Request For Quotation Control Unit Of Vacuum Switches For Relay Protection Of Ru-6 Kv

The Control Device Is Designed For Effective Control (Activation And Deactivation) Of Ism15_Ld Switch Blocks. Its Purpose Includes The Use In Power Cabinets Of Devices Of A Complete Distribution Network Of Internal And External Installation (Kru, Krun), As Well As In One-Way Maintenance Rooms Of Voltage (6-10) Kv Networks. The Control Device Provides: - The Usual Control Cycle Of The Switch Unit: О - 0.3 S - Оо - 15 S - Оо; - Prevention Of Re-Activation When The Command Remains Active After Automatic Shutdown Of The Switch Block; - Disconnection From Current Circuits In The Absence Of Supply Voltage. The Design Of The Control Device Is Made In A Hermetic Housing Made Of Plastic. All Elements Of The Electrical Circuit Are Installed On A Compact Board. The Card Is Securely Fixed Inside The Housing Of The Control Device. On The Side Of The Case There Is A Wago Connector For Connecting The Control Device. There Is Also A Fuse Holder And An Indicator That Signals Overheating Of The Fuse (Vp). When Using The Control Device Together With The Power Supply Unit, It Is Possible To Use Additional Devices: Bav/Tel-220-02 Autonomous Switching Unit. Signal Branching Boards. Dimensions Dimensions Wxhxd, Mm 192X120x61 Weight, Not Less Than 2 Kg, The Control Unit Is Designed To Control Vacuum Switches Ism15_Ld_1. The Control Units Allow You To Set The Control Modes Of The Switch With High Accuracy, Ensuring The Optimal Operating Mode Of The Vacuum Switch. The Control Unit Is Installed On The Pull-Out Elements, Kru And Kso. Functions Of The Control Unit Control Of The Ism15_Ld_1 Module; Prevention Of Erroneous Double Inclusion; Ism15 Chain Health Monitoring; Tracking Of Low-Current Circuit Malfunctions And Internal Errors With Led Malfunction Identification; Turning On The Vacuum Switch From A Third-Party Power Source; Alarm Of Emergency Or Abnormal Shutdown. Operating Conditions: Height Above Sea Level Up To 2000 Meters; Temperature Range -40..+55°С; The Relative Humidity Value Is 100%, The Temperature Is +25°C And 80% At +15°C; Bu/Tel Corresponds To Ip40 Dimensions Dimensions Wxhxd, No Less Than Mm: 205X250x110 Weight, Kg: 0.8, The Control Unit Is Designed To Control (Turn On And Turn Off) Vacuum Switches Of The Bb/Tel-10 Series Tshag 674152.004 Tu. The Control Unit Is Intended For Operation In Relay Cabinets Of Complete Distribution Devices Of Internal And External Installations (Switchboards, Switchboards), As Well As In Chambers Of Collective One-Way Service (Kso) Networks (6-10) Kv. The Control Unit Provides: Standard Vacuum Switch Control Cycle O-0.3 S-Vo-15 S-Vo; Blocking From Re-Activation, When The Activation Command Continues To Be Submitted After Automatic Disconnection Of The Switch; Disconnection From Current Circuits In The Absence Of Supply Voltage. The Design Of The Bu Is Structurally Made In A Closed Plastic Case. All Elements Of The Electrical Circuit Diagram Are Mounted On One Printed Circuit Board. The Board Is Rigidly Fixed Inside The Bu Housing. On The Side Surface Of The Case There Is A Wago Connector For Connecting The Bu. On The Same Surface Above The Connector, A Fuse Holder And A Fuse Burnout Indicator (Vp) Are Installed. Auxiliary Devices When Using A Bu Together With A Power Supply, It Is Possible To Use A Number Of Additional Devices: Block Of Autonomous Switching Bav/Tel-220-02. Signal Propagation Boards.