Tenders Are Invited For Construction Of An Exhibition And Administrative Facility Along With Land Development For The Maria Konopnicka Museum, On Plots No. 1297, 1298 Żarnowiec 133, Jedlicze 38-460.

1 The Subject Of The Order Is The Construction Of An Exhibition And Administrative Facility With Land Development For The Maria Konopnicka Museum, On Plots No. 1297, 1298 Żarnowiec 133, Jedlicze 38-460.2 The Order Includes The Following Works: 1) Construction Of An Exhibition And Administration Building With Land Development , Including: - Administration And Exhibition Building; - Road Access To The Building Hardened; - Parking Spaces On The Side Of The District Road; - Exit On The Side Of The Municipal Road Which Also Serves As A Fire Road; - Green Areas, Such As Lawns And, Optionally, Low Ornamental Shrubs. Rainwater Filtering Strips Are Designed Around The Exhibition And Administrative Building. As Part Of The Order, The Contractor Will Design And Build A Fire Protection Tank. On Plot No. 1297, 1298, An Underground Fire Tank With A Capacity Of Up To 300 M3 Equipped With 2 Hydrants Will Be Located. Technical Connections: The Contractor Will Connect The Designed Building To The Municipal Sewage, Energy And Telecommunications Networks (The Contractor Will Be Obliged To Make External Sections Of The Buildings Internal Installations) Domestic Water Needs. The Contractor Will Construct A Deep Well. 2) Construction Of A Renewable Energy Installation (Photovoltaic Installation, Heat Pumps)1. Photovoltaic Installationthe Operation Of A Photovoltaic System Is Based On The Production Of Electricity From Photovoltaic Generators In The Form Of Direct Current, And Then Converted Into Alternating Current With A Voltage Of 230V By A 3-F 15-20 Kw Inverter. 54 Photovoltaic Modules Were Designed With A Total Power Of At Least 20 Kwp. The Modules Will Be Installed On The Roof Of The Building, From The East-West Side. The Roof Slopes Are Inclined At An Angle Of 35 Degrees. A Supporting Structure Dedicated To Roofs Covered With Sheet Metal Should Be Used. Module Parameters: • Minimum Power Pmax: 350 Wp • Cell Type: Polycrystalline Si • Voltage Approx. 38V • Dimensions Approx. 165Cm X 99Cm • Efficiency: Min. 15.40 %• Weight Approx. 20 Kg• Mc4 Cabling Mounting• Ip65 Protection System• Protection Class Ii Class• Operating Temperature -40 To +85°C• Maximum System Voltage: 1000 V Dc2. Heat Pumpthe Heat Source For The Surface Heating Installation And For Domestic Hot Water Purposes Will Be An Air-Water Heat Pump. A Cascade Is Designed With At Least Two Pumps With A Total Nominal Capacity Of Not Less Than 70 Kw. The Indoor Units Will Be Located In The Basement In The Technical Room - 1.4. The External Units Will Be Located On The Façade Near The F-3 Axis. In The Technical Room There Will Be A Buffer With A Capacity Of 1,000 Liters And A Stainless Steel Hot Water Heater With A Capacity Of 300 Liters.3) Renovation Of The Surface Of The Existing Parking Lot. Renovation Of The Surface Of The Existing Parking Lot With An Area Of ​​391 M2 Consists In Making A Base Of Mechanically Compacted Crushed Aggregate With An Average Thickness Of 0.15 On The Existing Gravel Base. M, Which