Electronic Components And Supplies, Discrete Components, Static Converters, Electrical Industry, Electric Panel, Electrical Panel, Switches and Relay, Rotary Switches, Switch Supply

Sharing tender

Supply Of Detailed Technical Specifications · Jtag Download Via Mch Through Ethernet · Jtag Programming Connector At Front Panel · Automatic Arbitration Between Jtag Masters · Target Selection Through Jtag Information · Overrule Of Automatic Operation And Dedicated Selection Of Jtag Target By Front Panel Elements · Multiple Jsm Pinout Configurations Via Fpga Physical Dimemsions · Single-Width Annual Maintenance Contract Module: Width 73.5 Mm ( 2.89 In ) , Depth: 180.6 Mm ( 7.11 In ) Subsystem Processor · Altera Cyclone® Iii Fpga Interface: Backplane · Tcp / Ip: Protocol As Used By The Xilinx Vivado Or Ise Design Suites Supports The Xvc Protocol, Which Allows Jtag Commands To Pass Over Ip To An Embedded System So That A Target Xilinx Fpga Can Be Programmed And / Or Debugged. The Nat-Mch Parses The Ip Packets With A Tcp / Ip Connection And Converts The Packets Into Jtag Commands. After The Packets Are Processed, The Nat-Mch Communicates With The Nat-Jsm Over An Internal Protocol. The Nat-Jsm Switches The Connection To The Target Device And Provides Logical Connection Between The Xvc Server And The Target Fpga. Interfaces: Front Panel · Jtag Header: The Nat-Jsm Provides A Xilinx Compatible 14-Pin Programming Header On The Front Panel. With A Standard Xilinx Programming Adapter, You Can Program Or Debug The Resources In A Mtca System. The Interface Has Been Tested Successfully With The Xilinx Platform Cable Usb Ii. You Select The Programming Target Using The Rotary Switch On The Front Panel Or Through The Web Interface Of The Nat-Mch. · Mini Usb: A Mini Usb Connector On The Front Panel Provides A Direct Connection To The On-Board Usb-To-Jtag Bridge For Common Programming Adapters From Various Vendors. To Use This Programming Interface, The Software Driver Of The Respective Tool Should Support Programming Interfaces Based On The Ftdi Ft2232 Usb-To-Jtag Chip. The Interface Has Been Tested Successfully With Lattice Diamond Programmer 3.0. You Select The Programming Target Using The Rotary Switch On The Front Panel Or Through The Web Interface Of The Nat-Mch. Environmental Conditions · Temperature ( Operating ) : 0ºc To +50ºc With Forced Air Cooling · Temperature ( Storage ) :-40ºc To +85ºc · Relative Humidity:10Perc. To 90Perc. At +55ºc ( Non-Condensing ) Power Consumption Power Is To Be Supplied Through The Backplane Connector, The Onboard Power Converter Has A Range From