Construction Of 2 No . Hume Pipe Culverts On Gharaunda To Barsat Road Km . 2 . 70 In Village Dingar Majra And 8 . 70 In Village Barsat ( Road Id 7520 ) In Karnal Distt . , Karnal-Haryana
TDR : 25082272
Tender Notice
BOQ
Expired
Karnal
Haryana
Construction Of 2 No . Hume Pipe Culverts On Gharaunda To Barsat Road Km . 2 . 70 In Village Dingar Majra And 8 . 70 In Village Barsat ( Road Id 7520 ) In Karnal Distt .
Name of Work: CONSTRUCTION OF 2 NO. HUME PIPE CULVERTS ON GHARAUNDA TO BARSAT ROAD KM. 2.70 IN VILLAGE DINGAR MAJRA AND 8.70 IN VILLAGE BARSAT (ROAD ID 7520) IN KARNAL DISTT.
Sl.No.
Item Description
Item Code / Make
Quantity
Units
1
1
Earth work in excavation in foundations, trenches, etc. in all kinds of soils, not exceeding 2 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonry, in 15 cm layers with compaction, including disposal of all surplus soil, as directed within a lead of 30 metres.(HSR 6.6)
95
cum
2
2
Cement concrete 1:6:12 with stone aggregate 40mm nominal size in foundation and plinth (HSR 10.32)
10
cum
3
3
First class brick work laid in cement sand mortar 1 : 5 in foundation and plinth (HSR 11.3)
33
cum
4
4
Cement pointing 1:2 deep variety on brick and tile work (HSR 15.60)
50
sqm
5
5
Providing, lowering, cutting, jointing and testing 600mm dia RCC pipe Class NP-3 as per IS 458-2003 with Spigot and socketed joints manufactured with ISI marked Sulphate Resistance Cement as per ISI 12330 with rubber rings ISI marked , antitermite as required at site , into trenches, for all depths and laying out the same to correct alignments, gradients and levels including dressing and trimming and cutting of concrete beds and sides of trenches , if required , Jointing with rubber rings in trenches and jointing with 1:1 ½ cement sand mortar and with end dowels filled with 1:1 ½ cement sand mortar and finishing the joints at angle of 45 degree with faces of spigot of socket joints cutting and finishing the cut surface to a uniform finish etc. as fully described in (HSR item No 29.38,29.44,29.45 & 29.46) including cartage , loading and unloading complete in all respects.\nNote: - Contractor shall supply bill of manufacture of pipes. Pipes should bear name of manufacturer and ISI mark along with bill duly valid ISI certificate of manufacturer should be supply. Without these bills certificate no payment shall be released.
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
