary carriage suitable to install 4/6 nos luminaries in symmetrical arrangement including connector foundation bolt 4 nos fixed in existing RCC foundation and junction box etc, complete 10 Meters | | 25 | each |
|---|
| 4 | 1.03 | 90.15.4.6 : Supply Conveyance, installation, testing and commissioning of 70W LED Flood light output greater than 105lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than 10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer) | | 125 | each |
|---|
| 5 | 1.04 | 90.15.4.7 : Supply Conveyance, installation, testing and commissioning of 100W LED Flood light output greater than 105lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than 10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer) | | 18 | each |
|---|
| 6 | 1.05 | 14.1 : Excavation for foundation in soft soil including dressing of sides and ramming of bottoms, lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 metres. | | 40 | cum |
|---|
| 7 | 1.06 | 14.10 : Providing and laying in position reinforced cement concrete 1 :2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) in foundation of pump, DG set etc. including form work etc. as required (excluding reinforcement). | | 15 | cum |
|---|
| 8 | 1.07 | od38175/2020_2021 : Reinforcement for R.C.C works, bend, tied and placed in position(plain grill requiring bend cold) using tor steel- | | 600 | kg |
|---|
| 9 | 1.08 | od38176/2020_2021 : Providing 12mm thick cement plaster of mix 1:4 (1 cement : 4 fine sand) at all levels. | | 46 | cum |
|---|
| 10 | 1.09 | 5.4 : Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, andproviding masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required. | | 28 | set |
|---|
| 11 | 1.1 | od38177/2020_2021 : Providing and fixing 2 X 25 mm X 3 mm G.I. strip test joint for earthing system | | 7 | metre |
|---|
| 12 | 1.11 | od38178/2020_2021 : Providing and fixing 25 mm X 3 mm G.I. strip earth lead from the test joint to the earth plate | | 168 | metre |
|---|
| 13 | 1.12 | 90.16.1.3 : Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required3.15 mm copper conductor ( 10 SWG) | | 140 | metre |
|---|
| 14 | 1.13 | 90.16.5.3 : Supply of superior quality copper earth socket for the following size of earth conductor including crimping etc. as required.3.15 mm (10 SWG) | | 168 | each |
|---|
| 15 | 1.14 | od38179/2020_2021 : Supply and providing 25x3mm brass bolt and nut with washers on the existing MS box / earth bus etc. as required including drilling necessary holes as required- | | 79 | each |
|---|
| 16 | 1.15 | od38180/2020_2021 : Supply and providing 25x6 mm brass bolt and nut with washer including drilling holes as required- | | 56 | each |
|---|
| 17 | 1.16 | 90.14.1.1 : Fabrication, supply, conveyance, installation testing and commissioning of floor or wall mounting, dust and vermin proof, cubicle type MV panel board comprising of the following components/ devices & complying to IS 8623. Fabrication of fully partitioned, dust and vermin proof enclosure for panel assembly as per form 4 of IS 8623 (with latest amendments) using CRCA sheet as per approved design and requirement, with front and rear access facility, bus bar chambers, hinged doors for all switch gear compartments, earthing the doors using 4 sq mm braided copper conductor, providing necessary cut-outs for mounting meters, relays, indication lamps, bus bar interconnection etc, detachable covers for bus bar chamber and cable alley, powder coating the assembly after subjecting to 7 tank process etc as required. CRCA sheet alone be used for the fabrication. Angles/ flats/ slotted angles etc shall not be used for the fabrication of panel assembly. The measurments will be taken the area of the complete sheets used for panel board including partitions, folding, shrouding etc.Supply and fabrication of MV panel board using 2.00mm CRCA sheet, powder coated (excluding base frame) | | 41 | sqm |
|---|
