Tenders Are Invited For Implementation Of A Perimeter Security System In The Prison In Siedlce

The Subject Of The Order Is The Delivery, Construction And Commissioning Of A Wired Perimeter Security System In The Siedlce Prison For The Entire Area Of ​​The Unit, Built On The Line Of The Internal Fence. Basic Parameters Of The Internal Fence Line On Which The Perimeter Protection System Will Be Installed, Necessary To Design The Above-Mentioned System: • Total Length Of The Internal Fence Line L = Approx. 476 M (Including Approx. 16 M Of The Penitentiary Pavilion Building)• Height Of The Internal Fence Line With The Concertina Finial H = 4.5 M• Number Of Gates In The Internal Fence Line - 5 Pcs.• Number Of Gates In The Internal Fence Line - 1 Pc. • Distance From The Span To The Span Of The Internal Fence Line - Every 2.5 M. A Detailed Description Of The Subject Of The Order And The Terms Of Execution Of The Order Are Described In Annex No. 9 To Swz - Opz. Recommended Minimum Properties That Should Be Met By A Wired Perimeter Protection System: • System Based On Sensors Installed On The Fence Metal Made Of Razor Wire (Single Sensor Installed On Each Fence Span). Communication Between Sensors Is Based On A Cable (Sensors Connected To Each Other By A Cable On The Fence), Additionally The Cable Is Protected With A Stainless Steel Metal Braid.• Operation Of The Sensors Included In The System In The Temperature Range From -40°C To +70°C.• The System Allows Operation In Loop Structure (Damage Or Cutting Of The Transmission Cable Without Loss Of Information From The Protected Area).• Modular Architecture Allowing For The Construction Of Systems With Unlimited Surface Area.• A System That Allows You To Protect A Fence Up To 1,500 Meters Long With One Controller.• A System That Allows You To Detect An Attempt To Climb The Fence, Cutting The Fence Or Trying To Change The Position Of The Fence.• The System Will Enable Programming Of Each Sensor On The Detection Line (Possibility Of Individual Calibration Of The Sensor By Changing Its Sensitivity Parameters To Adapt To The Installation Conditions For A Given Fence Span).• Possibility To Install A Minimum Of 16 Input/Output Modules On A Single Detection Lines (Expansion With Other Alarm Points In The Future).• The System Should Enable Defining Alarm Zones And Detect And Inform On An Ongoing Basis About Events Involving Violation Of The Protected Zone With Accuracy Down To A Single Sensor.• The System Is Resistant To Phenomena That May Cause False Alarms, Such As Wind , Snowfall, Rain, Hail, Road Or Rail Vehicles Moving In The Vicinity Of The System Installation.• A System That Allows Monitoring Gates And Gates Within The Fence By Using Magnetic Detectors, Motion Detectors, Infrared Barriers Incorporated Into The System.• The System Will Ensure The Use Of Modules Overvoltage In Order To Eliminate Overvoltage Interference.• The System Should Enable The Installation Of At Least 14 Isolators On One Branch Of The System Bus. • The System Must Be Able To Integrate With A Visualization System And A Video Monitor