Tenders Are Invited For Construction Of A Water Supply Network In Ułanowice - Construction Drinking Water Pumping Station

The Designed Drinking Water Pumping Station Together With The Pedn160-125 Water Pipeline With Electrical Installation And Technical Infrastructure Will Ensure The Required Pressure In The Existing Water Supply Network In Ułanowice, Klimontów Commune. The Technical Infrastructure Installed In The Pumping Station Will Enable Monitoring And Measurement Of Water Flow In The Water Supply Network. The Construction Project Is An Underground, Linear Structure That Does Not Require The Design Of A Protection Zone. The Construction Project Is Intended To Ensure The Supply Of Water In Quantities Resulting From The Current And Planned Demand For Water At Appropriate Pressure. The Water Will Be Used For Municipal And Domestic Purposes. In Ułanowice, A Drive-Up Drinking Water Pumping Station Was Designed, Equipped With An Internal Power Supply, With A Control Cabinet And Ventilation Ducts Extended Outside The Chamber. The Control Cabinet Is Equipped With A System Managing The Operation Of The Pumping Station. After Building The Pumping Station, Restore The Area To Its Original Condition. The Pumping Station Will Be Placed On A 20 Cm Thick Aggregate Ballast. The Pumping Station Area Is Illuminated; Therefore, No Additional Lighting Is Planned. Water Supply Lines Will Be Run Below The Ground Frost Zone At A Depth Of At Least 1.2 M Below Ground Level. The Route Of The Planned Water Pipeline Was Designed Along The Municipal Road And At The Border Of Private Plots. The Water Supply Located In The Road Was Designed From Pe 100 Sdr 11 Rc. Shut-Off Valves Were Used When Turning On And Introducing The Planned Water Pipeline From The Existing Water Supply. The Scope Of The Study Includes The Construction Of:  Pe Rc Dn 125 Pressure Water Pipeline With A Length Of 29.80 M On The Wł1-Pp Section (According To Drawing S3)  Pe Rc Dn 160 Suction Water Pipeline With A Length Of 23 M On The Wł0-Pp Section (According To Drawing S3)  Drinking Water Pumping Station With Ventilation (According To Fig. Z1)  Internal Power Supply (According To The Electrical Industry)  Pressure Reducers Inside Existing Buildings On The Water Supply System And A Network Pressure Reducer (According To Fig. T1).  Check Valves In Existing Water Supply Nodes (According To Fig. T1).