| 1 | 2 | Supply and fixing of SS 304 manual screens of size 600mm x450mm with 20mm opening Center to Center and size of each bar 10mm x 20mm thick including cost of fitting complete | | 1 | No |
|---|
| 2 | 3 | Providing & installation of 2 Nos. Non Clog sewerage Submerssible pumping sets complete as given below at PS Supplying of Non Clog sewerage submerssible pumps.Model JSE-6, single stage, side delivery volume casing type, Pump efficiency BKW, Motror efficiency , rating 25.00/18.6/1450 RPM, \"f\" CLASS , Air fiill, ball bearing with 40000 Hrs life,Grease lubricated,solid Handling , Pump delivery size 150-250 mm,Type of motor TEWC, pump casing C.I.F.G.260, Implar 3-3-16, S.S- 410 shaft,SS-316, 415 Volts, 50 Hr, A.C. suppply, Star Delta, Thrmister & moisture sencer,IP-68/DUTY:81, Cable 10 m of required size, Auto coupling with intergal C.I.bend & ss Hardware-1 set, 50mm Galvanised guide pipe, M.S.Galvanised lifting chain with shackle 15 mtr length complete as per IS specification.( Non Clog Submersible sewage pumps of 101 m3/Hr (DWF) with Head 15 Mtr. all other accessories complete in all respects.1650 LPM)101 m3/hr 15 m Head | | 2 | Each |
|---|
| 3 | 4 | Supplying and fixing following DI/C.I. D/F pipe, CI specials, sluice valves with wheel, non return valves with G.M. Flap including cost of jointing materials, excavation, laying refilling including making adequate supports of masonry / concrete / steel for delivery pipe from submersible pump set up to 1.5 meter outside the outer wall of pump chamber as per specification given in Schedule No II.iii) 200 mm i/d D/F Pipes(b) bell mouth) | | 5 | Per Mtr |
|---|
| 4 | 5 | i)a) C.I. D/F Pipes 200 mm i/d | | 2 | Each |
|---|
| 5 | 6 | c) CI D/F bends, reducers, tapers, tees, tail piece, blank flange etc. up to 150 mm i/d and 300 mm i/d(i) The ACB, MCCB, contractors, ammeter etc. shall be of suitable rating as per the load requirement .All the power connections should be with solid copper bus bar of suitable rating.) | | 100 | Kg |
|---|
| 6 | 7 | Providing, and fixing of insulated rubber matting suitable for 11 KV installation 1 metre x 2 metre x 12 mm for site as per specifications . | | 3 | Each |
|---|
| 7 | 8 | Providing and fixing of exhaust fans each having a capacity of 45 cubic metres per minutes complete with suitable GI sheet ducting in pump chamber. | | 1 | Each |
|---|
| 8 | 9 | Providing and fixing of ceiling fans 48” i/d (1200 mm) with suitable GI pipe complete in all respects. | | 1 | Each |
|---|
| 9 | 10 | Supply, erection, testing and commissioning of LT panel with copper bus bar and solid connection of suitable rating consisting of 1 No. incoming MCCB required KVA Micro processor MCCB breaking capacity with having adjustable over load with time delay relay and adjustable short circuit with time delay relay with compete metering (Amp. Meter with CT, ASS, VSS and Phase indicating control fuses 3 Nos. fully automatic factory manufactured outgoing star delta starter suitable of having following accessories of suitable rating for respective motors. MCCB Amp. – 1 No.,Contractor of AMP (AC – 3 duty) – 2 No.,Electronic Motor protection relay with display,Protection:-,over current, under current,phase loss imbalance of reversal,Lock Rottor,Timer Electronic 0.60 second – 1 No.,Single phase preventor – 415 voltage AC -1 No.1,Push button = 2 No.,Amp. Meter = 1 No.,CTS 1000 / 5 Amp. = 2 Nos.,Amp. Selector switch = 1 No.,Control fuse – 2 No. | | 1 | Each |
|---|
| 10 | 11 | Supply erection testing of light fitting including wire in the pump chamber with material upto 5 points including switch, button, plug, PVC conduct pipe & copper wire etc. as per approved specifications. | | 1 | Each Job |
|---|
