| 1 | 1 | 1. COLLECTING SUMP \nA-1 Designing, Constructing, commissioning and testing of Collecting sump of suitable dia complete as per specifications of DNIT including Sluice valves, NRV, Dismantling Joints, Specials upto common header of Rising Main, 2 Nos. Non clog sewage submersible pumps of 350 m3/hr (6000 LPM)@ 12 MWC for pumping of sewage into receiving chamber complete in all respects.\nA-1 (a) Complete Civil Works \nA-1 (b) Complete Mechanical Works \nA-1 (c) Complete Electrical Works \nA-1 (d) Piping and Valves \n Sub Total \n 2. MAIN PUMPING STATION UNIT\nA-2 Designing, Constructing, Erecting, Commissioning, Testing, Trial Run of 22.50 MLD capacity Main Pumping Station at Village Vaidwala Distt. Sirsa (Haryana) complete in all respects consisting of following units:\n Receiving Chamber, Coarse Screen channel, Coarse screen Mechanical with Flat Belt Conveyer, Wet well cum Pump House with Sluice valves, NRV, Dismantling Joints, Specials upto common header of Rising Main, Electric Hoist with Electric Trolley, 2 Ton, 12 m lift Chain, 6 Nos. (5W+1SB) Non clog sewage submersible Raw Water Transfer Pumps of (2 No. (1W+1SB) of 975m3/hr (16250 LPM@ 12 MWC, 2 Nos. of 325 m3/hr (5500 LPM@ 12 MWC) and 2 Nos. of 162.50 m3/hr (2750 LPM@ 12 MWC) and all other works contingent thereto for completion of project. \nA-2 (a) Complete Civil Works \nA-2 (b) Complete Mechanical Works \nA-2 (c) Complete Electrical Works \nA-2 (d) Piping and Valves \n Sub Total A-1 (a) to A-1 (c)\n \n3. SEWAGE TREATMENT PLANT UNITS\nA-3 Designing, Constructing, Erecting, Commissioning, Testing and Trial Run of 7.50 MLD capacity Sewage Treatment Plant sequential batch reactor complete in all respects consisting of following units: \nStilling Chamber, Fine Screen Channels, Fine Screens Mechanical, Grit chamber : Mechanical, SBR Basins, Chlorine Contact Tank, Chlorinators, Sludge wasting, Automation, Activated Sludge Pumps, Sludge Sump, Excess Activated Sludge Pumps, Sludge storage sump, Screw Pumps, Biological Sludge Sump, Biological Sludge Centrifuge and Centrifuge Feed Pumps, Polyelectrolyte Dosing Pumps with motors for Biological Sludge Dewatering, Agitators for Polyelectrolyte Dosing Tanks for Biological Sludge, Agitators for Polyelectrolyte Dosing Tanks etc. and 3 MT, 6 m lift Chain Electric Hoist with Electric Trolley and Solar Power Lighting System in the premises of the STP location. (For 12 No. LED lights of 12 volts) and Installation of 12 No. poles with accessories for fixing of 12 No. LED Lights complete in all scope as per DNIT specifications. \nA-3 (a) Complete Civil Work :- \nA-3 (b) Decanter, Core parts including geared drives, VFDs, Lifting Mechanical etc. Diffusers, Air Grid Pipe work for Diffusers, PLC Programming and SCADA and OUR Control, PC, Software etc.\n \nA-3 (c) Complete Mechanical Work (including SBR Blowers, Electric Hoist with trolley, RAS Pumps with motors, SAS Pumps with motors, VFD etc. Diffusers, Air Grid Pipes, PLC Programming & SCADA, OUR Control, PC, Software etc. etc. complete in all respects).:- \nA-3 (d) Complete Electrical & Instrumentation Work ( including 2 Pole structure for incoming HT Power Supply, Metering Cubicle, 11 KV HT Breaker Panel: 1 Incoming, HT Cable : 11 KV Grade, 3 Core x 180 mm SQXLPE PVC insulated All conductor, HT Cable: Termination Kit, PCC with APFC & Capacitors, MCC-1, Lighting Distribution Boards & Miscellaneous Panels, PLC Panel Balance of Plant, PC with Printer, Desk and 2 KVA UPS, Field Instruments, LT & Instrument Cables, Cable Trays & Supports, Earthing, Safety Equipments, Internal & External Lighting, Electrical Hardware (Cable Glands, Cable Lugs, fasteners etc. complete, Harmonic Filter, Solar Power, Lighting System in the premises of STP location. (For 12 No. LED Lights of 12 Volts), Installation of 12 No. Poles with accessories completed all respects for fixing of 12 No. LED Lights.