Tenders Are Invited For Hardening With Road Plates Three Sections Of Municipal And Internal Roads In The Commune Of Szczaniec.

The Subject Of The Contract Is Hardening With Road Plates Three Sections Of Internal Municipal Roads In The Szczaniec Commune (Described In Annex 1 To Swz), Under 3 Nw. Tasks: Task 1- Hardening Of The Road In Szczaniec On Journal Of Laws No. 352 On A Section Of 255.00 M 20Cm, C) Driving Profiling (Transverse Declines) D) Road Panels With A Thickness Of 16 Cm In Two Lanes, E) Oxidal Surface 0/31.5Mm (Roadside) Between Plates And On The Sides Of The Plates -Strip Of Belt 3.5M, Roadside 0.5 M. Nourse: The Road Profile Should Be Adapted To The Ordinance Of The Existing Thermal Thermal Harness To An Average Of About 10-15 Cm Higher. Place The Axis Of The Road Into The Road Lane, Fit The Plate Arrangement In The Line Of Neighboring Plots. 8 Cm,- 25 Cm,- Circuit- Concrete Resistor 30X15cm On A Concrete Bench With C12/15 Resistance,- Crosy Side Of The Gr. 10 Cm, Died With Basalt Grits 50Cm Wide, Road Cross-Section In Accordance With The Fig. 20Cm, C) Execution Of Road Profiling (Transverse Declines) D) Laying Of Road Plates In Two Lanes, E) 0/31.5Mm Piercing Surface (Roadside 0.5 M) Between The Plates And The Sides Of The Plates -The Strip Of Belt 3.5M, Note: The Road Profile Should Be Adjusted To The Ordinances Of The Existing Thermal Terrible To An Average Of About 10-15 Cm Above. Place The Axis Of The Road Into The Road Lane. Place The Panels Of The Plates In The Neighboring Plot Of The Road. Crack Of The Road In Accordance With The Fig 20Cm, C) Driving Profiling (Transverse Declines) D) Road Plates In Two Lanes, E) 0/31.5Mm Piercing Surface (Roadside 0.5 M) Between Plates And On The Sides Of The Plates - Belt Width 3.5M, In The Light Of The Congress, Make The Space Between The Plate With Plates Or Concrete Cobblestones. Tie To The Existing Surface, And The Route Of The Plates Fits The Axial In The Line Of Neighboring Plots (In Accordance With Fig. 1C To Swz). Road In Accordance With Fig. - Annex 1C To Swz.3. A Detailed Description Of The Subject Of The Contract Is Specified In: A) Design Documentation Constituting Annex 1, 1A, 1B And 1C To Swz;