Tenders Are Invited For Comminutors - Delivery Of A Chopper For Waste For The Municipal Zakład Komunalny Sp.Z O.O. In Leżajsk

Comminutors - Delivery Of A Chopper For Waste For The Municipal Zakład Komunalny Sp.Z O.O. In Leżajsk. The Subject Of The Order Is The Delivery Of A Slow -Speed Mobile Chopper For The Miejski Zakład Komunalny Sp. Z O.O. In Leżajsk (Later Also Called Machine Or Device Or Shredder). Description Of The Required Minimum Technical And Utility Parameters. General Requirements: • Factory New, Unused, Produced Not Earlier Than In 2025; • Required Nominal Efficiency 45 T/H (Parameter Tolerance ± 15%) With A Rough Fraction (Fraction Content Below 250 Mm Must Constitute At Least 80% Of The Crushed Material) Of Green Waste (Mainly Branches) For An Average Sore Density Of 600 Kg/M3; Transport Dimensions: - Length Max. 9 120 Mm - Width Max. 2 550 Mm - Height Max. 3 360 Mm Equipped With Two Crushing Embankments And At Least One Grinding Comb; The Height Of The Reservoir Of The Reservoir Max 3 500 Mm; Loading Width Min. 3,000 Mm; The Crushing Chamber Equipped With Walls Increasing Its Volume, Folding And Hydraulic Folding; The Machine Must Ensure The Possibility Of Rough And Accurate Crushing Through The Possibility Of Additional Sieves Easily And Quickly Assembled, Equipped With The Following Classification Sieves: 150 Mm Round Eyes, 100 Mm Round Eyes, 80 Mm Round Eyes; • Control Desktop, Enabling Control With The Meter Function Of Overworked, Along With A Remote Control Equipped With An Emergency Switch; • A Device Adapted To Travel On Public Roads, Made As A Trailer With A D50 Mm Eyelets, Equipped With Abs, Permissible Total Mass Max. 30 Mg; A Set Of Indicators Containing At Least Indicators: Fuel Condition, Number Of Hours Worked From The Beginning Of Operation, The Number Of Hours Worked Per Day, The Speed Of The Shaft, Selected Work Program, Information On Errors And Defects; Drive: Diesel Engine With A Power Of Min. 250 Kw, Meeting The Eu Stage V Or Equivalent Flue Gas Purity Standards; Radiator Fan With Temporary Programming Change Of Rotation Direction; Direct Access To The Radiator / Radiator Cleaning; Drive Assembly Built In A Way That Allows Free Access To Service Points; Device Equipped With A Security System That Causes Exclusion At Its High Load; Machine Equipped With Emergency Switches At Dangerous Points; Wireless Shredder Control System From The Charger Cabin Of The Loading Material, Min. 16-Channel; Protection Against Starting Unauthorized Persons For Service; Internal And Outer Metolic Surfaces, Closed Surfaces Made With Anti -Corrosive Protection And Painting Coatings; Grinding System: • Shaft And The Entire Strengthening System With Increased Material Strength, Shaft Length Min. 2 700 Mm, Shaft Diameter Min. 600 Mm, Rotational Speed Smoothly In The Range Up To 30 Rpm. /Min; Shaft Equipped With An Automatic Reverse System - Also During Load Work