Bids Are Invited For Acquisition With Protection Installation, Emergency Exit Staircase, Emergency Output Door

Manufacture And Installation Of Staircase Protective Railing Fixesfabrication And Installation Of 2 ”Round Tube Handrail, 110Cm Length, With 90 ° Curve At Both Ends To Be Installed On The Ladder Wall. Railing Height At 90Cm. Painting With Gray Background And Paint. & Manufacture And Installation Of 2 ”Tube Railing, Total Length Of 105Cm With 90 ° Curve At Both Ends, With 2” Tube Fixation Poles With 3/4 Tube ”In The Horizontal Bars Every 15 Cm. Railing Height At 90Cm. Painting With Gray Background And Paint., Manufacture And Installation Of 2 ”2” Tube Railing And Installation Of Handrail, Total Length Of 90 ° Curve At Both Ends, With 3/4 ”Tube In The Horizontal Bars Of 15 In 15 Cm. Railing Height At 90Cm. Painting With Gray-Colored Zarcão And Paint., Supply And Installation Of A Complete Metal Door (Uninfined Installation Of Masonry), 110Cm Wide, With Mark And Opening With Anti Panic Bar (Without Outer Handle) .- The Structure Of Door Should Be 30X30mm Square Steel Pipe, With A Thickness Of 2Mm, With At Least 3 Horizontal Reinforcements, Covered With 1Mm Steel Plate On The Outside.- Singing Of 1 1/2 X 3/16- Structure Should Receive Bright Blue Enamel Painting On Zarcão Background.- Opening Should Be Out (Right) .- The Finish Should Be Free Of Burrs. Service Contemplates The Supply And Fixing Of A Metal Staircase With Railing, As Described Below.- The Ladder Structure Will Consist Of Pillars And Metalon Beams 100X100mm Of 2Mm.- Install At Least One 1, 5 Meter Reinforcement Pillar (It Will Also Serve To Limit Access To The Bottom Of The Stairs)- The Stairs Will Be Fixed By A 3/8 (25X25cm) Plate Screwed At The Existing Foundation/Floor And Beam With 1/2. 2.- The Pillars Will Be Welded. On The Plate.- The Ladder Floors Will Be In Non-Slip Plate 1/8. It Does Not Need Mirror.- The Railing Will Be In A 30X30mm Tube Of 1, 5Mm With 110Cm High On The Side Where There Is No Wall, And At The Top Of The Wall (Where There Is A Risk Of Falling), Which Should Be Closed With A 2 ”Wire 12 Galvanized (Otis) Wire, To Every Extent When There Is A Risk Of Falling. A Height Of 90Cm. The Handrails Will Be Made According To The Rs Fire Department Standard. They Should Be Installed To Allow The Continuous Slip Of The Hands Along The Length And At Least 40 Mm From The Bodies To Which They Are Fixed Are Removed.- The Stairs Must Be Of A Non-Slip Metal Plate Of At Least 3Mm, 3Mm, With Folded Edges To Increase Resistance. They Should Have A Default Depth And Height, According To Rs Fire Department Standard (18Cm Height And 28Cm Deep)- At The End Of The Stairs, A 100Cm Wide Gate Should Be Installed, Built With A 30X30mm Tube 1, 5Mm With Bar Antipanic (Right Opening) For Emergency Exit (Without Outer Handle). The Gate Should Be Height Of At Least 200 Cm. A Metal Plate With At Least 60 Cm Wide Should Be Installed Throughout The Antipanic Bar To Make It Difficult To Operate The Gate ..., Manufacturing And Installation Of Handrail In The Center Part