Tenders Are Invited For Screed Works – New Building Sag - Screed Work

Screed Works – New Building Sag - Screed Work. Before The Shell Construction Work Begins, Trees Are Felled On The Building Site As A Preparatory Measure. The Water Pipe That Has Been Taken Out Of Service Will Be Expanded By The Contractor And The Excavated Area Will Be Filled With Load-Bearing Material. The Construction Work Is Accompanied And Documented By A Soil Expert. The Construction Site Is Then Handed Over To The Contractor. As Part Of The Shell Construction Work, Surface Investigations Must Be Carried Out By The Explosive Ordnance Disposal Service In Some Areas Of The Building Site (See Be Plan). These Are Carried Out After The Paving Has Been Demolished Down To The Level Of The Excavation Pit. If Probing Is Not Possible, Excavation Monitoring Must Be Carried Out. If Explosive Devices Are Found During Execution, The Work Must Be Stopped Immediately And The Construction Management Must Be Informed. In The Eastern Area, The Existing Paving For The Construction Site Area And The Entrances/Exits Should Be Retained. Existing Defects (E.G. Tree Locations) Must Be Repaired And Prepared With Gravel Material. After The Construction Site Facilities Are Dismantled, The Existing Paving Will Be Demolished By The Gala Construction. The Shell Construction Starts After The Necessary Work Preparation, Introductions, Creation And Coordination Of Appointments And Construction Site Setup Plans As Well As Measurement Work, Etc. With The Construction Site Setup. The Concreting Sections Can Be Found In The Formwork Plans. Any Deviations From This Must Be Coordinated With The Structural Engineer On His Own Responsibility, Re-Planned And Approved By The Test Engineer. After The Stb Ceiling Has Been Completed On The 2Nd Floor (Elevator Shaft/Technical Rooms), The Steel Structure For The Technical Center Will Be Erected. The Trapezoidal Sheet Metal For The Roof Construction Is Then Laid And The Facade Made Of Sandwich Elements Is Assembled. After Completion Of The Stb Ceiling On The 1St Floor, The Windows / Pr Facades Are Installed In The Order Of The Ground Floor And 1St Floor. The Facing Facade Is Carried Out After The Windows Have Been Installed. The An Shell Construction Closes Larger Roof Openings And The Roof Areas Are Sealed Using An Emergency Seal (Building Rainproof). Immediately Afterwards, The Non-Technical/Technical Expansion Takes Place On The Ground Floor And 1St Floor. The Drywall Walls Are Initially Erected With Stud Frames/One-Sided Planking. After The Installation Work, The Drywall Walls Are Closed And The Interior Plastering Work Is Carried Out On The Stb / Mw Walls. Subsequently, The Screed Work (Including Underfloor Heating) Will Be Carried Out In Sections, Initially On The Ground Floor And 1St Floor. After The Screed Has Been Installed, The Installations In The False Ceiling Area Are Completed And Then The Substructures Of The Suspended Ceilings Are Installed. During The Same Period, Door Frames Must Be Installed And Painting/Tiling Work Must Be Carried Out On The Walls. The Flooring Work And Carpentry Work Will Then Be Carried Out And The Aluminum Frame Doors Will Be Installed