\nA-3 (e) Piping & Valves ( DI K-9 pipe varying from 80 mm – 500 mm, MS pipe, RCC pipe, S/S pipe, Ball valves, Butterfully valves, Check valves, Knife Gate valves, Sluice Gates Manual / Motorized of different sizes for completion and commissioning of complete plant as per approved Design and drawings to the satisfaction of the Engineer in Charge.\n Sub Total A-2 (a) to A-2 (d)\n \nA-4 Designing, Constructing, Erecting, Commissioning, Testing and trial run of complete 2.25 MLD capacity Tertiary Treatment Plant comprising of Dual Media Deep Filter Beds along with filter gallery & operational building, Air Scour Blowers, Filter Feed Tank & Filter Feed pumps, Backwash water transfer pumps, Backwash Overhead tanks, Gas chlorination system including Vaccum Chlorinators, Booster pumps, Interconnecting piping, Leak Detector, Residual chlorine Analyzer, Leak Absorption system, Safety equipments & other accessories, Plant Drainage Pumps, 3 Nos. Treated Effluent Transfer pumps of 350 m3/ hr@8MWC, Laboratory Equipment and Chain Electric Host with Electric Trolley of 3 Ton, 6 m Lift etc. complete in all respects as per DNIT specifications.\nA-4 (a) Complete Civil Work :-\nA-4 (b) Complete Mechanical Work:- \nA-4 (c) Complete Electrical Work:- \nA-4 (d) Complete Instrumentation Work:- \nA-4 (e) Piping & Valves \n Sub Total A-3 (a) to A-3 (d)\n \nA-5 Design and construction of Internal Road @3.75 M wide including earthfilling as per DNIT specification and paved area as per DNIT specifications. \nA-5 (a) Internal Roads \nA-5 (b) Paved Area \n Sub Total A-4 (a) to A-4 (b)\n \nA-6 Construction of 1 No. Staff Quarter of 41 M^2 Each as per DNIT specification.\n Sub total A-5\n \nA-7 TRANSFORMER, DG SET & FENCED ENCLOSURE INCLUDING BLOWER\nA-7 (a) Design, Supply & Erection of 1 No. 400 KVA Transformer of 11/0.443 KVA rating, outdoor type, 11KVA VCB, Geo switch, HT Metering Panel, APFC Panel, capacitors, battery chargers, 11 KVA substation, entire cable work & further distribution upto main LT Panel, earthing, safety equipments & any other work contingent thereto complete in all respects as per DNIT. \nA-7 (b) Design, Supply & Erection of 400 KVA DG set with acoustic of KV rating with change over switch & complete as per specifications as described in the approved DNIT. \nA-7 (c) Design, Construction & Erection of suitable sized platform, including drains etc. and fencing of the same for installation of outdoor transformer, DG set and Air Blowers complete in all respects as per specifications. \nA-7 (d) Construction of HT Sub station, Blower cum PMCC Room, Chlorination Room, Biological Sludge Pump House, Biological Sludge Dewatering Unit Building, Filter Annexe Building, Security Building and Administration Building consisting of Control Room, Laboratory / Office / Work shop etc, Toilet, Lobby, including all Sanitary fittings etc. as per drawings at MPS & STP site covered area with RCC framed structure of brick work vitrified glazed tiles flooring, powder coated aluminum frame of size 100mm x 45mm of 10 gauge for chowkhat, 75mm x 45mm of 10 gauge for door frame, 45mm x 45mm of 10 gauge for window frame with 5mm thick glass AIS/Saint Gobain/ Modi Float. including Operation & Maintenance for 12 months during defect liability period after trail run of 3 months and five years thereafter. (Covered area = 1000 Sqm)\n Sub Total A-6 (a) to A-6 (d)\n \nA-8 Horticulture and Development of MPS & STP site complete in all respects as per satisfaction of the Engineer in Charge.\n Sub Total \n\n \nA-9 OPERATION & MAINTENANCE\n The rate to be quoted shall include Operation & Maintenance of all STP units as illustrated in the scope of work\n a) For one year defect liability period immediately after expiry of three months trial period including operation & maintenance. (Free of Cost)\n | BI01010001010000000000000515BI0100001112 | 1 | Lump sum amount payable for the complete work |
|---|
