Construction Of Cc Walls And Strengthening Of Slopes With Stone Pitching From A2 To P7 Piers Of Cable Stayed Bridge In Ambedkar University Area Backside Of Amar Society Houses., Rangareddy-Telangana
TDR : 24530696
Tender Notice
BOQ
Expired
Rangareddy
Telangana
Construction Of Cc Walls And Strengthening Of Slopes With Stone Pitching From A2 To P7 Piers Of Cable Stayed Bridge In Ambedkar University Area Backside Of Amar Society Houses.
Supplying of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorising glass beads @ 250gms with Reflectorising Glass Beads on Bituminous Surface at 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per MORTH Section 803.4 and IRC: 35-2015, the material should satisfy the requirements as per MORTH specifications 803.4 and must comply with the following: a) White index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department).
2
Road markings
APSS
5.00
Nos
23875.00
119375.00
Providing and fixing Junction boards of size 1500x1050mm made out of TYPE XI of ASTMD 4956-09
3
Road markings
APSS
500.00
Nos
316.00
158000.00
Supplying & Fixing Raised Pavement Markers (Road Studs) with Twin Moulded Shanks : Supplying & Fixing of Molded Shanks Raised Pavement Markers made of plastic body moulded from HIPS(HI Impact Polysterene) or ABS or ASA ( Acrylic Strene Acrylonitrite and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face and shall support a load of 13635 kg tested in accordance to ASTM D 4280 Type H and complying to Specifications of Category A of MORTH Circular No RW/NH/33023/10-97 ? DO III Dt 11.06. 1997. The height and width shall not exceed 20 mm and 130 mm with minimum reflective area of 13 Sqcm on each side and the slope to the base shall be 35 +/- 5 degree. The strength of detachment of the integrated cylindrical shanks, (of diameter not less than 19 +/- 2 mm and height not less than 30+/- 2 mm) from the body is to be a minimum value of 700 Kgs. Fixing will be by drilling holes on the road for the twin shanks to go inside, without nails and using epoxy resin based adhesive as per manufacturer?s recommendation and complete as directed by the engineer.
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
