Short Sleeve School T -Shirt - Short Sleeve T -Shirt N. 1, 2, 4, 6, 8, 10, 12, 14, P, M, G, Gg. (Can Be Among Them Special Sizes) Short -Sleeved T -Shirt, Made Of Half -Mesh -Mesh, With The Composition Of 50% Polyester + 50% Cotton, With A Minimum Weight Of 150Gr/M², In White. The Sleeves Should Be Straight Sermodels, And The Collar Should Be Unique, Round In A Bald Collar Model. In The Neckline Of The Collar, And In The Shirts Of The Shirts, Should Be Applied Fist, Produced And Made In Rectilinear Machine, In Ribanacanelde 1 X 1, With The Composition Of 100% Polyester, With The Weight Of 200Gr/M², In Green Color, Near Pantone 19-1764 Tc, With The Measurements For The Neckline Of The Collar In 3Cm (Finished) Wide, And To The Dasmangas Fists At 2, 0 Cm Of Finished Width. Waist Bars Should Be Served With A Width Of 2, 0 Cm And Sewn On A Rooster Machine Of Duasagules. It Should Be Sewn Internally With An Overlock Machine. In The Inner Part Of The Green Collar, A Yellow Bias Of The Same T -Shirt Should Be Applied. In The Middle Of The Inner Back Of The Collar, A White Tissue Label Should Be Beaten With Black Indication Features, And Should Be Uniform And Inform Social Skill, Cnpj, Fabric Composition, Washing Symbols, Size, Year And Country Of Manufacture. The Tolerance Of Variation In The Weight May Be 5%; And In Measurements Up To 1, 0 Cm. The Line Used For Making Is100% Polyester N. 120. All Parts Should Be Packed Separately In Transparent Plastic Bags. The Piece Must Be Free From Any Defect That Compromises Its Presentation., School Uniform -2 Uniform Kit - Female Uniform Set Containing: 1 Short -Sleeved T -Shirt, 1Shortsaia Helanca And 1 Long -Sleeved Jacket, 01 To 14, Lot -3 School Uniform Kit - Set Of 6. 1 Unisex Pants, Nostasx: 12, G., Lot -4 School Uniform Kit - Uniformary Set For Students (Eja) Containing: 1 Mangacurta T -Shirt, In Sizes: 12, Gg, Shoelaces Sneakers - Tennis Should Be Made In Dubbed Canvas, With Collar Edge Finishing, Container Views, And The Tongue. (Tongue) Are Unique Stroke To Pale Height. The Assembly Process Should Be With Bagged Insole, (Strobel). The Sole Will Be Made Through The Autoclave Vulcanization Process. The Toe, Tip, The Side Band And The Sole (Bass Plant) Should Be Of A Vulcanized Rubber -Based Composition. Also For A Better Edesign Chim, Heights Must Be Respected At Interference Points, Following The Scale Of The French Point For Other Numbers, The Height Of The Height Of The 35 Size 35 With 80 Mm (± 2Mm) And The 95 Mm (± 2 Mm) Eyelet View. These Two Measurements Will Be Verified At The Highest Point, Considering The Outside Of The Footwear To Aquina Of The Sole (As Guided In The Figure Below)., 06/27/2025