| 18 | 1.17 | 90.14.7 : Supply and providing copper earth bus in the panel board | | 280 | Cum cm |
|---|
| 19 | 1.18 | 90.14.2.1 : Supply and providing 2mm SMC sheet as shrouding for bus interconnection / terminations etc. including required nut & bolt etc. | | 2.6 | sqm |
|---|
| 20 | 1.19 | 90.14.3.2 : Supply and providing heavy duty 'A' section neoprene gasket in the panel boardU' section rubber beeding suitable for 1.60/ 2.00 mm sheet | | 57 | metre |
|---|
| 21 | 1.2 | 90.14.5 : Supply and fabrication conveyance and installation of angle iron frame work for wall mounting panel board | | 466 | kg |
|---|
| 22 | 1.21 | 2.1.1 : Providing and fixing following capacity TP&N disconnector fuse switch unit inside the existing panel board with ISI marked HRC fuses including drilling holes in cubicle panel, making connections, etc. as required.32 Amp TP & N | | 28 | each |
|---|
| 23 | 1.22 | od38181/2020_2021 : Supply and fixing of Neutral link 32 A, 2 Way neutral links mounted on DMC/SMC base- | | 28 | each |
|---|
| 24 | 1.23 | od38182/2020_2021 : Supply and fixing 32A HRC fuse base with HRC fuse link- | | 28 | each |
|---|
| 25 | 1.24 | 2.14.1 : Supplying and fixing following rating, double pole, (single phase and neutral), 240 volts, residual current circuit breaker (RCCB), having a sensitivity current upto 300 milliamperes in the existing MCB DB complete with connections, testing and commissioning etc. as required.25 amps | | 28 | each |
|---|
| 26 | 1.25 | 2.10.3 : Supplying and fixing 5 amps to 32 amps rating, 240/415 volts, \"C\" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required.Double pole | | 28 | each |
|---|
| 27 | 1.26 | od38183/2020_2021 : Supply and fixing Time switch 240V AC DIN/BASE mounting(L&T J648B1-Analog version) in the existing enclosure and giving connection as required- | | 28 | each |
|---|
| 28 | 1.27 | od38184/2020_2021 : Supply and fixing 25A AC1, MNX 9, 2 Pole power contactor (L&T) conforming to IS/IEC 60947-4-1 & IEC60947-4-1 in the existing enclosure and giving connection as required- | | 84 | each |
|---|
| 29 | 1.28 | 1.17.20 : Supplying and drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface / recessed steel/ PVC conduit as required.2 x 4 sq. mm | | 80 | metre |
|---|
| 30 | 1.29 | 90.12.24.2 : Supply of superior quality copper tubular cable socket and making core termination of cables of the following sizes including crimping etc. as required.4 sq mm | | 119 | each |
|---|
| 31 | 1.3 | 90.12.9.2 : Supplying, laying and jointing of the following sizes of double wall corrugated (DWC) pipes made out of HDPE conforming to IS 14930 Part II for mechanical protection to underground power cables with all required accessories in ground in the existing trench50/38 mm or nearest size | | 56 | metre |
|---|
| 32 | 1.31 | 90.12.5.3 : Supply & laying of one number PVC insulated and PVC sheathed armoured aluminium power cable of 1.1KV grade of the following sizes in the existing RCC/ HUME / STONE WARE/ GI/ DWC pipe as required.2 core 10 sq mm | | 84 | metre |
|---|
| 33 | 1.32 | od38186/2020_2021 : Fabrication,supply,conveyance and installation of Granite name board indicating the cost involved, the dates of commencement, completion, inauguration etc on existing base as required- | | 28 | no |
|---|
| 34 | 1.33 | od38187/2020_2021 : Supply and fixing Danger notice board of size, 125 x 75 mm | | 28 | each |
|---|
| 35 | 1.34 | od135266/2020_2021 : Supply and fixing flex board and fixing around pole writing Name of work in suitable colour etc as required | | 28 | each |
|---|
| 36 | 1.35 | od135268/2020_2021 : Supply and laying light gauge PVC conduit of the following sizes conforming to IS 9537/1983 Part III in roof slab, jointing the pipes with PVC solvent cement, tying & fixing the conduit firmly with the re-inforcement etc. as required. 32 mm(service pipe) | | 56 | metre |
|---|
| 37 | 1.36 | od38188/2020_2021 : KSEB Charges for single phase connection as per actual receipts | | 1 | L.S |
|---|
