Cycling Logos with thermo plastic Paint ( Rate is based on quotation)
2
Cycling Track
N/A
1460.00
1 Sqm
702.00
1024920.00
Supplying of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorising glass beads @ 250 gms with reflectorising glass beads on Bituminopus surface at 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per IRC: 35, the material should be of BERGER company / BERGER Equivalent and must comply with the following a) White index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for cheking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. in case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249 c) Crack resistance. The applied panel cured for 7 days under ambient condition and then should be tested as per BS3262, Part-1, 1989 and should pass at the range of \0\ degree centigrade to \-0\ degree centigrade d) Adhesion : Strong E) Softening point : 102 degree centigrade F) Dried film finish : Smooth and uniform G) Night Vision : High as directed by the Engineer-In-Charge and confirming to IS : 164-1961 (1st revision reaffirmed in 1986) and clause confirming to IRC 35-1997
3
Cycling Track
N/A
96.00
1 Sqm
7432.00
713472.00
Providing and fixing village name board size 600x800 mm made out of Type-XI of ASTMD 4956-09 wide angle cube cornered micro prismatic Retro reflective sheeting and conforming to IRC 67:2012 for full background of Green colour & white letters and fixed over 3MM alluminium composite Material sheet having minimum 0.30mm thick Alluminium skin on both sides with back side painted grey colour and fixed over back support frame of MS angle 25x25x3mm all round and fixing with 35x35x4mm and mounted on a MS angle post of size 75x75x6mm with clear height of not less than 2.1m from the ground level to the bottom of the board. The signpost should be painted with one coat of red oxide paint and 2 coats of synthetic enamel paint black and white colour with bands of 30cm of height. The signpost shall be firmly fixed with MS base angle 35x35x4 mm in to the ground by M15 concrete foundation of size 450x450x600mm including cost and conveyance of all materials equipment, machinery and labour with all leads and lift loading charges necessary for satisfactory completion of the work as directed by Engineer-in-charge
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
