Bids Are Invited For Acquisition Of A 6M³ Tipper Bucket For Installation On The Iveco Tector 17-280 Truck (4X2), According To Specifications In The Terms Of Reference, Attached To The Notice.

6M³ Multipurpose Dump Bucket, Chassis Built On 8” Wide “U” Folded Profile. A36 – 6.00Mm With Full-Length Back Cover In U-Profile Folded In Sheet Steel At 36 – 6.00Mm Thick. Sub Chassis, Built In “U” Profile Bent Into 6” Space. A36 – 6.00Mm With Articulation Through Bearings And Lubrication Pins, Attachment To The Vehicle Chassis Using Clamps. Telescopic Hydraulic System, Equipped With 01 (One) Cylinder With Direct Low Working Pressure System Complete Set With Gear Pump For Adequate Working Pressure, Driven Through Pneumatic Power Take-Off From Inside The Cabin Of The Tractor Truck. Direct Coupling With 3-Way Safety System According To Resolution 859/2021. Cargo Box, Built With Rounded Corners, Bottom In Steel Plates Astm A 36 Esp. 4.50Mm: Side Plates In Steel Astm A 36 Of Esp. 4.50Mm With Automatic Swing Closing And Manual Gate Type: “U” Beam Reinforcements: Front Cover In Astm A 36 Steel Plates With A Thickness Of 3.00Mm And “U” Beam Reinforcements Of The Same Material. With 45° Tilt Angle. Accessories, Wraparound Fenders Made With Rubber Rear Mudguards, Tool Box, Water Core, Fastening Pin, Front Ladder, Spare Wheel Support, Reflective Strips, Rear Bumper Fixed To The Vehicles Chassis And Approved Side Protectors By Inmetro According To Current Legislation, Signals On Each Side According To Resolution 859/21 – Contran. Finish, Surface Treatment, Anticorrosive Background, Pu Polyurethane Paint In Battalion Standard Color, 01/21/2025