Support Support - Supports Should Be In 3.50 M (Three Meters And Fifty Centimeters) In Length, No Amendments, 2 1/2 (Two Inch) External Diameter And Wall With A Minimum Thickness Of 3, 00 Mm (Three Millimeters). The Base Should Be Pressed With A Machine Or Contain Anti -Turning Finally Opposite Fins Of 6 Cm X 6 Cm (36 Cm2) With A Minimum Thickness Of 2 Mm (The Sheet Of The Fins) Welded To The Post At 20 Cm (Twenty Centimeters) From The Base. The Top Of The Tube Should Be Prohibited With Welded Lid To Avoid Water Infiltration. The Whole Set Should Be Galvanized To Fire, Internally And Externally, Regulatory Plaques (Octagonal Format) - The Plates Should Be 16 Msg, Cold Laminate Steel, Decapped, Phosphate, With Anti -Ruginous Treatment And Finish With Black Electrostatic Painting On Both Sides Of The Plate. In The Letters, Waterfront And Bottom Of Regulatory Plates, Prismatic Reflective Film - Type I, Abnt: Nbr 14 644. The Plates Should Have 04 (Four) Holes In The 1/4 Diameter, Next To The Edges, Being 02 (Two) In The Vertical Axis And 02 (Two) In The Horizontal Axis, And The Centers Of The Holes Should Distance 22, 5 Cm From The Center Of The Regulatory Plate. Forms And Colors The Plates Must Obey The Octagonal Format, 60 Cm Of Inscribed Inner Circle Diameter, Side Of 25 Cm, And The Technical Patterns Described In Volume I Of The Vertical Regulation Signs, The Brazilian Traffic Signaling Manual, Regulatory Plates (Circular Format) - The Plates Should Be 16 Msg, With Anti -Ruginous Treatment And Finishing With Electrostatic Painting On Black Color On Both Sides Of The Plate. In The Stripe, Type I Prismatic Reflective Film, Abnt: Nbr 14 644) Reflective Films Should Be Used. In The Symbols And Letters Of The Plates Should Be Used Black Film, Type Iv, And The Hole Centers Should Distance 22, 5 Cm From The Center Of The Regulatory Plate. - Forms And Colors The Plates Will Be Made Following (Dimensions Of 0, 60 M) And In Accordance With The Technical Standards Described In Volume I Of The Vertical Regulation Signaling, Warning Plates - The Plates Should Be 16 Msg, With Anti -Ruginous Treatment And Finish, With Black Electrostatic Painting On The Two Faces Of The Plate. In The Outer Edge And At The Bottom Of The Warning Plates, Prismatic Reflective Film, Type I, Abnt: Nbr 14 644. Symbols, Numbers, Internal Waterfront And Warning Subtitles Of Warning Plates Shall Use Black Film, Abnt: Nbr 14 644). The Plates Should Have 04 (Four) Holes In The 1/4, 5 Cm Diameter From The Center Of The Warning Plate. - Form And Colors Warning Plates In The Dimensions (0, 60 X 0, 60 M) Should Obey The Technical Standards Described In Volume Ii Of The Vertical Warning Signaling, Indicative Plates - The Plates Should Be 16 Msg, With Black Electrostatic Painting On The Two Faces Of The Plate. On The Outer Edge And At The Bottom Of The Indicative Plates Should Be Used Prismatic Reflective Film, 5 Cm From The Center Of The Indicative Plate.