Tenders Are Invited For Delivery And Assembly Along With The Training Of The 80 Kva Power Generator Related To The Implementation Of The Project As Part Of The Cyber-Safed Self-Government Szamocin Grant

Part No. 1: Construction Works - Preparation Of The Area Under The Aggregate Is Construction Works Involving The Preparation Of The Area For The Aggregate Along With The Cabling Connecting The Aggregate With The Umig Building. The Agreet Will Be Located At The Building Of The City And Commune Office Of Szamocin In The Western Facade. For The Assembly Of The Aggregate, The Layer Should Be Collected Humus And Make A Trench For A Foundation Plate Aggregate. The Plate Measuring 5.0 M X 3.5 M. After The Perimeter Of The Plate, Arrange The Resistor 8X30x100-17 M. Then Make A Concrete Foundation From A Broken Fraction 0-31.5 Mm With 15 Cm. A Layer Of Lean Concrete With A Thickness Of 12 Cm Thick Will Be Laid On The Aggregate. Make The Surfaces With A Concrete Cube With A 8 Cm Thick Brick (Gray) On Cement-Sand Bed. A Panel Mesh (Minimum Thickness Of 4 Mm) With A Height Of 150 Cm Should Be Made Around The Foundation Slab. Mount The Panels To The 40X60 X2 Posts In A Spacing Of 2.5 M Stated Without A System Foundation. In The Fence, Make A Gate With A Width Of Min. 100 Cm. After Setting The Aggregate, The Power Cable Should Be Made With A Length Of About 50 M. Enter The Cable To The Box, Which Should Be Mounted In The Wall And Entered Into The Existing Connector Located In The Wall Of The Same Facade. When Laying The Power Cable, It Will Be Necessary To Dismantle And Restore The Existing Cube On The Road Foundation Approx. 15 M2.